A planar near-field scanning technique for bistatic radar cross section measurements

A progress report on the development of a bistatic radar cross section (RCS) measurement range is presented. A technique using one parabolic reflector and a planar scanning probe antenna is analyzed. The field pattern in the test zone is computed using a spatial array of signal sources. It achieved an illumination pattern with 1 dB amplitude and 15 degree phase ripple over the target zone. The required scan plane size is found to be proportional to the size of the desired test target. Scan plane probe sample spacing can be increased beyond the Nyquist lambda/2 limit permitting constant probe sample spacing over a range of frequencies

Aeronomy report no. 73: Analysis of sounding rocket data from Punta Chilca, Peru

A technique is described for measuring electron concentrations in the lower portion of the ionosphere above Punta Chilca. A radio-propagation experiment for measuring Faraday rotation is combined with a dc/Langmuir probe experiment for measuring electron current. The results obtained from the analysis of radio and probe data from Nike Apache 14.532, which was launched at 20:26 UT on May 28, 1975, at a solar zenith angle of 60 deg are presented. A comparison of the profiles of electron concentration indicates that the value of the maximum ionization in the D region under quiet conditions is proportional to the square of the cosine of the solar zenith angle

Adaptive antenna arrays for satellite communications: Design and testing

When two separate antennas are used with each feedback loop to decorrelate noise, the antennas should be located such that the phase of the interfering signal in the two antennas is the same while the noise in them is uncorrelated. Thus, the antenna patterns and spatial distribution of the auxiliary antennas are quite important and should be carefully selected. The selection and spatial distribution of auxiliary elements is discussed when the main antenna is a center fed reflector antenna. It is shown that offset feeds of the reflector antenna can be used as auxiliary elements of an adaptive array to suppress weak interfering signals. An experimental system is designed to verify the theoretical analysis. The details of the experimental systems are presented

Engineering calculations for the Delta S method of solving the orbital allotment problem

The method of calculating single-entry separation requirements for pairs of satellites is extended to include the interference on the top link as well as on the down link. Several heuristic models for analyzing the effects of shaped-beam antenna designs on required satellite separations are introduced and demonstrated with gain contour plots. The calculation of aggregate interference is extended to include the effects of up-link interference. The relationship between the single-entry C/I requirements, used in determining satellite separation constraints for various optimization procedures, and the aggregate C/I values of the resulting solutions is discussed

Steps towards the development of an experimentally verified simulation of pool nucleate boiling on a silicon wafer with artificial sites

Nucleate boiling is a very effective heat transfer cooling process, used in numerous industrial applications. Despite intensive research over decades, a reliable model of nucleate pool boiling is still not available. This paper presents a numerical and experimental investigation of nucleate boiling from artificial nucleation sites. The numerical investigation described in the first section of the paper is carried out by a hybrid mechanistic numerical code first developed at the University of Ljubljana to simulate the temperature field in a heated stainless steel plate with a large number of nucleation sites during pool boiling of water at atmospheric pressure. It is now being redeveloped to interpret experiments on pool boiling at artificial sites on a silicon plate and as a design tool to investigate different arrangements of sites to achieve high heat fluxes. The code combines full simulation of the temperature field in the solid wall with simplified models or correlations for processes in the liquid-vapour region. The current capabilities and limitations of the code are reviewed and improvements are discussed. Examples are given of the removal of computational constraints on the activation of sites in close proximity and improvements to the bubble growth model. Preliminary simulations are presented to compare the wall conditions to be used in the experiments on silicon at Edinburgh University with the conditions in current experiments on thin metal foils at Ljubljana. An experimental rig for boiling experiments with artificial cavities on a 0.38 mm thick silicon wafer immersed in FC-72, developed at Edinburgh University, is described in the second part of the paper

Case-control study of stroke and the quality of hypertension control in north west England

Objective: To examine the risk of stroke in relation to quality of hypertension control in routine general practice across an entire health district. Design: Population based matched case-control study. Setting: East Lancashire Health District with a participating population of 388,821 aged < or = 80. Subjects: Cases were patients under 80 with their first stroke identified from a population based stroke register between 1 July 1994 and 30 June 1995. For each case two controls matched with the case for age and sex were selected from the same practice register. Hypertension was defined as systolic blood pressure > or = 160 mm Hg or diastolic blood pressure > or = 95 mm Hg, or both, on at least two occasions within any three month period or any history of treatment with antihypertensive drugs. Main outcome measures: Prevalence of hypertension and quality of control of hypertension assessed by using the mean blood pressure recorded before stroke) and odds ratios of stroke (derived from conditional logistic regression). Results: Records of 267 cases and 534 controls were examined; 61% and 42% of these subjects respectively were hypertensive. Compared with non-hypertensive subjects hypertensive patients receiving treatment whose average pre-event systolic blood pressure was controlled to or = 160 mm Hg) or untreated had progressively raised odds ratios of 1.6, 2.2, 3.2, and 3.5 respectively. Results for diastolic pressure were similar; both were independent of initial pressures before treatment. Around 21% of strokes were thus attributable to inadequate control with treatment, or 46 first events yearly per 100,000 population aged 40-79. Conclusions: Risk of stroke was clearly related to quality of control of blood pressure with treatment. In routine practice consistent control of blood pressure to below 150/90 mm Hg seems to be required for optimal stroke prevention

Planar near-field scanning for compact range bistatic radar cross-section measurement

The design, construction, and testing of a low cost, planar scanning system to be used in a compact range environment for bistatic radar cross-section (bistatic RCS) measurement data are discussed. This scanning system is similar to structures used for measuring near-field antenna patterns. A synthetic aperture technique is used for plane wave reception. System testing entailed comparison of measured and theoretical bistatic RCS of a sphere and a right circular cylinder. Bistatic scattering analysis of the ogival target support, target and pedestal interactions, and compact range room was necessary to determine measurement validity

Simulation and experimental investigation of pool boiling on a silicon wafer with artificial nucleation sites

This paper reports progress on a project to develop a design tool for large arrays of nucleation sites at specified locations to achieve high rates of cooling by pool boiling. The tool will be based on an improved version of a hybrid simulation, in which the 3-D temperature field in the wall is solved numerically, along with simple sub-models for bubble-driven heat transfer that require experimental calibration. Improvements to the computer code and progress with the experiments are reported briefly. The paper focuses on the development of a sub-model for the lateral coalescence of bubbles, which is shown to cause irregularity in the bubble production by a regular array of nucleation sites

Revealing the X-ray Variability of AGN with Principal Component Analysis

We analyse a sample of 26 active galactic nuclei with deep XMM-Newton observations, using principal component analysis (PCA) to find model independent spectra of the different variable components. In total, we identify at least 12 qualitatively different patterns of spectral variability, involving several different mechanisms, including five sources which show evidence of variable relativistic reflection (MCG-6-30-15, NGC 4051, 1H 0707-495, NGC 3516 and Mrk 766) and three which show evidence of varying partial covering neutral absorption (NGC 4395, NGC 1365, and NGC 4151). In over half of the sources studied, the variability is dominated by changes in a power law continuum, both in terms of changes in flux and power law index, which could be produced by propagating fluctuations within the corona. Simulations are used to find unique predictions for different physical models, and we then attempt to qualitatively match the results from the simulations to the behaviour observed in the real data. We are able to explain a large proportion of the variability in these sources using simple models of spectral variability, but more complex models may be needed for the remainder. We have begun the process of building up a library of different principal components, so that spectral variability in AGN can quickly be matched to physical processes. We show that PCA can be an extremely powerful tool for distinguishing different patterns of variability in AGN, and that it can be used effectively on the large amounts of high-quality archival data available from the current generation of X-ray telescopes.Comment: 25 pages, 27 figures, accepted to MNRAS. Analysis code available on request to lead author. Edit: Rogue table remove