Time resolved imaging of magnetization dynamics in hard disk writer yokes excited by bipolar current pulses

This is the final version of the article. Available from the American Institute of Physics via the DOI in this record.A partially built hard disk writer structure with a NiFe/CoFe/Ru/NiFe/CoFe synthetic antiferromagnetic (SAF) yoke was studied by time and vector resolved scanning Kerr microscopy. All three time dependent components of the magnetization were recorded simultaneously as a bipolar current pulse with 1 MHz repetition rate was delivered to the coil. The component of magnetization parallel to the symmetry axis of the yoke was compared at the pole and above a coil winding in the centre of the yoke. The two responses are in phase as the pulse rises, but the pole piece lags the yoke as the pulse falls. The Kerr signal is smaller within the yoke than within the confluence region during pulse cycling. This suggests funneling of flux into the confluence region. Dynamic images acquired at different time delays showed that the relaxation is faster in the centre of the yoke than in the confluence region, perhaps due to the different magnetic anisotropy in these regions. Although the SAF yoke is designed to support a single domain to aid flux conduction, no obvious flux beaming was observed, suggesting the presence of a more complicated domain structure. The SAF yoke writer hence provides relatively poor flux conduction but good control of rise time compared to single layer and multi-layered yokes studied previously.The authors acknowledge the financial support of Seagate Pla

Time- and vector-resolved Kerr microscopy of hard disk writers

Copyright © 2011 American Institute of Physics. This article may be downloaded for personal use only. Any other use requires prior permission of the author and the American Institute of Physics. The following article appeared in Applied Physics Letters 99 (2011) and may be found at http://dx.doi.org/10.1063/1.3665957Time-resolved scanning Kerr microscopy has been used to make wafer level measurements of magnetization dynamics within the yoke and pole piece of partially built hard disk writer structures. Three Cartesian components of the vector magnetization were recorded simultaneously using a quadrant photodiode polarization bridge detector. The rise time, relaxation time, and amplitude of each component has been related to the magnetic ground state, the initial torque, and flux propagation through the yoke and pole piece. Dynamic images reveal “flux-beaming” in which the magnetization component parallel to the symmetry axis of the yoke is largest along that axis

Erratum: “Time resolved scanning Kerr microscopy of hard disk writer structures with a multilayered yoke” [Appl. Phys. Lett. 102, 162407 (2013)]

This is the final version of the article. Available from the American Institute of Physics via the DOI in this record.The original article is in ORE at http://hdl.handle.net/10871/21958There is no abstract available for this articl

Time resolved scanning Kerr microscopy of hard disk writer structures with a multilayered yoke

The erratum is available in ORE at http://hdl.handle.net/10871/21966Partially built hard disk writer structures with a multilayered yoke formed from 4 repeats of a NiFe(∼1 nm)/CoFe(50 nm) bilayer were studied by time and vector resolved scanning Kerr microscopy. Dynamic images of the in-plane magnetization suggest an underlying closure domain equilibrium state. This state is found to be modified by application of a bias magnetic field and also during pulse cycling, leading to different magnetization rotation and relaxation behavior within the tip region. © 2013 AIP Publishing LLC.The authors gratefully acknowledge financial support from the Seagate Plan

Interference between items stored for distinct tasks in visual working memory

The action perspective on working memory suggests that memory representations are coded according to their specific temporal and behavioral task demands. This stands in contrast to theories that assume representations are stored in a task-agnostic format within a “common workspace”. Here, we tested whether visual items that are memorized for different tasks are stored separately from one another or show evidence of inter-item interference during concurrent maintenance, indicating a common storage. In two experiments, we combined a framing memory task (memorize a motion direction for continuous direction report) with an embedded memory task (memorize a motion direction for a binary direction discrimination) that was placed within the retention period of the framing task. Even though the temporal and action demands were item specific, we observed two types of interference effects between the items: The embedded motion direction was (1) repulsed away and (2) degraded in precision by the motion direction of the item in the framing task. Repulsion and precision degradation increased with item similarity when both items were concurrently held in working memory. In contrast, perceptual and iconic memory control conditions revealed weaker repulsion overall and no interference effect on precision during the stimulus processing stages prior to working memory consolidation. Thus, additional inter-item interference arose uniquely within working memory. Together, our results present evidence that items that are stored for distinct tasks to be performed at distinct points in time, reside in a common workspace in working memory

Time resolved scanning Kerr microscopy of flux beam formation in hard disk write heads

This is the author accepted manuscript. The final version is available from the publisher via the DOI in this record.The underlying research dataset supporting this publication is available under a Creative Commons Attribution-ShareAlike 4.0 International License (https://creativecommons. org/licenses/by-sa/4.0/) and can be publicly accessed in Open Research Exeter via the following persistent identifier: http://hdl.handle.net/10871/21108.To meet growing data storage needs, the density of data stored on hard disk drives must increase. In pursuit of this aim the magnetodynamics of the hard disk write head must be characterized and understood, particularly the process of “flux beaming”. In this study, seven different configurations of perpendicular magnetic recording (PMR) write heads were imaged using time-resolved scanning Kerr microscopy, revealing their detailed dynamic magnetic state during the write process. It was found that the precise position and number of driving coils can significantly alter the formation of flux beams during the write process. These results are applicable to the design and understanding of current PMR and next-generation heat-assisted magnetic recording (HAMR) devices, as well as being relevant to other magnetic devices.The authors gratefully acknowledge financial support from the Seagate Plan

Imaging the equilibrium state and magnetization dynamics of partially built hard disk write heads

This is the final version of the article. Available from the American Institute of Physics via the DOI in this record.Four different designs of partially built hard disk write heads with a yoke comprising four repeats of NiFe (1nm)/CoFe (50nm) were studied by both x-ray photoemission electron microscopy (XPEEM) and time-resolved scanning Kerr microscopy (TRSKM). These techniques were used to investigate the static equilibrium domain configuration and the magnetodynamic response across the entire structure, respectively. Simulations and previous TRSKM studies have made proposals for the equilibrium domain configuration of similar structures, but no direct observation of the equilibrium state of the writers has yet been made. In this study, static XPEEM images of the equilibrium state of writer structures were acquired using x-ray magnetic circular dichroism as the contrast mechanism. These images suggest that the crystalline anisotropy dominates the equilibrium state domain configuration, but competition with shape anisotropy ultimately determines the stability of the equilibrium state. Dynamic TRSKM images were acquired from nominally identical devices. These images suggest that a longer confluence region may hinder flux conduction from the yoke into the pole tip: the shorter confluence region exhibits clear flux beaming along the symmetry axis, whereas the longer confluence region causes flux to conduct along one edge of the writer. The observed variations in dynamic response agree well with the differences in the equilibrium magnetization configuration visible in the XPEEM images, confirming that minor variations in the geometric design of the writer structure can have significant effects on the process of flux beaming.The authors gratefully acknowledge financial support from the Seagate Plan

A many-analysts approach to the relation between religiosity and well-being

The relation between religiosity and well-being is one of the most researched topics in the psychology of religion, yet the directionality and robustness of the effect remains debated. Here, we adopted a many-analysts approach to assess the robustness of this relation based on a new cross-cultural dataset (N = 10, 535 participants from 24 countries). We recruited 120 analysis teams to investigate (1) whether religious people self-report higher well-being, and (2) whether the relation between religiosity and self-reported well-being depends on perceived cultural norms of religion (i.e., whether it is considered normal and desirable to be religious in a given country). In a two-stage procedure, the teams first created an analysis plan and then executed their planned analysis on the data. For the first research question, all but 3 teams reported positive effect sizes with credible/confidence intervals excluding zero (median reported beta = 0.120). For the second research question, this was the case for 65% of the teams (median reported beta = 0.039). While most teams applied (multilevel) linear regression models, there was considerable variability in the choice of items used to construct the independent variables, the dependent variable, and the included covariates.</p

Current directions in visual working memory research: An introduction and emerging insights

Visual working memory (VWM) is a core construct in the cognitive (neuro-)sciences, assumed to serve as a hub for information exchange and thus supporting a multitude of cognitive functions related to processing visual information. Here, we give an introduction into key terms and paradigms and an overview of ongoing debates in the field, to which the articles collected in this Special Issue on 'Current Directions in Visual Working Memory Research' contribute. Our aim is to extract, from this overview, some 'emerging' theoretical insights concerning questions such as the optimal way to examine VWM, which types of mental representations contribute to performance on VWM tasks, and how VWM keeps features from the same object together and apart from features of concurrently maintained objects (the binding problem)