Post-Impact Thermal Evolution of Porous Planetesimals

Impacts between planetesimals have largely been ruled out as a heat source in the early Solar System, by calculations that show them to be an inefficient heat source and unlikely to cause global heating. However, the long-term, localized thermal effects of impacts on planetesimals have never been fully quantified. Here, we simulate a range of impact scenarios between planetesimals to determine the post-impact thermal histories of the parent bodies, and hence the importance of impact heating in the thermal evolution of planetesimals. We find on a local scale that heating material to petrologic type 6 is achievable for a range of impact velocities and initial porosities, and impact melting is possible in porous material at a velocity of > 4 km/s. Burial of heated impactor material beneath the impact crater is common, insulating that material and allowing the parent body to retain the heat for extended periods (~ millions of years). Cooling rates at 773 K are typically 1 - 1000 K/Ma, matching a wide range of measurements of metallographic cooling rates from chondritic materials. While the heating presented here is localized to the impact site, multiple impacts over the lifetime of a parent body are likely to have occurred. Moreover, as most meteorite samples are on the centimeter to meter scale, the localized effects of impact heating cannot be ignored.Comment: 38 pages, 9 figures, Revised for Geochimica et Cosmochimica Acta (Sorry, they do not accept LaTeX

Following microscopic motion in a two dimensional glass-forming binary fluid

The dynamics of a binary mixture of large and small discs are studied at temperatures approaching the glass transition using an analysis based on the topology of the Voronoi polygon surrounding each atom. At higher temperatures we find that dynamics is dominated by fluid-like motion that involves particles entering and exiting the nearest-neighbour shells of nearby particles. As the temperature is lowered, the rate of topological moves decreases and motion becomes localised to regions of mixed pentagons and heptagons. In addition we find that in the low temperature state particles may translate significant distances without undergoing changes in their nearest neig hbour shell. These results have implications for dynamical heterogeneities in glass forming liquids.Comment: 12 pages, 7 figure

Focussing quantum states

Does the size of atoms present a lower limit to the size of electronic structures that can be fabricated in solids? This limit can be overcome by using devices that exploit quantum mechanical scattering of electron waves at atoms arranged in focussing geometries on selected surfaces. Calculations reveal that features smaller than a hydrogen atom can be obtained. These structures are potentially useful for device applications and offer a route to the fabrication of ultrafine and well defined tips for scanning tunneling microscopy.Comment: 4 pages, 4 figure

In-place scene labelling and understanding with implicit scene representation

Semantic labelling is highly correlated with geometry and radiance reconstruction, as scene entities with similar shape and appearance are more likely to come from similar classes. Recent implicit neural reconstruction techniques are appealing as they do not require prior training data, but the same fully self-supervised approach is not possible for semantics because labels are human-defined properties.We extend neural radiance fields (NeRF) to jointly encode semantics with appearance and geometry, so that complete and accurate 2D semantic labels can be achieved using a small amount of in-place annotations specific to the scene. The intrinsic multi-view consistency and smoothness of NeRF benefit semantics by enabling sparse labels to efficiently propagate. We show the benefit of this approach when labels are either sparse or very noisy in room-scale scenes. We demonstrate its advantageous properties in various interesting applications such as an efficient scene labelling tool, novel semantic view synthesis, label denoising, super-resolution, label interpolation and multi-view semantic label fusion in visual semantic mapping systems

Response of the Shockley surface state to an external electrical field: A density-functional theory study of Cu(111)

The response of the Cu(111) Shockley surface state to an external electrical field is characterized by combining a density-functional theory calculation for a slab geometry with an analysis of the Kohn-Sham wavefunctions. Our analysis is facilitated by a decoupling of the Kohn-Sham states via a rotation in Hilbert space. We find that the surface state displays isotropic dispersion, quadratic until the Fermi wave vector but with a significant quartic contribution beyond. We calculate the shift in energetic position and effective mass of the surface state for an electrical field perpendicular to the Cu(111) surface; the response is linear over a broad range of field strengths. We find that charge transfer occurs beyond the outermost copper atoms and that accumulation of electrons is responsible for a quarter of the screening of the electrical field. This allows us to provide well-converged determinations of the field-induced changes in the surface state for a moderate number of layers in the slab geometry.Comment: 11 pages, 6 figures, 4 tables; accepted for publication by Phys. Rev. B; changes from v1 in response to referee comments, esp. to Sections I and V.B (inc. Table 4), with many added references, but no change in results or conclusion

Design data collection with Skylab/EREP microwave instrument S-193

There are no author-identified significant results in this report

Double non-equivalent chain structure on vicinal Si(557)-Au surface

We study electronic and topographic properties of the vicinal Si(557)-Au surface using scanning tunneling microscopy and reflection of high energy electron diffraction technique. STM data reveal double wire structures along terraces. Moreover behavior of the voltage dependent STM tip - surface distance is different in different chains. While the one chain shows oscillations of the distance which are sensitive to the sign of the voltage bias, the oscillations in the other chain remain unchanged with respect to the positive/negative biases. This suggests that one wire has metallic character while the other one - semiconducting. The experimental results are supplemented by theoretical calculations within tight binding model suggesting that the observed chains are made of different materials, one is gold and the other one is silicon chain.Comment: 9 pages, 12 figures, accepted for publication in Phys. Rev.

Genome sequence of a gammaherpesvirus from a common bottlenose dolphin (Tursiops truncatus)

A herpesvirus genome was sequenced directly from a biopsy specimen of a rectal lesion from a female common bottlenose dolphin. This genome sequence comprises a unique region (161,235 bp) flanked by multiple copies of a terminal repeat (4,431 bp) and contains 72 putative genes. The virus was named common bottlenose dolphin gammaherpesvirus 1

Glassy behaviour in a simple topological model

In this article we study a simple, purely topological, cellular model which is allowed to evolve through a Glauber-Kawasaki process. We find a non-thermodynamic transition to a glassy phase in which the energy (defined as the square of the local cell topological charge) fails to reach the equilibrium value below a characteristic temperature which is dependent on the cooling rate. We investigate a correlation function which exhibits aging behaviour, and follows a master curve in the stationary regime when time is rescaled by a factor of the relaxation time t_r. This master curve can be fitted by a von Schweidler law in the late beta-relaxation regime. The relaxation times can be well-fitted at all temperatures by an offset Arrhenius law. A power law can be fitted to an intermediate temperature regime; the exponent of the power law and the von Schweidler law roughly agree with the relationship predicted by Mode-coupling Theory. By defining a suitable response function, we find that the fluctuation-dissipation ratio is held until sometime later than the appearance of the plateaux; non-monotonicity of the response is observed after this ratio is broken, a feature which has been observed in other models with dynamics involving activated processes.Comment: 11 pages LaTeX; minor textual corrcetions, minor corrections to figs 4 & 7

Learning meshes for dense visual SLAM

Estimating motion and surrounding geometry of a moving camera remains a challenging inference problem. From an information theoretic point of view, estimates should get better as more information is included, such as is done in dense SLAM, but this is strongly dependent on the validity of the underlying models. In the present paper, we use triangular meshes as both compact and dense geometry representation. To allow for simple and fast usage, we propose a view-based formulation for which we predict the in-plane vertex coordinates directly from images and then employ the remaining vertex depth components as free variables. Flexible and continuous integration of information is achieved through the use of a residual based inference technique. This so-called factor graph encodes all information as mapping from free variables to residuals, the squared sum of which is minimised during inference. We propose the use of different types of learnable residuals, which are trained end-to-end to increase their suitability as information bearing models and to enable accurate and reliable estimation. Detailed evaluation of all components is provided on both synthetic and real data which confirms the practicability of the presented approach