234 research outputs found
Preparation of Knill-Laflamme-Milburn states using tunable controlled phase gate
A specific class of partially entangled states known as
Knill-Laflamme-Milburn states (or KLM states) has been proved to be useful in
relation to quantum information processing [Knill et al., Nature 409, 46
(2001)]. Although the usage of such states is widely investigated, considerably
less effort has been invested into experimentally accessible preparation
schemes. This paper discusses the possibility to employ a tunable controlled
phase gate to generate an arbitrary Knill-Laflamme-Milburn state. In the first
part, the idea of using the controlled phase gate is explained on the case of
two-qubit KLM states. Optimization of the proposed scheme is then discussed for
the framework of linear optics. Subsequent generalization of the scheme to
arbitrary n-qubit KLM state is derived in the second part of this paper.Comment: 5 pages, 4 figures, accepted in Journal of Physics
Mesoscopic superpositions of vibronic collective states of N trapped ions
We propose a scalable procedure to generate entangled superpositions of
motional coherent states and electronic states in N trapped ions. Beyond their
fundamental importance, these states may be of interest for quantum information
processing and may be used in experimental studies of decoherence.Comment: Final version, as published in Physical Review Letters. See also
further developments and applications in quant-ph/020207
Multiplexed gas spectroscopy using tunable VCSELs
Detection and identification of gas species using tunable laser diode laser absorption spectroscopy has been performed using vertical cavity surface emitting lasers (VCSEL). Two detection methods are compared: direct absorbance and wavelength modulation spectroscopy (WMS). In the first, the output of a DC-based laser is directly monitored to detect for any quench at the targeted specie wavelength. In the latter, the emission wavelength of the laser is modulated by applying a sinusoidal component on the drive current of frequency {omega}, and measuring the harmonics component (2{omega}) of the photo-detected current. This method shows a better sensitivity measured as signal to noise ratio, and is less susceptible to interference effects such as scattering or fouling. Gas detection was initially performed at room temperature and atmospheric conditions using VCSELs of emission wavelength 763 nm for oxygen and 1392 nm for water, scanning over a range of approximately 10 nm, sufficient to cover 5-10 gas specific absorption lines that enable identification and quantization of gas composition. The amplitude and frequency modulation parameters were optimized for each detected gas species, by performing two dimensional sweeps for both tuning current and either amplitude or frequency, respectively. We found that the highest detected signal is observed for a wavelength modulation amplitude equal to the width of the gas absorbance lines, in good agreement with theoretical calculations, and for modulation frequencies below the time response of the lasers (<50KHz). In conclusion, we will discuss limit of detection studies and further implementation and packaging of VCSELs in diode arrays for continuous and simultaneous monitoring of multiple species in gaseous mixtures
Spin Transport in a Quantum Wire
We study the effect of electron-electron backscattering interactions on spin
transport in a quantum wire. Even if these interactions have no significant
effect on charge transport, they strongly influence the transport of spin. We
use the quantum Boltzmann equation in the collision approximation to derive
equations of motion for spin current and magnetization. In the limit of small
perturbations from equilibrium, we explain the existence of `precessional' and
`diffusive' behaviors. We also discuss the low-temperature non-linear decay of
an uniform spin current outside the hydrodynamic regime.Comment: 10 pages, 5 figures, REVTE
Coherent state quantization of a particle in de Sitter space
We present a coherent state quantization of the dynamics of a relativistic
test particle on a one-sheet hyperboloid embedded in a three-dimensional
Minkowski space. The group SO_0(1,2) is considered to be the symmetry group of
the system. Our procedure relies on the choice of coherent states of the motion
on a circle. The coherent state realization of the principal series
representation of SO_0(1,2) seems to be a new result.Comment: Journal of Physics A: Mathematical and General, vol. 37, in pres
Scalar field "mini--MACHOs": a new explanation for galactic dark matter
We examine the possibility that galactic halos are collisionless ensembles of
scalar field ``massive compact halo objects'' (MACHOs). Using mass constraints
from MACHO microlensing and from theoretical arguments on halos made up of
massive black holes, as well as demanding also that scalar MACHO ensambles of
all scales do not exhibit gravothermal instability (as required by consistency
with observations of LSB galaxies), we obtain the range: m\alt 10^{-7}
M_\odot or 30 M_\odot\alt m\alt 100 M_\odot. The rather narrow mass range of
large MACHOs seems to indicate that the ensambles we are suggesting should be
probably made up of scalar MACHOs in the low mass range (``mini--MACHOs''). The
proposed model allows one to consider a non--baryonic and non--thermal
fundamental nature of dark matter, while at the same time keeping the same
phenomenology of the CDM paradigm.Comment: 5 pages, 1 eps figure. RevTex 4 style. To appear in Physical Review
A dimensioning and tolerancing methodology for concurrent engineering applications I: problem representation
This paper is the first of two which present a methodology for determining the dimensional specifications of all the component parts and sub-assemblies of a product according to their dimensional requirements. To achieve this goal, two major steps are followed, each of which is described in a paper. In the first paper, all relationships necessary for finding the values of dimensions and tolerances are represented in a matrix form, known as a Dimensional Requirements/Dimensions (DR/D) matrix. In the second paper, the values of individual dimensions and tolerances are determined by applying a comprehensive solution strategy to satisfy all the relationships represented in the DR/D matrix. The methodology is interactive and suitable for use in a concurrent engineering (CE) environment. The graphical tool presented in this paper will assist a CE team in visualizing the overall D&T problem and foreseeing the ramifications of decisions regarding the selection of dimensions and tolerances. This will assist the CE team to systematically determine all the controllable variables, such as dimensions, tolerances, and manufacturing processes
Detection of codon 12 K- ras mutations in non-neoplastic mucosa from bronchial carina in patients with lung adenocarcinomas
K- ras activation by point mutation in codon 12 has been reported in lung adenocarcinomas in various models of experimental lung tumours induced by chemical carcinogens. The hypothesis of the presence of cells containing K- ras mutation in non neoplastic bronchial carina, the main site of impaction of airborne contaminants, was investigated by evaluating concurrent lung tumour and non-neoplastic proximal bronchial carinae from 19 patients with lung adenocarcinomas. The restriction fragment length polymorphism enriched PCR method used can detect one mutant allele among 103normal alleles. A mutation was detected in 42% of lung adenocarcinoma samples. No mutation was detected in either tumour or bronchial carinae in nine patients (47%). K- ras mutation was detected in the lung tumour but not in bronchial carinae in four patients (21%), in both the lung tumour and bronchial carinae in four other patients (21%). In two patients (11%), K- ras mutation was detected in at least one bronchial carina, but not in the lung tumour. Mutations of codon 12, confirmed by sequencing analysis of ten samples, were G to T transversion, mostly TGT and GTT in bronchial carinae and lung tumours. Our data show that activated K- ras by point mutation can be present in non-neoplastic bronchial carina mucosa even when no mutation is detected in tumour samples. © 2000 Cancer Research Campaig
Fabrication and in vitro deployment of a laser-activated shape memory polymer vascular stent
<p>Abstract</p> <p>Background</p> <p>Vascular stents are small tubular scaffolds used in the treatment of arterial stenosis (narrowing of the vessel). Most vascular stents are metallic and are deployed either by balloon expansion or by self-expansion. A shape memory polymer (SMP) stent may enhance flexibility, compliance, and drug elution compared to its current metallic counterparts. The purpose of this study was to describe the fabrication of a laser-activated SMP stent and demonstrate photothermal expansion of the stent in an <it>in vitro </it>artery model.</p> <p>Methods</p> <p>A novel SMP stent was fabricated from thermoplastic polyurethane. A solid SMP tube formed by dip coating a stainless steel pin was laser-etched to create the mesh pattern of the finished stent. The stent was crimped over a fiber-optic cylindrical light diffuser coupled to an infrared diode laser. Photothermal actuation of the stent was performed in a water-filled mock artery.</p> <p>Results</p> <p>At a physiological flow rate, the stent did not fully expand at the maximum laser power (8.6 W) due to convective cooling. However, under zero flow, simulating the technique of endovascular flow occlusion, complete laser actuation was achieved in the mock artery at a laser power of ~8 W.</p> <p>Conclusion</p> <p>We have shown the design and fabrication of an SMP stent and a means of light delivery for photothermal actuation. Though further studies are required to optimize the device and assess thermal tissue damage, photothermal actuation of the SMP stent was demonstrated.</p
Chlorophyll and carbohydrates in Arachis pintoi plants under influence of water regimes and nitrogen fertilization
- …