5,014 research outputs found
Update of the search for Gamma Ray Bursts with ARGO-YBJ in scaler mode
We report an update of the search for emission from Gamma Ray Bursts (GRBs) in the energy range 1−100 GeV in coincidence with the prompt emission detected by satellites, using the large field of view (about 2 sr) air shower detector ARGO-YBJ, appropriate to monitor unpredictable and short duration events like GRBs. The search has been carried out using the single particle technique in time coincidence with satellite detections both for single events and by stacking GRBs in time and phase. Between December 2004 and April 2011, 131 GRBs detected by different satellites occurred in the ARGO-YBJ field of view (zenith angle within 45 degrees). For 110 of these we searched for a high
energy counterpart in the ARGO-YBJ data, finding no statistically significant signal. The resulting fluence upper limits between 1 and 100 GeV reach values as low as 10^(−5) erg/cm2, and in one case (GRB090902B) can be compared with observations by the LAT instrument on the Fermi satellite
Feasibility of Tsunami Early Warning Systems for small volcanic islands
Abstract. This paper investigates the feasibility of Tsunami Early Warning Systems for small volcanic islands focusing on warning of waves generated by landslides at the coast of the island itself. The critical concern is if there is enough time to spread the alarm once the system has recognized that a tsunami has been generated. We use the results of a large scale physical model experiment in order to estimate the time that tsunamis take to travel around the island inundating the coast. We discuss how and where it is convenient to place instruments for the measurement of the waves
Lidar in Space Technology Experiment correlative measurements by lidar in Potenza, southern Italy.
An intensive lidar measurement campaign was carried out in Potenza (40°36′N-15°44′E, 820 m above sea level (asl)) in conjunction with the Lidar in Space Technology Experiment (LITE) mission and primarily aimed at the validation of LITE stratospheric aerosol measurements. Potenza lidar measurements in coincidence with all five nighttime overpasses near southern Italy (September 11, 12, 17, and 18, 1994) are compared with simultaneous LITE data. Potenza lidar data appear to be highly correlated with LITE data both at 355 and 532 nm. Potenza lidar versus LITE measurements of the aerosol-scattering ratio show a correlation coefficient of 0.72–0.81 at 355 nm and 0.88–0.93 at 532 nm, with an average calibration coefficient of 0.92 ± 0.19 at 355 nm and 1.02 ± 0.07 at 532 nm. Comparisons are also made in terms of the average Angstrom coefficient, whose values are consistent with submicrometer aerosol particles. Finally, Potenza lidar measurements of the aerosol layer base and top heights, the peak aerosol-scattering ratio and peak height, as well as of the aerosol scattering ratio at the cloud base appear to be consistent with measurements performed by other ground lidar stations in Europe during the LITE campaign as well as with the LITE data
Surgical management of rhinosinusitis in onco-hematological patients
ObjectivesIn onco-hematological diseases, the incidence of paranasal sinuses infection dramatically increase and requires a combination of medical and surgical therapy. Balloon dilatation surgery (DS) is a minimally invasive, tissue preserving procedure. The study evaluates the results of DS for rhinosinusitis in immunocompromised patients.MethodsA retrospective chart review was conducted in 110 hematologic patients with rhinosinusitis. Twenty-five patients were treated with DS technique and 85 patients with endoscopic sinus surgery (ESS). We considered the type of anesthesia and the extent of intra- and postoperative bleeding. Patients underwent Sino-Nasal Outcome Test (SNOT-20) to evaluate changes in subjective symptoms and global patient assessment (GPA) questionnaire to value patient satisfaction.ResultsLocal anesthesia was employed in 8 cases of DS and in 15 of ESS. In 50 ESS patients, an anterior nasal packing was placed and in 12 cases a repacking was necessary. In the DS group, nasal packing was required in 8 cases and in 2 cases a repacking was placed (P=0.019 and P=0.422, respectively). The SNOT-20 change score showed significant improvement of health status in both groups. However the DS group showed a major improvement in 3 voices: need to blow nose, runny nose, and facial pain/pressure. The 3-month follow-up GPA questionnaire showed an higher satisfaction of DS group.ConclusionBalloon DS represents a potentially low aggressive treatment and appears to be relatively safe and effective in onco-hematologic patients. All these remarks may lead the surgeon to consider a larger number of candidates for surgical procedure
Atmospheric Thermodynamic Profiling through the Use of a Micro-Pulse Raman Lidar System: Introducing the Compact Raman Lidar MARCO
It was for a long time believed that lidar systems based on the use of high-repetition micro-pulse lasers could be effectively used to only stimulate atmospheric elastic backscatter echoes, and thus were only exploited in elastic backscatter lidar systems. Their application to stimulate rotational and roto-vibrational Raman echoes, and consequently, their exploitation in atmospheric thermodynamic profiling, was considered not feasible based on the technical specifications possessed by these laser sources until a few years ago. However, recent technological advances in the design and development of micro-pulse lasers, presently achieving high UV average powers (1–5 W) and small divergences (0.3–0.5 mrad), in combination with the use of large aperture telescopes (0.3–0.4 m diameter primary mirrors), allow one to presently develop micro-pulse laser-based Raman lidars capable of measuring the vertical profiles of atmospheric thermodynamic parameters, namely water vapor and temperature, both in the daytime and night-time. This paper is aimed at demonstrating the feasibility of these measurements and at illustrating and discussing the high achievable performance level, with a specific focus on water vapor profile measurements. The technical solutions identified in the design of the lidar system and their technological implementation within the experimental setup of the lidar prototype are also carefully illustrated and discussed
Characterization of the planetary boundary layer height and structure by Raman lidar: comparison of different approaches
Abstract. The planetary boundary layer (PBL) includes the portion of the atmosphere which is directly influenced by the presence of the earth's surface. Aerosol particles trapped within the PBL can be used as tracers to study the boundary-layer vertical structure and time variability. As a result of this, elastic backscatter signals collected by lidar systems can be used to determine the height and the internal structure of the PBL. The present analysis considers three different methods to estimate the PBL height. The first method is based on the determination of the first-order derivative of the logarithm of the range-corrected elastic lidar signals. Estimates of the PBL height for specific case studies obtained through this approach are compared with simultaneous estimates from the potential temperature profiles measured by radiosondes launched simultaneously to lidar operation. Additional estimates of the boundary layer height are based on the determination of the first-order derivative of the range-corrected rotational Raman lidar signals. This latter approach results to be successfully applicable also in the afternoon–evening decaying phase of the PBL, when the effectiveness of the approach based on the elastic lidar signals may be compromised or altered by the presence of the residual layer. Results from these different approaches are compared and discussed in the paper, with a specific focus on selected case studies collected by the University of Basilicata Raman lidar system BASIL during the Convective and Orographically-induced Precipitation Study (COPS)
Vestibulo-Ocular Reflex Modification after Virtual Environment Exposure
Immersion in an illusory world is possible by means of virtual reality (VR), where environmental perception is modi
bff
c1c ed by artificial sensorial stimulation. The application of VR for the assessment and rehabilitation of pathologies affecting the vestibular system, in terms of both diagnosis and care, could represent an interesting new line of research. Our perception of reality is in fact based on static and dynamic spatial information perceived by our senses. During head movements in a virtual environment the images on the display and the labyrinthine information relative to the head angular accelerations differ and therefore a visuo-vestibular conflict is present. It is known that mismatches between visual and labyrinthine information may modify the vestibulo-oculomotor reflex (VOR) gain. We studied the post-immersion modifications in 20 healthy subjects (mean age 25 years) exposed to a virtual environment for 20 min by wearing a head-mounted display. VOR gain and phase were measured by means of harmonic sinusoidal stimulation in the dark before, at the end of and 30 min after VR exposure. A VOR gain reduction was observed in all subjects at the end of VR exposure which disappeared after 30 min. Our data show that exposure to a virtual environment can induce a temporary modi
bff
c1c cation of the VOR gain. This
bff
c1c nding can be employed to enable an artificial, instrumental modification of the VOR gain and therefore opens up new perspectives in the assessment and rehabilitation of vestibular diseases
- …