Enhancing carbon sequestration in soil with coal combustion products: a technology for minimising carbon footprints in coal-power generation and agriculture

Coal-fired power generation and agriculture account for more than half of global greenhouse gas emissions, but the coal fly ash (CFA) produced in the former can be a resource for reducing emissions from agriculture to minimise environmental footprints in both industries. Our aim in this study was to test how acidic and alkaline CFA addition could minimise loss of C and N from acidic soil, with or without added manure. We determined composition and structural characteristics of acidic and alkaline CFA for their capacity to adsorb organic carbon, but observed poor adsorption because of low concentrations of cenospheres and unburnt carbon as the primary absorbents in the ash. Addition of CFA had no impact on the loss of carbon or nitrogen from unmanured soil in which concentrations of these nutrients were low. Loss of carbon from manured soil was reduced by 36% with alkaline ashes and by 3-fold with acidic ashes; while loss of N was 30–50% lower with acidic ashes, but 28% higher with alkaline ashes, compared with no ash treatment. The increases in C sparing with CFA addition were achieved not by direct C absorption but by restraining microbial population and respiration, and potentially emissions. Alkaline CFA increased soil pH and if used to substitute just 10% of lime for ameliorating soil acidity would reduce CO2 emission associated with the mining of the lime and its eventual dissolution in soil by ~ 2.66 Tg or 2.8% of Australia’s annual agricultural emissions. High concentrations of oxides of phosphorus, silicon, titanium and clay particles in acidic ashes, and oxides of cations in alkaline ashes, were associated with potential for promoting C storage and acidity amelioration in soil

The impact of aluminosilicate-based additives upon the sintering and melting behaviour of biomass ash

The composition of ash arising from biomass combustion can cause significant slagging and fouling issues in pulverised-fuel boilers, particularly if high concentrations of alkalis are present. Al–Si additives have shown promise in improving the ash deposition characteristics of troublesome biomass, converting volatile potassium to potassium aluminosilicates. This article presents results of lab-scale testing for two high-potassium biomass ashes, olive-cake (OCA) and white-wood (WWA), combined with two promising additives, coal pulverised fuel ash (PFA) and kaolin powder, at 5% mass fraction. Ash fusion testing results show that the use of these additives consistently increases flow temperatures. For WWA, kaolin was observed to reduce deformation temperatures and increase flow temperatures to far above combustion temperatures. Sinter strength testing showed that additive use significantly improves the deposition properties of OCA, preventing the precipitation of KCl and formation of deposits that are highly undesirable for removal via sootblower. Sintering was eliminated at all temperatures measured with the use of kaolin. Both additives had negative effects upon the sintering of WWA, indicating that Al–Si additive use should be restricted to high K, high Cl biomass. High temperature viscometry of OCA, combined with thermodynamic modelling, showed that viscosities at combustion temperatures were far below ideal values due high Mg concentration and silicate formation. Kaolin at 5% mass fraction was predicted to significantly improve this behaviour, with aluminosilicate formation producing favourable viscosities. Results indicate that kaolin addition to high K, high Cl biomass such as OCA shows promise in making the ash compositions viable for pulverised-fuel combustion