206 research outputs found

    Stimulated Raman scattering in an optical parametric oscillator based on periodically poled MgO-doped stoichiometric LiTaO3

    Full text link
    The evolution versus pump power of the spectrum of a singly resonant optical parametric oscillator based on an MgO-doped periodically poled stoichiometric lithium tantalate crystal is observed. The onset of cascade Raman lasing due to stimulated Raman scattering in the nonlinear crystal is analyzed. Spurious frequency doubling and sum-frequency generation phenomena are observed and understood. A strong reduction of the intracavity Raman scattering is obtained by a careful adjustment of the cavity losses.Comment: 6 figure

    Sub-kHz-level relative stabilization of an intracavity doubled continuous wave optical parametric oscillator using Pound-Drever-Hall scheme

    Get PDF
    We report the relative frequency stabilization of an intracavity frequency doubled singly resonant optical parametric oscillator on a Fabry-Perot\'etalon. The red/orange radiation produced by the frequency doubling of the intracavity resonant idler is stabilized using the Pound-Drever-Hall locking technique. The relative frequency noise of this orange light, when integrated from 1 Hz to 50 kHz, corresponds to a standard deviation of 700 Hz. The frequency noise of the pump laser is shown experimentally to be transferred to the non resonant signal beam

    Saturation in heteronuclear photoassociation of 6Li7Li

    Full text link
    We report heteronuclear photoassociation spectroscopy in a mixture of magneto-optically trapped 6Li and 7Li. Hyperfine resolved spectra of the vibrational level v=83 of the singlet state have been taken up to intensities of 1000 W/cm^2. Saturation of the photoassociation rate has been observed for two hyperfine transitions, which can be shown to be due to saturation of the rate coefficient near the unitarity limit. Saturation intensities on the order of 40 W/cm^2 can be determined.Comment: 5 pages, 3 figures, to appear in Phys. Rev. A (Rapid Communication

    Aerodynamics of aero-engine installation

    Get PDF
    This paper describes current progress in the development of methods to assess aero-engine airframe installation effects. The aerodynamic characteristics of isolated intakes, a typical transonic transport aircraft as well as a combination of a through-flow nacelle and aircraft configuration have been evaluated. The validation task for an isolated engine nacelle is carried out with concern for the accuracy in the assessment of intake performance descriptors such as mass flow capture ratio and drag rise Mach number. The necessary mesh and modelling requirements to simulate the nacelle aerodynamics are determined. Furthermore, the validation of the numerical model for the aircraft is performed as an extension of work that has been carried out under previous drag prediction research programmes. The validation of the aircraft model has been extended to include the geometry with through flow nacelles. Finally, the assessment of the mutual impact of the through flow nacelle and aircraft aerodynamics was performed. The drag and lift coefficient breakdown has been presented in order to identify the component sources of the drag associated with the engine installation. The paper concludes with an assessment of installation drag for through-flow nacelles and the determination of aerodynamic interference between the nacelle and the aircraft

    Choosy beetles : How host trees and southern boreal forest naturalness may determine dead wood beetle communities

    Get PDF
    Wood-living beetles make up a large proportion of forest biodiversity and contribute to important ecosystem services, including decomposition. Beetle communities in managed southern boreal forests are less species rich than in natural and near-natural forest stands. In addition, many beetle species rely primarily on specific tree species. Yet, the associations between individual beetle species, forest management category, and tree species are seldom quantified, even for red-listed beetles. We compiled a beetle capture dataset from flight intercept traps placed on Norway spruce (Picea abies), oak (Quercus sp.), and Eurasian aspen (Populus tremulae) trees in 413 sites in mature managed forest, near-natural forest, and clear-cuts in southeastern Norway. We used joint species distribution models to estimate the strength of associations for 368 saproxylic beetle species (including 20 vulnerable, endangered, or critical red-listed species) for each forest management category and tree species. Tree species on which traps were mounted had the largest effect on beetle communities; oaks had the most highly associated beetle species, including most of the red-listed species, followed by Norway spruce and Eurasian aspen. Most beetle species were more likely to be captured in near-natural than in mature managed forest. Our estimated associations were compatible ? for many species ? with categorical classifications found in several existing databases of saproxylic beetle preferences. These quantitative beetle-habitat associations will improve future analyses that have typically relied on categorical classifications. Our results highlight the need to prioritize conservation of near-natural forests and oak trees in Scandinavia to protect the habitat of many red-listed species in particular. Furthermore, we underline the importance of carefully considering the species of trees on which traps are mounted in order to representatively sample beetle communities in forest stands.Peer reviewe

    High-precision calculations of van der Waals coefficients for heteronuclear alkali-metal dimers

    Get PDF
    Van der Waals coefficients for the heteronuclear alkali-metal dimers of Li, Na, K, Rb, Cs, and Fr are calculated using relativistic ab initio methods augmented by high-precision experimental data. We argue that the uncertainties in the coefficients are unlikely to exceed about 1%.Comment: 11 pages, 2 figs, graphicx.st

    High-precision determination of transition amplitudes of principal transitions in Cs from van der Waals coefficient C_6

    Get PDF
    A method for determination of atomic dipole matrix elements of principal transitions from the value of dispersion coefficient C_6 of molecular potentials correlating to two ground-state atoms is proposed. The method is illustrated on atomic Cs using C_6 deduced from high-resolution Feshbach spectroscopy. The following reduced matrix elements are determined < 6S_{1/2} || D || 6P_{1/2} > =4.5028(60) |e| a0 and =6.3373(84) |e| a0 (a0= 0.529177 \times 10^{-8} cm.) These matrix elements are consistent with the results of the most accurate direct lifetime measurements and have a similar uncertainty. It is argued that the uncertainty can be considerably reduced as the coefficient C_6 is constrained further.Comment: 4 pages; 3 fig

    Quantum computation with trapped polar molecules

    Full text link
    We propose a novel physical realization of a quantum computer. The qubits are electric dipole moments of ultracold diatomic molecules, oriented along or against an external electric field. Individual molecules are held in a 1-D trap array, with an electric field gradient allowing spectroscopic addressing of each site. Bits are coupled via the electric dipole-dipole interaction. Using technologies similar to those already demonstrated, this design can plausibly lead to a quantum computer with 104\gtrsim 10^4 qubits, which can perform 105\sim 10^5 CNOT gates in the anticipated decoherence time of 5\sim 5 s.Comment: 4 pages, RevTeX 4, 2 figures. Edited for length and converted to RevTeX, but no substantial changes from earlier pdf versio

    High-resolution 3D forest structure explains ecomorphological trait variation in assemblages of saproxylic beetles

    Get PDF
    Climate, topography and the 3D structure of forests are major drivers affecting local species communities. However, little is known about how the specific functional traits of saproxylic (wood-living) beetles, involved in the recycling of wood, might be affected by those environmental characteristics. Here, we combine ecological and morphological traits available for saproxylic beetles and airborne laser scanning (ALS) data in Bayesian trait-based joint species distribution models to study how traits drive the distributions of more than 230 species in temperate forests of Europe. We found that elevation (as a proxy for temperature and precipitation) and the proportion of conifers played important roles in species occurrences while variables related to habitat heterogeneity and forest complexity were less relevant. Furthermore, we showed that local communities were shaped by environmental variation primarily through their ecological traits whereas morphological traits were involved only marginally. As predicted, ecological traits influenced species' responses to forest structure, and to other environmental variation, with canopy niche, wood decay niche and host preference as the most important ecological traits. Conversely, no links between morphological traits and environmental characteristics were observed. Both models, however, revealed strong phylogenetic signal in species' response to environmental characteristics. These findings imply that alterations of climate and tree species composition have the potential to alter saproxylic beetle communities in temperate forests. Additionally, ecological traits help explain species' responses to environmental characteristics and thus should prove useful in predicting their responses to future change. It remains challenging, however, to link simple morphological traits to species' complex ecological niches. Read the free Plain Language Summary for this article on the Journal blog

    Functional structure of European forest beetle communities is enhanced by rare species

    Get PDF
    Biodiverse communities have been shown to sustain high levels of multifunctionality and thus a loss of species likely negatively impacts ecosystem functions. For most taxa, however, roles of individual species are poorly known. Rare species, often most likely to go extinct, may have unique traits and functional roles. Alternatively, rare species may be functionally redundant, such that their loss would not disrupt ecosystem functions. We quantified the functional role of rare species by using captures of wood-living (saproxylic) beetle species, combined with recent databases of morphological and ecological traits, from three regions in central and northern Europe. Using a rarity index based on species' local abundance, geographic range, and habitat breadth, we used local and regional species removal simulations to examine the contributions of both the rarest and the most common beetle species to three measures of community functional structure: functional richness, functional specialization, and functional originality. Both regionally and locally, all three measures declined more rapidly when rare species were removed than under common (or random) species removal scenarios. These consistent patterns across scales and among forest types give evidence that rare species provide unique functional contributions, and their loss may disproportionately impact ecosystem functions. This implies that conservation measures targeting rare and endangered species, such as preserving intact forests with dead wood and mature trees, can provide broader ecosystem-level benefits. Experimental research linking functional structure to ecosystem processes should be prioritized to increase understanding of the functional consequences of species loss and to develop more effective conservation strategies
    corecore