40,876 research outputs found
Recommended from our members
Studies on Temperature and Strain Sensitivities of a Few-mode Critical Wavelength Fiber Optic Sensor
This paper studied the relationship between the temperature/strain wavelength sensitivity of a fiber optic in-line Mach-Zehnder Interferometer (MZI) sensor and the wavelength separation of the measured wavelength to the critical wavelength (CWL) in a CWL-existed interference spectrum formed by interference between LP01 and LP02 modes. The in-line MZI fiber optic sensor has been constructed by splicing a section of specially designed few-mode fiber (FMF), which support LP01 and LP02 modes propagating in the fiber, between two pieces of single mode fiber. The propagation constant difference, Δβ, between the LP01 and LP02 modes, changes non-monotonously with wavelength and reaches a maximum at the CWL. As a result, in sensor operation, peaks on the different sides of the CWL then shift in opposite directions, and the associated temperature/strain sensitivities increase significantly when the measured wavelength points become close to the CWL, from both sides of the CWL. A theoretical analysis carried out has predicted that with this specified FMF sensor approach, the temperature/strain wavelength sensitivities are governed by the wavelength difference between the measured wavelength and the CWL. This conclusion was seen to agree well with the experimental results obtained. Combining the wavelength shifts of the peaks and the CWL in the transmission spectrum of the SFS structure, this study has shown that this approach forms the basis of effective designs of high sensitivity sensors for multi-parameter detection and offering a large measurement range to satisfy the requirements needed for better industrial measurements
Recommended from our members
Research on VCSEL interference analysis and elimination method
Laser methane gas sensors have been increasingly accepted in coal mine safety monitoring. Most laser spectroscopic methane gas sensors are based in BFB lasers at around 1650nm. However, they suffer from high power consumption and high cost due to temperature control is required for laser diode operation at constant temperature. VCSEL lasers have offered low operation current and low power consumption when operating at non-TEC mode. However, it is found that the interference noise is critical for laser methane detection. This paper report typical results of the laser diode ripple characterization method and methods of noise reduction methods are discussed
- …