374 research outputs found
Observation of longitudinal and transverse self-injections in laser-plasma accelerators
Laser-plasma accelerators can produce high quality electron beams, up to
giga-electronvolts in energy, from a centimeter scale device. The properties of
the electron beams and the accelerator stability are largely determined by the
injection stage of electrons into the accelerator. The simplest mechanism of
injection is self-injection, in which the wakefield is strong enough to trap
cold plasma electrons into the laser wake. The main drawback of this method is
its lack of shot-to-shot stability. Here we present experimental and numerical
results that demonstrate the existence of two different self-injection
mechanisms. Transverse self-injection is shown to lead to low stability and
poor quality electron beams, because of a strong dependence on the intensity
profile of the laser pulse. In contrast, longitudinal injection, which is
unambiguously observed for the first time, is shown to lead to much more stable
acceleration and higher quality electron beams.Comment: 7 pages, 7 figure
Angular momentum evolution in laser-plasma accelerators
The transverse properties of an electron beam are characterized by two
quantities, the emittance which indicates the electron beam extend in the phase
space and the angular momentum which allows for non-planar electron
trajectories. Whereas the emittance of electron beams produced in laser- plasma
accelerator has been measured in several experiments, their angular momentum
has been scarcely studied. It was demonstrated that electrons in laser-plasma
accelerator carry some angular momentum, but its origin was not established.
Here we identify one source of angular momentum growth and we present
experimental results showing that the angular momentum content evolves during
the acceleration
Betatron emission as a diagnostic for injection and acceleration mechanisms in laser-plasma accelerators
Betatron x-ray emission in laser-plasma accelerators is a promising compact
source that may be an alternative to conventional x-ray sources, based on large
scale machines. In addition to its potential as a source, precise measurements
of betatron emission can reveal crucial information about relativistic
laser-plasma interaction. We show that the emission length and the position of
the x-ray emission can be obtained by placing an aperture mask close to the
source, and by measuring the beam profile of the betatron x-ray radiation far
from the aperture mask. The position of the x-ray emission gives information on
plasma wave breaking and hence on the laser non-linear propagation. Moreover,
the measurement of the longitudinal extension helps one to determine whether
the acceleration is limited by pump depletion or dephasing effects. In the case
of multiple injections, it is used to retrieve unambiguously the position in
the plasma of each injection. This technique is also used to study how, in a
capillary discharge, the variations of the delay between the discharge and the
laser pulse affect the interaction. The study reveals that, for a delay
appropriate for laser guiding, the x-ray emission only occurs in the second
half of the capillary: no electrons are injected and accelerated in the first
half.Comment: 8 pages, 6 figures. arXiv admin note: text overlap with
arXiv:1104.245
Simplified open repair for anterior chest wall deformities. Analysis of results in 205 patients
SummaryIntroductionPectus deformities are the most frequently seen congenital thoracic wall anomalies. The cause of these conditions is thought to be abnormal elongation of the rib cartilages. We here report our clinical experience and the results of a sternochondroplasty procedure based on the subperichondrial resection of the elongated cartilages.HypothesisThis technique is a valuable surgical strategy to treat the wide variety of pectus deformities.Patients and methodsDuring the period from October 2001 through September 2009, 205 adult patients (171 men and 34 women) underwent pectus excavatum (181), carinatum (19) or arcuatum (5) repair. The patients’ pre and postoperative data were collected using a computerized database, and the results were assessed with a minimum 2-year follow-up.ResultsThe postoperative morbidity rate was minimal and the mortality was nil. The surgeon graded cosmetic results as excellent (72.5%), good (25%) or fair (2.5%), while patients reported better results. Patients with pectus excavatum were found to have much more patent foramen ovale (PFO) than the normal adult population, which occluded after the procedure in 61% of patients, and significant improvement was found in exercise cardiopulmonary function and exercise tolerance at the 1-year follow-up.DiscussionOur sternochondroplasty technique based on the subperichondrial resection of the elongated cartilages allows satisfactory repair of both pectus excavatum and sternal prominence. It is a safe procedure that might improve the effectiveness of surgical therapy in patients with pectus deformities.Level of evidenceLevel IV. Retrospective study
Bright betatron x-ray radiation from a laser-driven-clustering gas target
Hard X-ray sources from femtosecond (fs) laser-produced plasmas, including the betatron X-rays from laser wakefield-accelerated electrons, have compact sizes, fs pulse duration and fs pump-probe capability, making it promising for wide use in material and biological sciences. Currently the main problem with such betatron X-ray sources is the limited average flux even with ultra-intense laser pulses. Here, we report ultra-bright betatron X-rays can be generated using a clustering gas jet target irradiated with a small size laser, where a ten-fold enhancement of the X-ray yield is achieved compared to the results obtained using a gas target. We suggest the increased X-ray photon is due to the existence of clusters in the gas, which results in increased total electron charge trapped for acceleration and larger wiggling amplitudes during the acceleration. This observation opens a route to produce high betatron average flux using small but high repetition rate laser facilities for applications
Demonstration of the synchrotron-type spectrum of laser-produced Betatron radiation
Betatron X-ray radiation in laser-plasma accelerators is produced when
electrons are accelerated and wiggled in the laser-wakefield cavity. This
femtosecond source, producing intense X-ray beams in the multi kiloelectronvolt
range has been observed at different interaction regime using high power laser
from 10 to 100 TW. However, none of the spectral measurement performed were at
sufficient resolution, bandwidth and signal to noise ratio to precisely
determine the shape of spectra with a single laser shot in order to avoid shot
to shot fluctuations. In this letter, the Betatron radiation produced using a
80 TW laser is characterized by using a single photon counting method. We
measure in single shot spectra from 8 to 21 keV with a resolution better than
350 eV. The results obtained are in excellent agreement with theoretical
predictions and demonstrate the synchrotron type nature of this radiation
mechanism. The critical energy is found to be Ec = 5.6 \pm 1 keV for our
experimental conditions. In addition, the features of the source at this energy
range open novel perspectives for applications in time-resolved X-ray science.Comment: 5 pages, 4 figure
Single shot phase contrast imaging using laser-produced Betatron x-ray beams
Development of x-ray phase contrast imaging applications with a laboratory
scale source have been limited by the long exposure time needed to obtain one
image. We demonstrate, using the Betatron x-ray radiation produced when
electrons are accelerated and wiggled in the laser-wakefield cavity, that a
high quality phase contrast image of a complex object (here, a bee), located in
air, can be obtained with a single laser shot. The Betatron x-ray source used
in this proof of principle experiment has a source diameter of 1.7 microns and
produces a synchrotron spectrum with critical energy E_c=12.3 +- 2.5 keV and
10^9 photons per shot in the whole spectrum.Comment: 3 pages, 3 figure
Quasi-monoenergetic electron beams production in a sharp density transition
International audienceUsing a laser plasma accelerator, experiments with a 80 TW and 30 fs laser pulse demonstrated quasi-monoenergetic electron spectra with maximum energy over 0.4 GeV. This is achieved using a supersonic He gas jet and a sharp density ramp generated by a high intensity laser crossing pre-pulse focused 3 ns before the main laser pulse. By adjusting this crossing pre-pulse position inside the gas jet, among the laser shots with electron injection more than 40% can produce quasi-monoenergetic spectra. This could become a relatively straight forward technique to control laser wakefield electron beams parameters
- …