2 research outputs found
Recommended from our members
Optimization of the lead probe neutron detector.
The lead probe neutron detector was originally designed by Spencer and Jacobs in 1965. The detector is based on lead activation due to the following neutron scattering reactions: {sup 207}Pb(n, n'){sup 207m}Pb and {sup 208}Pb(n, 2n){sup 207m}Pb. Delayed gammas from the metastable state of {sup 207m}Pb are counted using a plastic scintillator. The half-life of {sup 207m}Pb is 0.8 seconds. In the work reported here, MCNP was used to optimize the efficiency of the lead probe by suitably modifying the original geometry. A prototype detector was then built and tested. A 'layer cake' design was investigated in which thin (< 5 mm) layers of lead were sandwiched between thicker ({approx} 1 - 2 cm) layers of scintillator. An optimized 'layer cake' design had Figures of Merit (derived from the code) which were a factor of 3 greater than the original lead probe for DD neutrons, and a factor of 4 greater for DT neutrons, while containing 30% less lead. A smaller scale, 'proof of principle' prototype was built by Bechtel/Nevada to verify the code results. Its response to DD neutrons was measured using the DD dense plasma focus at Texas A&M and it conformed to the predicted performance. A voltage and discriminator sweep was performed to determine optimum sensitivity settings. It was determined that a calibration operating point could be obtained using a {sup 133}Ba 'bolt' as is the case with the original lead probe
Recommended from our members
Neutron scattering effects on fusion ion temperature measurements.
To support the nuclear fusion program at Sandia National Laboratories (SNL), a consistent and verifiable method to determine fusion ion temperatures needs to be developed. Since the fusion temperature directly affects the width in the spread of neutron energies produced, a measurement of the neutron energy width can yield the fusion temperature. Traditionally, the spread in neutron energies is measured by using time-of-flight to convert a spread in neutron energies at the source to a spread in time at detector. One potential obstacle to using this technique at the Z facility at SNL is the need to shield the neutron detectors from the intense bremsstrahlung produced. The shielding consists of eight inches of lead and the concern is that neutrons will scatter in the lead, artificially broaden the neutron pulse width and lead to an erroneous measurement. To address this issue, experiments were performed at the University of Rochester's Laboratory for Laser Energetics, which demonstrated that a reliable ion temperature measurement can be achieved behind eight inches of lead shielding. To further expand upon this finding, Monte Carlo N-Particle eXtended (MCNPX) was used to simulate the experimental geometric conditions and perform the neutron transport. MCNPX was able to confidently estimate results observed at the University of Rochester