A Novel Three-Point Modulation Technique for Fractional-N Frequency Synthesizer Applications

This paper presents a novel three-point modulation technique for fractional-N frequency synthesizer applications. Convention modulated fractional-N frequency synthesizers suffer from quantization noise, which degrades not only the phase noise performance but also the modulation quality. To solve this problem, this work proposes a three-point modulation technique, which not only cancels the quantization noise, but also markedly boosts the channel switching speed. Measurements reveal that the implemented 2.4 GHz fractional-N frequency synthesizer using three-point modulation can achieve a 2.5 Mbps GFSK data rate with an FSK error rate of only 1.4 %. The phase noise is approximately -98 dBc/Hz at a frequency offset of 100 kHz. The channel switching time is only 1.1 μs with a frequency step of 80 MHz. Comparing with conventional two-point modulation, the proposed three-point modulation greatly improves the FSK error rate, phase noise and channel switching time by about 10 %, 30 dB and 126 μs, respectively

Cracking pressure control of parylene checkvalve using slanted tensile tethers

MEMS check valves with fixed cracking pressures are important in micro-fluidic applications where the pressure, flow directions and flow rates all need to be carefully controlled. This work presents a new surface-micromachined parylene check valve that uses residual thermal stress in the parylene to control its cracking pressure. The new check valve uses slanted tethers to allow the parylene tensile stress to apply a net downward force on the valving seat against the orifice. The angle of the slanted tethers is made using a gray-scale mask to create a sloped sacrificial photoresist with the following tether parylene deposition. The resulted check valves have both the cracking pressures and flow profiles agreeable well with our theoretical analysis

Parylene stiction

This paper presents a preliminary study into stiction between parylene C and substrate surfaces for biocompatible check-valve applications. During fabrication, parylene C is used as the structural material for the check-valve. The substrate surfaces studied include Au, Al, Si, parylene C, XeF_2 treated Si, and silicon dioxide. Stiction between different surfaces is created after sacrificial photoresist etching. Then, the stiction is measured using blister tests, and stiction mechanisms for different materials are investigated. The devices are released with different recipes to examine their effects. Finally, the results of the study reveal methods to control the cracking pressure of parylene check-valves

Energy-Efficient Non-Orthogonal Transmission under Reliability and Finite Blocklength Constraints

This paper investigates an energy-efficient non-orthogonal transmission design problem for two downlink receivers that have strict reliability and finite blocklength (latency) constraints. The Shannon capacity formula widely used in traditional designs needs the assumption of infinite blocklength and thus is no longer appropriate. We adopt the newly finite blocklength coding capacity formula for explicitly specifying the trade-off between reliability and code blocklength. However, conventional successive interference cancellation (SIC) may become infeasible due to heterogeneous blocklengths. We thus consider several scenarios with different channel conditions and with/without SIC. By carefully examining the problem structure, we present in closed-form the optimal power and code blocklength for energy-efficient transmissions. Simulation results provide interesting insights into conditions for which non-orthogonal transmission is more energy efficient than the orthogonal transmission such as TDMA.Comment: accepted by IEEE GlobeCom workshop on URLLC, 201

Stiction of parylene C to silicon surface measured using blister tests

Micro-fabricated biocompatible check valves are integral parts of many implantable micro-fluidic devices. The cracking pressure of check valves is usually controlled by stiction between polymeric films and the underlying substrate. The following paper presents the first comprehensive study of stiction between parylene and silicon surfaces. The valves are fabricated using surface micromachining with parylene C as the structural material. Deep Reactive Ion Etching (DRIE) is used to create through holes in the wafer for the passage of fluids. Blister test is employed to calculate stiction. From experimental results, stiction between parylene C and silicon surfaces is found to be 2.59 J/m2, which is comparable to the stiction between silicon and other polymeric thin films

Minimally Invasive Parylene Dual-Valved Flow Drainage Shunt for Glaucoma Implant

A parylene-enabled microvalved shunt implant for glaucoma drainage is presented in this paper. Enabled by the dual-checkvalve operation, this device can physically drain the extra intraocular fluid and regulate the intraocular pressure (IOP) within the normal range (15-20 mmHg). Improved surgical features, in addition to the functional/microfluidic components, such as parylene-tube carrier and anchors, are also incorporated in such device to realize minimally invasive suture-less implantation, suitable for practical in vivo use. With the optimized micromachining and post-fabrication process procedures, the developed implant is the first checkvalved glaucoma drainage device (GDD), which is passive, consumes no additional power, and functions without any circuit involved to pursue its medical application

The small GTPase HRas shapes local PI3K signals through positive feedback and regulates persistent membrane extension in migrating fibroblasts

Self-amplification of phosphoinositide 3-kinase (PI3K) signaling is believed to regulate asymmetric membrane extension and cell migration, but the molecular organization of the underlying feedback circuit is elusive. Here we use an inducible approach to synthetically activate PI3K and interrogate the feedback circuitry governing self-enhancement of 3'-phosphoinositide (3-PI) signals in NIH3T3 fibroblasts. Synthetic activation of PI3K initially leads to uniform production of 3-PIs at the plasma membrane, followed by the appearance of asymmetric and highly amplified 3-PI signals. A detailed spatiotemporal analysis shows that local self-amplifying 3-PI signals drive rapid membrane extension with remarkable directional persistence and initiate a robust migratory response. This positive feedback loop is critically dependent on the small GTPase HRas. Silencing of HRas abrogates local amplification of 3-PI signals upon synthetic PI3K activation and results in short-lived protrusion events that do not support cell migration. Finally, our data indicate that this feedback circuit is likely to operate during platelet-derived growth factor-induced random cell migration. We conclude that positive feedback between PI3K and HRas is essential for fibroblasts to spontaneously self-organize and generate a productive migratory response in the absence of spatial cues

Pyrrolidinyl caffeamide against ischemia/reperfusion injury in cardiomyocytes through AMPK/AKT pathways

BACKGROUND: Coronary heart disease is a leading cause of death in the world and therapy to reduce injury is still needed. The uncoupling of glycolysis and glucose oxidation induces lactate accumulation during myocardial ischemia/reperfusion (I/R) injury. Cell death occurs and finally leads to myocardial infarction. Caffeic acid, one of the major phenolic constituents in nature, acts as an antioxidant. Pyrrolidinyl caffeamide (PLCA), a new derivative of caffeic acid, was synthesized by our team. We aimed to investigate the effect of PLCA on hypoxia/reoxygenation (H/R) in neonatal rat ventricular myocytes (NRVM) and on myocardial I/R in rats. RESULTS: Cardiomyocytes were isolated and subjected to 6 h hypoxia followed by 18 h reperfusion. PLCA (0.1 to 3 μM) and metformin (30 μM) were added before hypoxia was initiated. PLCA at 1 μM and metformin at 30 μM exerted similar effects on the improvement of cell viability and the alleviation of cell apoptosis in NRVM after H/R. PLCA promoted p-AMPK, p-AKT, and GLUT4 upregulation to induce a cardioprotective effect in both cell and animal model. The accumulation of cardiac lactate was attenuated by PLCA during myocardial I/R, and infarct size was smaller in rats treated with PLCA (1 mg/kg) than in those treated with caffeic acid (1 mg/kg). CONCLUSIONS: AMPK and AKT are synergistically activated by PLCA, which lead facilities glucose utilization, thereby attenuating lactate accumulation and cell death. The cardioprotective dose of PLCA was lower than those of metformin and caffeic acid. We provide a new insight into this potential drug for the treatment of myocardial I/R injury