Hard X‐ray polarimetry of solar flares with BATSE

We describe a technique for measuring the polarization of hard X‐rays from solar flares based on the angular distribution of that portion of the flux which is scattered off the top of the Earth’s atmosphere. The scattering cross section depends not only on the scatter angle itself, but on the orientation of the scatter angle with respect to the incident polarization vector. Consequently, the distribution of the observed albedo flux will depend on the direction and the polarization properties (i.e., the level of polarization and polarization angle) of the source. Since the albedo component can represent a relatively large fraction (up to 40%) of the direct source flux, there will generally be sufficient signal for making such a measurement. The sensitivity of this approach is therefore dictated by the effective area and the ability of a detector system to ‘image’ the albedo flux. The 4π coverage of the BATSE detectors on the Compton Gamma‐RayObservatory provides an opportunity to measure both the direct and the albedo flux from a given solar flare event. Although the BATSE design (with its large field‐of‐view for each detector) is not optimized for albedo polarimetry, we have nonetheless investigated the feasibility of this technique using BATSE data

Using BATSE to measure gamma-ray burst polarization

We describe a technique for measuring the polarization of hard x-rays from γ-ray bursts based on the angular distribution of that portion of the flux which is scattered off the top of the Earth’s atmosphere. The scattering cross section depends not only on the scatter angle itself, but on the orientation of the scatter angle with respect to the incident polarization vector. Consequently, the distribution of the observed albedo flux will depend on the direction and the polarization properties (i.e., the level of polarization and polarization angle) of the source. Although the BATSE design (with its large field-of-view for each detector) is not optimized for albedo polarimetry, we have nonetheless investigated the feasibility of this technique using BATSE data

Discovery of Pulsed X-ray Emission from the SMC Transient RX J0117.6-7330

We report on the detection of pulsed, broad-band, X-ray emission from the transient source RX J0117.6-7330. The pulse period of 22 seconds is detected by the ROSAT/PSPC instrument in a 1992 Sep 30 - Oct 2 observation and by the CGRO/BATSE instrument during the same epoch. Hard X-ray pulsations are detectable by BATSE for approximately 100 days surrounding the ROSAT observation (1992 Aug 28 - Dec 8). The total directly measured X-ray luminosity during the ROSAT observation is 1.0E38 (d/60 kpc)^2 ergs s-1. The pulse frequency increases rapidly during the outburst, with a peak spin-up rate of 1.2E-10 Hz s-1 and a total frequency change 1.8%. The pulsed percentage is 11.3% from 0.1-2.5 keV, increasing to at least 78% in the 20-70 keV band. These results establish RX J0117.6-7330 as a transient Be binary system.Comment: 17 pages, Latex, aasms, accepted for publication in ApJ Letter

Visualizing Information on a Sphere

We describe a method for the visualization of information units on spherical domains which is employed in the banking industry for risk analysis, stock prediction and other tasks. The system is based on a quantification of the similarity of related objects that governs the parameters of a mass-spring system. Unlike existing approaches we initialize all information units onto the inner surface of two concentric spheres and attach them with springs to the outer sphere. Since the spring stiffnesses correspond to the computed similarity measures, the system converges into an energy minimum which reveals multidimensional relations and adjacencies in terms of spatial neighborhoods. Depending on the application scenario our approach supports different topological arrangements of related objects. In order to cope with large data sets we propose a blobby clustering mechanism that enables encapsulation of similar objects by implicit shapes. In addition, we implemented various interaction techniques allowing semantic analysis of the underlying data sets. Our prototype system IVORY is written in JAVA, and its versatility is illustrated by an example from financial service providers

Polarised target for Drell-Yan experiment in COMPASS at CERN, part I

In the polarised Drell-Yan experiment at the COMPASS facility in CERN pion beam with momentum of 190 GeV/c and intensity about $10^8$ pions/s interacted with transversely polarised NH$_3$ target. Muon pairs produced in Drel-Yan process were detected. The measurement was done in 2015 as the 1st ever polarised Drell-Yan fixed target experiment. The hydrogen nuclei in the solid-state NH$_3$ were polarised by dynamic nuclear polarisation in 2.5 T field of large-acceptance superconducting magnet. Large helium dilution cryostat was used to cool the target down below 100 mK. Polarisation of hydrogen nuclei reached during the data taking was about 80 %. Two oppositely polarised target cells, each 55 cm long and 4 cm in diameter were used. Overview of COMPASS facility and the polarised target with emphasis on the dilution cryostat and magnet is given. Results of the polarisation measurement in the Drell-Yan run and overviews of the target material, cell and dynamic nuclear polarisation system are given in the part II.Comment: 4 pages, 2 figures, Proceedings of the 22nd International Spin Symposium, Urbana-Champaign, Illinois, USA, 25-30 September 201

Imaging and burst location with the EXIST high-energy telescope

The primary instrument of the proposed EXIST mission is a coded mask high energy telescope (the HET), that must have a wide field of view and extremely good sensitivity. It will be crucial to minimize systematic errors so that even for very long total integration times the imaging performance is close to the statistical photon limit. There is also a requirement to be able to reconstruct images on-board in near real time in order to detect and localize gamma-ray bursts. This must be done while the spacecraft is scanning the sky. The scanning provides all-sky coverage and is key to reducing systematic errors. The on-board computational problem is made even more challenging for EXIST by the very large number of detector pixels. Numerous alternative designs for the HET have been evaluated. The baseline concept adopted depends on a unique coded mask with two spatial scales. Monte Carlo simulations and analytic analysis techniques have been used to demonstrate the capabilities of the design and of the proposed two-step burst localization procedure

Investigation of percussion drills for geothermal applications

A series of tests was conducted to provide data for an economic evaluation of percussion drilling in geothermal reservoirs. Penetration rate, operation on aqueous foam, and high temperature vulnerabilities of downhole percussion tools are described

Discovery of 16.6 and 25.5 s Pulsations from the Small Magellanic Cloud

We report the serendipitous detection of two previously unreported pulsars from the direction of the Small Magellanic Cloud, with periods of 16.6 and 25.5 seconds. The detections are based on archival PCA data from the Rossi X-ray Timing Explorer (RXTE). The observation leading to these detections occurred in September 2000 extending over 2.1 days with an exposure of 121 ks. A possible identification of the 16.6 s pulsar with an X-ray source RX J0051.8-7310 seen by both ROSAT and ASCA imaging X-ray satellites is presented.Comment: 9 pages with 3 figures. Submitted to ApJ Letter

Adaptive Vehicle Control

This report presents the final design for our device made for Mrs. Laura Jagels. Mrs. Jagels, who has an above the knee amputation, needed a device that would allow her to operate a manual car in a safe and reliable way that still gives her the traditional driving experience. This report takes into consideration the shortcomings of current market devices that enable amputees to operate vehicles. From this research and through interviews with Mrs. Jagels, we were able to decide on our device specifications, giving us a basis to objectively evaluate designs. Ideation and concept prototype building was performed for the following functions and characteristics: pedal selection, pedal modulation, device attachment. Based on this ideation, Pugh Matrix analysis and a Weighted Decision Matrix on full concept models, we devised a design direction that was approved by Mrs. Jagels. We then finalized part selection and built the final prototype. We also discuss and justify our design decisions, present out manufacturing process, discuss our testing results, and break down the total cost of the device. We end the report with insights and recommendations to further improve the device

Search for weakly interacting sub-eV particles with the OSQAR laser-based experiment: results and perspectives

Recent theoretical and experimental studies highlight the possibility of new fundamental particle physics beyond the Standard Model that can be probed by sub-eV energy experiments. The OSQAR photon regeneration experiment looks for "Light Shining through a Wall" (LSW) from the quantum oscillation of optical photons into "Weakly Interacting Sub-eV Particles" (WISPs), like axion or axion-like particles (ALPs), in a 9 T transverse magnetic field over the unprecedented length of $2 \times 14.3$ m. No excess of events has been detected over the background. The di-photon couplings of possible new light scalar and pseudo-scalar particles can be constrained in the massless limit to be less than $8.0\times10^{-8}$ GeV$^{-1}$. These results are very close to the most stringent laboratory constraints obtained for the coupling of ALPs to two photons. Plans for further improving the sensitivity of the OSQAR experiment are presented.Comment: 7 pages, 7 figure