Fast fluctuations of soft X-rays from active regions

A selection of short lived small soft X-ray bursts is studied using data from the Hard X-ray Imaging Spectrometer (HXIS), and the results are compared with the data from the Hard X-Ray Burst Spectrometer (HXRBS) with a view to understanding conditions at the onset of flares. Short-lived events provide an opportunity to study the radiation from the primary energy transfer process without confusion from the slowly-varying thermal X-ray emission which characterizes the decay of a large flare. The fast decay of the soft X-rays, only a few tens of seconds, suggests that they occur in the dense chromosphere. The results indicate that the short events may be signatures of several different phenomena, depending on their characteristics. Some events occur in association with reverse-drift type III bursts and simultaneous flaring elsewhere on the Sun, thus suggesting dumping of particles accelerated at a remote site. Some events have hard X-ray bursts and normal type III bursts associated with them, while others have neither. The latter events place strong constraints on the nonthermal electron population present

Spectral and spatial properties of solar microflares

Solar microflares are studied using both hard ( 28 keV) and soft (3.5 to 8.0 keV) X-ray observations. The soft X-ray events have durations 3 m at 0.1x maximum intensity, and typically have similar rise and decay times. The fastest decay observed was 15 s (1/e). Soft and hard X-ray intensities are uncorrelated. The events are very compact, consistent with a projected area approximately 8 x 8 inches. They are normally not associated with H alpha or type 3 emissions and their time profiles suggest a thermal origin at the top of the chromosphere. If the primary energy release site is in the corona, an energy transfer agent consistent with the observations is a non-thermal proton beam

Rediscovery and status of Cylindera (s. str.) lunalonga (Schaupp, 1884) (Coleoptera: Carabidae: Cicindelinae) in the San Joaquin Valley of California with a comparison to a Sierra Nevada population

Surveys for adult Cylindera (s. str.) lunalonga (Schaupp) (Coleoptera: Carabidae: Cicindelinae) were conducted between 2001 and 2011 at over 80 sites throughout the species’ historic range in the San Joaquin Valley and Sierra Nevada Mountains of California. Previously considered extirpated from the Valley, these surveys resulted in finding adults at 18 sites, several with large populations (>50 individuals). As suggested by historic records, our studies confirmed that the Valley populations of Cy. lunalonga occur in what were historically wetland sites, but are now lowland agricultural croplands. Adults were always associated with wet, muddy soil within and along the edges of irrigation ditches. A comparison of morphology, behavior, habitat, and conservation is made with the only known extant Sierra Nevada population

Abradable compressor and turbine seals, volume 1

The application and advantages of abradable coatings as gas-path seals in a general aviation turbine engine were evaluated for use on the high-pressure compressor, the high-pressure turbine, and the low-pressure turbine shrouds. Topics covered include: (1) the initial selection of candidate materials for interim full-scale engine testing; (2) interim engine testing of the initially selected materials and additional candidate materials; (3) the design of the component required to adapt the hardware to permit full-scale engine testing of the most promising materials; (4) finalization of the fabrication methods used in the manufacture of engine test hardware; and (5) the manufacture of the hardware necessary to support the final full-scale engine tests

BIOMASS FOR ELECTRICITY AND PROCESS HEAT AT ETHANOL PLANTS

Published in: Applied Engineering in Agriculture, Vol. 22(5): 723-728Biomass, Process heat, Ethanol production, Electricity, Combined heat and power, Resource /Energy Economics and Policy,

Abradable compressor and turbine seals, volume 2

The applications and advantages of abradable coatings as gas path seals in a general aviation turbofan engine were investigated. Abradable materials were evaluated for the high pressure radial compressor and the axial high and low pressure turbine shrouds