'Aurora'-a time domain based meta-algorithm for the rapid simulation and design of complex optical circuits

A new simulation tool called ‘Aurora’, specifically developed to efficiently simulate highly complex optical devices such as OADMs and Routers based on (higher order)microring resonators, is presented. The meta-simulation algorithm used by Aurora creates a framework in which many different simulation algorithms can be properly combined rather than providing a simulation algorithm itself. The calculations of this program use a simple scheme based in the time domain from which the frequency response can easily be derived. Simulation results of a 4-port OADM and waveguide gratings show excellent agreement when compared to experimentally obtained measurement data and conventional simulation methods

Ultrafast all-optical wavelength conversion in silicon-insulator waveguides by means of cross phase modulation using 300 femtosecond pulses

In this paper we report the ultrafast all-optical wavelength conversion in Silicon-on-Insulator (SOI) waveguides. We used a pump-probe setup with 300 femtosecond pulses to demonstrate large temporal phase-shifts, caused by the Kerr effect and free carrier generation. Large wavelength shifts of a 1683nm probe signal have been observed. The wavelength conversion, ranging from 10nm redshifts to 15nm blueshifts, depending on the time delay between the pump and probe pulses, is caused by the pump induced Cross Phase Modulation. Furthermore, an all-optical switching scheme using SOI microring resonators is discussed. These results enable ultrafast all-optical switching using SOI microring resonators

Absorption spectroscopy of complex rare earth ion doped hybrid materials over a broad wavelength range

In the present work we applied a measurement setup to determine several relevant properties of rare-earth doped nanoparticles dispersed in polymer slab waveguides in a single absorption measurement: background absorption of the polymer host material, water absorption, polymer composition (overtones), rare earth concentration, and ligand contribution (increase of exponential loss trend in the UV). Furthermore, nanoparticle size and concentration in case of a refractive index mismatch (1//spl lambda//sup 4/ and r/sup 6/ dependence of Rayleigh scattering losses in the UV) could be extracted

The hydrological response of the Ourthe catchment to climate change as modelled by the HBV model

The Meuse is an important river in Western Europe, which is almost exclusively rain-fed. Projected changes in precipitation characteristics due to climate change, therefore, are expected to have a considerable effect on the hydrological regime of the river Meuse. We focus on an important tributary of the Meuse, the Ourthe, measuring about 1600 km2. The well-known hydrological model HBV is forced with three high-resolution (0.088°) regional climate scenarios, each based on one of three different IPCC CO2 emission scenarios: A1B, A2 and B1. To represent the current climate, a reference model run at the same resolution is used. Prior to running the hydrological model, the biases in the climate model output are investigated and corrected for. Different approaches to correct the distributed climate model output using single-site observations are compared. Correcting the spatially averaged temperature and precipitation is found to give the best results, but still large differences exist between observations and simulations. The bias corrected data are then used to force HBV. Results indicate a small increase in overall discharge, especially for the B1 scenario during the beginning of the 21st century. Towards the end of the century, all scenarios show a decrease in summer discharge, partially because of the diminished buffering effect by the snow pack, and an increased discharge in winter. It should be stressed, however, that we used results from only one GCM (the only one available at such a high resolution). It would be interesting to repeat the analysis with multiple model

Ultrafast all-optical wavelength conversion in silicon waveguides using femtosecond pump-probe pulses

Experimental results on ultrafast all-optical wavelength conversion in silicon-on-insulator waveguides are presented. Red and blue shifts of 10nm have been observed in femtosecond pump-probe experiments. Alloptical switching and the importance of waveguide dispersion are discussed

Corporate real estate strategies for future higher education

Purpose – This paper aims to explore the alignment of Corporate Real Estate (CRE) strategies of Dutch Universities of Applied Sciences (UAS) with the developments in higher education

Optical gain of LaF3:Nd nanoparticle doped polymers for active integrated optical devices.

We report on rare earth doped LaF3 nanoparticles dispersed in PMMA and SU-8 photosensitive polymers. We observed optical gain after we applied these materials for waveguides. Experimental results on various samples will be discussed. We theoretically discuss the improvements that can be obtained and the possibilities of this new class of materials when applied to microring resonators

Self Phase Modulation and Stimulated Raman Scattering due to High Power Femtosecond Pulse Propagation in Silicon-on-Insulator Waveguides.

Self Phase Modulation (SPM) and Stimulated Raman Scattering (SRS) in silicon waveguides have been observed and will be discussed theoretically using a modified Nonlinear Schrödinger Equation. The high optical peak powers needed for the experiments were obtained by coupling sub-picosecond (200fs) transform limited pulses with a spectral width of 12nm into a single mode silicon waveguide. Spectral broadening up to 50nm has been observed due to Self Phase Modulation. An intensity increase of the idler spectrum around 1650nm at the expense of the 1550nm pump signal has been observed as function of pump power, indicating the presence of Stimulated Raman Scattering

Low-cost and low-loss multimode waveguides of photodefinable epoxy

To satisfy the urgent need for low-cost multimode planar waveguides, we developed photodefined, multimode-fiber compatible waveguides with low-cost commercially available epoxies showing low losses from 550 to 1100 nm and around 1300nm