181 research outputs found
A new XRD method to quantify plate and lath martensites of hardened medium-carbon steel
This paper introduces a new technique to separately measure the volume fraction and tetragonal ratio of co-existing lath and plate martensites in ultrahigh strength steel, and to calculate their different carbon contents. First of all, the two martensites are assumed to have body centre tetragonal lattice structures of different tetragonal ratios. X-ray diffraction is then applied to obtain the overlapping (200) diffraction peak, which is subsequently separated as four sub-peaks using a self-made multiple Gaussian peak-fitting method to allow the measurement of the individual lattice parameters c and a. Finally a modified equation is applied to calculate the carbon contents from the obtained tetragonal ratios. The new technique is then applied to investigate the effect of subsequent tempering on the decarbonisation of the as-quenched martensites.
Keywords: Gaussian peak-fitting, martensite carbon content,
martensite tetragonal ratio, medium-carbon steels, Xray
diffractio
Effect of Grain Boundary Character Distribution on the Impact Toughness of 410NiMo Weld Metal
Grain boundary character distributions in 410NiMo weld metal were studied in the as-welded, first-stage, and second-stage postweld heat treatment (PWHT) conditions, and these were correlated with the Charpy-V impact toughness values of the material. The high impact toughness values in the weld metal in the as-welded and first-stage PWHT conditions compared to that in the second-stage condition are attributed to the higher fraction of low-energy I pound boundaries. A higher volume fraction of retained austenite and coarser martensite after second-stage PWHT accompanied by the formation of the ideal cube component in the 2-hour heat-treated specimen led to a reduction in the toughness value. A subsequent increase in the PWHT duration at 873 K (600 A degrees C) enhanced the formation of {111}aOE (c) 112 >, which impedes the adverse effect of the cubic component, resulting in an increase in the impact toughness. In addition to this, grain refinement during 4-hour PWHT in the second stage also increased the toughness of the weld metal
Specific features of cast high-entropy AlCrFeCoNiCu alloys produced by ultrarapid quenching from the melt
Martensite crystal lattice, mechanism of austenite-martensite transformation and behavior of carbon atoms in martensite
Investigation on the nucleation mechanism of deformation-induced martensite in an austenitic stainless steel under severe plastic deformation
- …