Stratigraphic and taxonomic considerations on the late Cretaceous rudist fauna of Aksai Chin (Western Tibet, China) from the De Filippi collection

The rudist fauna collected in western Tibet in the Aksai Chin area by the DE FILIPPI expedition in 1914 has been reprised and redescribed. This fauna is composed of Radiolites cf. lusitanicus, Radiolites sp., Gorjanovicia cf. endrissi, ? Sauvagesia sp., Sphaerulites sp., Durania sp., and Gyropleu-ra sp. The rudist-bearing beds belong to the Tielongtan Group of the Tianshuihai terrane. The Turo-nian-? Coniacian Xiloqzung Formation (Fm.) bear the older rudists (Radiolites cf. lusitanicus, Radiolites sp., Sphaerulites sp., Durania sp.), whereas younger ages have been determined through microfossil analysis which, compared with the western Neotethys records, suggests an early-mid Campanian age. This allowed to ascribe the younger rudists of the collection (Gorjanovicia cf. endrissi, ? Sauvagesia sp., Gyropleura sp., Radiolites sp.) to the Dongloqzung Formation. Our data confirm that rudist-bea-ring facies in the Tielongtan Group extend at least up to the middle Campanian. The Aksai Chin rudist assemblage should belong to the Southwestern Asian assemblage of the Eastern Mediterranean Sub-province

Investigation via morphological analysis of aluminium foams produced by replication casting

Foams and porous materials with cellular structure have many interesting combinations of physical and mechanical properties coupled with low specific weight. By means of replication casting it is possible to manufacture foams from molten metal without direct foaming. A soluble salt is used as space holder, which is removed by leaching in water. This can be done successfully if the content of space holding fillers is so high that all the granules are interconnected. One of the main advantages of using the replication casting is a close control of pore sizes which is given by the distribution of particle sizes of the filler material. This contrasts with the pore size distribution of the materials foamed by other processes where a wider statistical distribution of pores is found. On the other hand, the maximum porosities that can be achieved using space holders are limited to values below 60%, whereas the other methods allow for porosities up to 98%. Temperature of the mould and infiltration pressure are critical process parameters: a typical problem encountered is the premature solidification of the melt, especially due to the high heat capacity of the salt. In this work foam properties such as cell shape, distribution and anisotropy and defect presence are investigated by using digital image processing technique. For this purpose replicated AlSi7Mg0.3 alloy foams are produced by infiltrating preforms of NaCl particles, varying the metal infiltration pressure and the mould preheating temperature. An original procedure based on image analysis has been set up to determine size, morphology and distribution of cells. The paper demonstrates that this methodology, coupled with microstructural analysis, is a useful tool for investigating the effects of process parameters on foam properties

The Friendly Health Issue Network to Support Computer-Assisted Education for Clinical Reasoning in Multimorbidity Patients

Clinical reasoning in multimorbidity conditions asks for the ability to anticipate the possible evolutions of the overall health state of a patient and to identify the interactions among the concurrent health issues and their treatments. The HIN (Health Issue Network) approach, as Petri Nets-based formal language, is introduced as capable of providing a novel perspective to facilitate the acquisition of such competencies, graphically representing the network among a set of health issues (HIs) that affect a person throughout their life, and describing how HIs evolve over time. The need to provide a more immediate user-oriented interface has led to the development of f-HIN (friendly HIN), a lighter version based on the same mathematical properties as HIN, from which stems in turn the f-HINe (friendly HIN extracted) model, used to represent networks related to either real patients’ clinical experiences extracted from electronic health records, or from teacher-designed realistic clinical histories. Such models have also been designed to be embedded in a software learning environment that allows drawing a f-HIN diagram, checking for its format correctness, as well as designing clinical exercises for the learners, including their computer-assisted assessment. The present paper aims at introducing and discussing the f-HIN/f-HINe models and their educational use. It also introduces the main features of the software learning environment it was built upon, pointing out its importance to: (i) help medical teachers in designing and representing the context of a learning outcome; and (ii) handle the complex history of a multimorbidity patient, to be conveyed in Case-Based Learning (CBL) exercises

Vertical Greenery as Natural Tool for Improving Energy Efficiency of Buildings

The European Construction Sector Observatory outlined that green building envelopes as green roofs and walls contribute to the reduction of energy demand and CO2 emissions due to the air conditioning in summer periods, and the mitigation of heat islands in urban areas. For this reason, the understanding about the contribution of urban greening infrastructures on buildings to sustainable energy use for air conditioning is urgent. This paper focuses on the analysis of a vertical surface provided with a Parthenocissus quinquefolia (L.) Planch., a winter deciduous species, as green cover of a building, assessing the reduction of the solar radiation energy absorbed by the facade and, consequently, the heat flux (HF) transmitted into the internal ambient. This research shows that, in July, surface temperatures (STs) on the vegetated facade were up to 13 degrees C lower than on the unvegetated (bare) facade. Under the climate and environmental conditions of the green wall located at ENEA Casaccia Research Center, a saving of 2.22 and 1.94 kWh(e)/m(2) , respectively in 2019 and 2020, for the summer cooling electricity load, was achieved. These energy reductions also allowed the saving of 985 and 862 g CO2/m(2) emissions, respectively, in 2019 and 2020. Ultimately, a green factor named K-v* was also elaborated to evaluate the influence of vegetation on the STs as well as on HFs transmitted into the indoor ambient and adapted to the case of a detached vertical green cover. Measurements of K-v* factor lasting three years showed the suitability of this index for defining the shading capacity of the vegetation on the building facade surfaces, which can be used to predict thermal gains and effects in a building endowed of a vertical green system

Understanding petri nets in health sciences education. The health issue network perspective

Scarce literature exists as to the use of Petri Nets (PN) to model the dynamic evolution of health issues in a deterministic way. Starting from the HIN (Health Issue Network) approach, the paper aims at describing the suitability of PN in supporting the Case–Based Learning method for improving an educational simulation environment in which students can manage realistic clinical data related to the evolution of a patient's health state over time

An Italian dinosaur Lagerstätte reveals the tempo and mode of hadrosauriform body size evolution

During the latest Cretaceous, the European Archipelago was characterized by highly fragmented landmasses hosting putative dwarfed, insular dinosaurs, claimed as fossil evidence of the “island rule”. The Villaggio del Pescatore quarry (north-eastern Italy) stands as the most informative locality within the palaeo-Mediterranean region and represents the first, multi-individual Konservat-Lagerstätte type dinosaur-bearing locality in Italy. The site is here critically re-evaluated as early Campanian in age, thus preceding the final fragmentation stages of the European Archipelago, including all other European localities preserving hypothesized dwarfed taxa. New skeletal remains allowed osteohistological analyses on the hadrosauroid Tethyshadros insularis indicating subadult features in the type specimen whereas a second, herein newly described, larger individual is likely somatically mature. A phylogenetic comparative framework places the body-size of T. insularis in range with other non-hadrosaurid Eurasian hadrosauroids, rejecting any significant evolutionary trend towards miniaturisation in this clade, confuting its ‘pygmy’ status, and providing unmatched data to infer environmentally-driven body-size trends in Mesozoic dinosaurs

Case-based learning. A formal approach to generate health case studies from electronic healthcare records

There is an increasing social pressure to train medical students with a level of competency sufficient to face clinical practice already at the end of their curriculum. The case-based learning (CBL) is an efficient teaching method to prepare students for clinical practice through the use of real or realistic clinical cases. In this regard, the Electronic Healthcare Record (EHR) could be a good source of real patient stories that can be transformed into educative cases. In this paper a formal approach to generate Health Case Studies from EHR is defined

Forebulge migration in the foreland basin system of the central-southern Apennine fold-thrust belt (Italy): New high-resolution Sr-isotope dating constraints

The Apennines are a retreating collisional belt where the foreland basin system, across large domains, is floored by a subaerial forebulge unconformity developed due to forebulge uplift and erosion. This unconformity is overlain by a diachronous sequence of three lithostratigraphic units made of (a) shallow-water carbonates, (b) hemipelagic marls and shales and (c) siliciclastic turbidites. Typically, the latter two have been interpreted regionally as the onset of syn-orogenic deposition in the foredeep depozone, whereas little attention has been given to the underlying unit. Accordingly, the rate of migration of the central-southern Apennine fold-thrust belt-foreland basin system has been constrained, so far, exclusively considering the age of the hemipelagites and turbidites, which largely post-date the onset of foredeep depozone. In this work, we provide new high-resolution ages obtained by strontium isotope stratigraphy applied to calcitic bivalve shells sampled at the base of the first syn-orogenic deposits overlying the Eocene-Cretaceous pre-orogenic substratum. Integration of our results with published data indicates progressive rejuvenation of the strata sealing the forebulge unconformity towards the outer portions of the fold-thrust belt. In particular, the age of the forebulge unconformity linearly scales with the pre-orogenic position of the analysed sites, pointing to an overall constant migration velocity of the forebulge wave in the last 25 Myr