Time-Resolved Detection of Individual Electrons in a Quantum Dot

We present measurements on a quantum dot and a nearby, capacitively coupled, quantum point contact used as a charge detector. With the dot being weakly coupled to only a single reservoir, the transfer of individual electrons onto and off the dot can be observed in real time in the current signal from the quantum point contact. From these time-dependent traces, the quantum mechanical coupling between dot and reservoir can be extracted quantitatively. A similar analysis allows the determination of the occupation probability of the dot states.Comment: 3 pages, 3 figure

Finite bias charge detection in a quantum dot

We present finite bias measurements on a quantum dot coupled capacitively to a quantum point contact used as a charge detector. The transconductance signal measured in the quantum point contact at finite dot bias shows structure which allows us to determine the time-averaged charge on the dot in the non-blockaded regime and to estimate the coupling of the dot to the leads.Comment: 6 pages, 4 figure

In Situ Treatment of a Scanning Gate Microscopy Tip

In scanning gate microscopy, where the tip of a scanning force microscope is used as a movable gate to study electronic transport in nanostructures, the shape and magnitude of the tip-induced potential are important for the resolution and interpretation of the measurements. Contaminations picked up during topography scans may significantly alter this potential. We present an in situ high-field treatment of the tip that improves the tip-induced potential. A quantum dot was used to measure the tip-induced potential.Comment: 3 pages, 1 figure, minor changes to fit published versio

Thermally excited Trivelpiece–Gould modes as a pure electron plasma temperature diagnostic

Thermally excited plasma modes are observed in trapped, near-thermal-equilibrium pure electron plasmas over a temperature range of 0.05<kT<5 eV. The modes are excited and damped by thermal fluctuations in both the plasma and the receiver electronics. The thermal emission spectra together with a plasma-antenna coupling coefficient calibration uniquely determine the plasma (and load) temperature. This calibration is obtained from the mode spectra themselves when the receiver-generated noise absorption is measurable; or from separate wave reflection/absorption measurements; or from kinetic theory. This nondestructive temperature diagnostic agrees well with standard diagnostics, and may be useful for expensive species such as antimatter

Thermally excited fluctuations as a pure electron plasma temperature diagnostic

Thermally excited charge fluctuations in pure electron plasma columns provide a diagnostic for the plasma temperature over a range of 0.05 0.2, so that Landau damping is dominant and well modeled by theory. The third method compares the total (frequency-integrated) number delta N of fluctuating image charges on the wall antenna to a simple thermodynamic calculation. This method works when lambda(D)/R-p > 0.2

Evaluation of ERTS-1 data for inventory of forest and rangeland and detection of forest stress

The author has identified the following significant results. Results of photointerpretation indicated that ERTS is a good classifier of forest and nonforest lands (90 to 95 percent accurate). Photointerpreters could make this separation as accurately as signature analysis of the computer compatible tapes. Further breakdowns of cover types at each site could not be accurately classified by interpreters (60 percent) or computer analysts (74 percent). Exceptions were water, wet meadow, and coniferous stands. At no time could the large bark beetle infestations (many over 300 meters in size) be detected on ERTS images. The ERTS wavebands are too broad to distinguish the yellow, yellow-red, and red colors of the dying pine foliage from healthy green-yellow foliage. Forest disturbances could be detected on ERTS color composites about 90 percent of the time when compared with six-year-old photo index mosaics. ERTS enlargements (1:125,000 scale, preferably color prints) would be useful to forest managers of large ownerships over 5,000 hectares (12,500 acres) for broad area planning. Black-and-white enlargements can be used effectively as aerial navigation aids for precision aerial photography where maps are old or not available

Two-subband quantum Hall effect in parabolic quantum wells

The low-temperature magnetoresistance of parabolic quantum wells displays pronounced minima between integer filling factors. Concomitantly the Hall effect exhibits overshoots and plateau-like features next to well-defined ordinary quantum Hall plateaus. These effects set in with the occupation of the second subband. We discuss our observations in the context of single-particle Landau fan charts of a two-subband system empirically extended by a density dependent subband separation and an enhanced spin-splitting g*.Comment: 5 pages, submitte

Imaging a Coupled Quantum Dot - Quantum Point Contact System

We performed measurements on a quantum dot and a capacitively coupled quantum point contact by using the sharp metallic tip of a low-temperature scanning force microscope as a scanned gate. The quantum point contact served as a detector for charges on the dot or nearby. It allowed us to distinguish single electron charging events in several charge traps from charging events on the dot. We analyzed the tip-induced potential quantitatively and found its shape to be independent of the voltage applied to the tip within a certain range of parameters. We estimate that the trap density is below 0.1% of the doping density and that the interaction energy between the quantum dot and a trap is a significant portion of the dot's charging energy. Possibly, such charge traps are the reason for frequently observed parametric charge rearrangements.Comment: 6 pages, 5 figure

Measurement of the Tip-Induced Potential in Scanning Gate Experiments

We present a detailed experimental study on the electrostatic interaction between a quantum dot and the metallic tip of a scanning force microscope. Our method allowed us to quantitatively map the tip-induced potential and to determine the spatial dependence of the tip's lever arm with high resolution. We find that two parts of the tip-induced potential can be distinguished, one that depends on the voltage applied to the tip and one that is independent of this voltage. The first part is due to the metallic tip while we interpret the second part as the effect of a charged dielectric particle on the tip. In the measurements of the lever arm we find fine structure that depends on which quantum state we study. The results are discussed in view of scanning gate experiments where the tip is used as a movable gate to study nanostructures.Comment: 7 pages, 5 figures, minor changes to fit published versio

Thermal excitation of Trivelpiece-Gould modes in a pure electron plasma

Thermally excited plasma modes are observed in trapped, near-thermal-equilibrium pure electron plasmas over a temperature range of 0.05<T<5 eV. The measured thermal emission spectra together with a separate measurement of the wave absorption coefficient uniquely determines the temperature. Alternately, kinetic theory including the antenna geometry and the measured mode damping (i.e. spectral width) gives the plasma impedance, obviating the reflection measurement. This non-destructive temperature diagnostic agrees well with standard diagnostics, and may be useful for expensive species such as anti-matter