123 research outputs found
Seismic anisotropy and shear-wave splitting in lower-crustal and upper-mantle rocks from the Ivrea Zone : experimental and calculated data
International audienceTo quantify the relationships between anisotropy. S-wave splitting and tectonics, we determined the seismic properties of lower-crustal and upper-mantle rocks outcropping in the lvrea Zone (Northem Italy). We obtained P-and S-wave seismic velocities by laboratory direct velocity measurements and/or by calculations based on the modal compositions of the rocks, the lattice preferred orientations (LPOs), and the single crystal stiffness coefficients. Measured P-and S-wave velocities (6.0-7 .5 km s-1 and 3.6-4.2 km s-1) are typical of the lower crust. The P-wave anisotropy is in the range 0-l 0%. Shear-wave birefringence is in the range 0.0-0.6 km s-1 , with typical values between 0.0 and 0.2 km s-1 • In many cases, the birefringence is clearly related to fabric elements (foliation, lineation). Mafic rocks such as anorthosite or pyroxene-bearing gabbros exhibit low P-wave anisotropies (< 5%) and low shear-wave birefringences (less than 0.1 km s-1). In contrast, the seismic properties of felsic rocks such as biotite-bearing gneisses and mafic rocks such as amphibolites display high V P anisotropy (10%) and strong birefringence (0.3 km s-1). Biotite and amphibole preferred orientations clearly control seismic anisotropy and particularly shear-wave splitting. In these rocks, maximum splitting is observed in directions parallel to the foliation with the fast split shear wave polarized parallel to the foliation plane. To have an overview of the seismic properties of this lower-crustal section at a broader scale, we calculated from our data the anisotropie seismic properties of several hypothetical samples that are perhaps more representative of the regional anisotropy than each sample individually. For instance, the average lower-crustal sample displays an anisotropy of 5.5% for P waves and a birefringence around 0.14 km s I for S waves propagating parallel to the foliation. We observe little splitting for waves propagating at high angle to the foliation
Seismic anisotropy, structures and geodynamics of continents Shear-wave splitting in the Appalachians and the Pyrenees: importance of the inherited tectonic fabric of the lithosphere
International audienceSplitting of teleseismic shear waves has been measured in the Appalachians (eastern USA) and the Pyrenees (western Europe) using data recorded by permanent and portable stations. From a comparison of the results, it appears that an interpretation of the recorded seismic anisotropy in terms of geodynamics is not straightforward. Successive geodynamic events have generated structures that may have resulted in a similar pattern of mantle flow and that therefore may have contributed in the development of the recorded anisotropy. Combining geological and geophysical arguments, it appears that the mantle anisotropy measured across the Appalachians and the Pyrenees may not be systematically Appalachian or Pyrenean in age but may be mainly due to a lithospheric structure formed during earlier major tectonic events, i.e. the Grenvillian and the Hercynian orogenies, respectively. We suggest that during major episodes of continent assembly, a pervasive tectonic fabric is developed in the lithospheric mantle. In the subsequent evolution of the continent, this fabric may induce a significant mechanical anisotropy that will drastically influence the mechanical behaviour of the Iithosphere when submitted to new tectonic events
Mantle flow beneath La RĂ©union hotspot track from SKS splitting
International audienceIf upper mantle anisotropy beneath fast-moving oceanic plates is expected to align the fast azimuths close to the plate motion directions, the upper mantle flow pattern beneath slow-moving oceanic plates will reflect the relative motion between the moving plate and the underlying large-scale convecting mantle. In addition to the non-correlation of the fast azimuths with the plate motion direction, the flow and anisotropy pattern may be locally perturbed by other factors such as the upwelling and the sublithospheric spreading of mantle plumes. Investigating such plume–lithosphere interaction is strongly dependent on the available seismological data, which are generally sparse in oceanic environment. In this study, we take the opportunity of recent temporary deployments of 15 seismic stations and 5 permanent stations on the Piton de la Fournaise volcano, the active locus of La Ré union hotspot and of 6 permanent stations installed along or close to its fossil track of about 3700 km in length, to analyze azimuthal anisotropy detected by SKS wave splitting and to decipher the various possible origins of anisotropy beneath the Western Indian Ocean. From about 150 good and fair splitting measurements and more than 1000 null splitting measurements, we attempt to distinguish between the influence of a local plume signature and large-scale mantle flow. The large-scale anisotropy pattern obtained at the SW-Indian Ocean island stations is well explained by plate motion relative to the deep mantle circulation. By contrast, stations on La Ré union Island show a complex signature characterized by numerous ''nulls'' and by fast split shear wave polarizations trending normal to the plate motion direction and obtained within a small backazimuthal window, that cannot be explained by either a single or two anisotropic layers. Despite the sparse spatial coverage which precludes a unique answer, we show that such pattern may be compatible with a simple model of sublithospheric spreading of La Ré union plume characterized by a conduit located at 100–200 km north of La Ré union Island. Anisotropy beneath the new GEOSCOPE station in Rodrigues Island does not appear to be influenced by La Ré union plume-spreading signature but is fully compatible with either a model of large-scale deep mantle convection pattern and/or with a channeled asthenospheric flow beneath the Rodrigues ridge.
Upper mantle anisotropy beneath the African IRIS and Geoscope stations
International audienceUpper mantle anisotropy beneath the African IRIS and Geoscope stations is investigated through the measurements of splitting of teleseismic shear waves such as SKS, SKKS and PKS phases. Seismic anisotropy data are interesting on their own as a measure of upper mantle active or frozen deformation beneath a given station, but each station is of potential interest since it can be used to retrieve source-side seismic anisotropy at remote sites if one is able to perform station-side anisotropy correction. We performed systematic investigations of teleseismic shear wave splitting at 15 stations from the IRIS and Geoscope global seismic networks, which are located on both the oceanic and the continental parts of the African plate. Anisotropy is generally well observed at continental stations. The patterns we present generally show much more complexity than the results previously published from smaller data sets. Despite this complexity, the splitting parameters generally appear in several places to contain a signature of the regional geodynamic setting (rift structures, Archaean craton, Pan-African belt), although a deeper source of anisotropy (asthenospheric) may be present. At the oceanic stations, anisotropy measurements are much more difficult to perform because the signal is generally of poor quality. MSEY, in the Seychelles (Indian ocean), is the exception and displays a clear correlation of the azimuth of the fast split shear wave with the trend of the absolute plate motion, as defined by hotspot tracks
Rheological heterogeneity, mechanical anisotropy and deformation of the continental lithosphere
International audienceThis paper aims to present an overview on the influence of rheological heterogeneity and mechanical anisotropy on the deformation of continents. After briefly recapping the concept of rheological stratification of the lithosphere, we discuss two specific issues: (1) as supported by a growing body of geophysical and geological observations, crust=mantle mechanical coupling is usually efficient, especially beneath major transcurrent faults which probably crosscut the lithosphere and root within the sublithospheric mantle; and (2) in most geodynamic environments, mechanical properties of the mantle govern the tectonic behaviour of the lithosphere. Lateral rheological heterogeneity of the continental lithosphere may result from various sources, with variations in geothermal gradient being the principal one. The oldest domains of continents, the cratonic nuclei, are characterized by a relatively cold, thick, and consequently stiff lithosphere. On the other hand, rifting may also modify the thermal structure of the lithosphere. Depending on the relative stretching of the crust and upper mantle, a stiff or a weak heterogeneity may develop. Observations from rift domains suggest that rifting usually results in a larger thinning of the lithospheric mantle than of the crust, and therefore tends to generate a weak heterogeneity. Numerical models show that during continental collision, the presence of both stiff and weak rheological heterogeneities significantly influences the large-scale deformation of the continental lithosphere. They especially favour the development of lithospheric-scale strike-slip faults, which allow strain to be transferred between the heterogeneities. An heterogeneous strain partition occurs: cratons largely escape deformation, and strain tends to localize within or at the boundary of the rift basins provided compressional deformation starts before the thermal heterogeneity induced by rifting are compensated. Seismic and electrical conductivity anisotropies consistently point towards the existence of a coherent fabric in the lithospheric mantle beneath continental domains. Analysis of naturally deformed peridotites, experimental deformations and numerical simulations suggest that this fabric is developed during orogenic events and subsequently frozen in the lithospheric mantle. Because the mechanical properties of single-crystal olivine are anisotropic, i.e. dependent on the orientation of the applied forces relative to the dominant slip systems, a pervasive fabric frozen in the mantle may induce a significant mechanical anisotropy of the whole lithospheric mantle. It is suggested that this mechanical anisotropy is the source of the so-called tectonic inheritance, i.e. the systematic reactivation of ancient tectonic directions; it may especially explain preferential rift propagation and continental break-up along pre-existing orogenic belts. Thus, the deformation of continents during orogenic events results from a trade-off between tectonic forces applied at plate boundaries, plate geometry, and the intrinsic properties (rheological heterogeneity and mechanical anisotropy) of the continental plates
Why do continents break-up parallel to ancient orogenic belts?
International audienceThe frequently observed parallelism between rifts and the pre existing orogenic fabric of continents suggests that the inherited tectonic fabric of the lithosphere influences the rupture of continents. We propose that the existence of a pervasive fabric in the lithospheric mantle induces an anisotropie strength in the lithosphere, that guides the propagation of continental rifts. Subcrustal mantle mechanical anisotropy is supported by (i) the anisotropie strength of olivine, (ii) an ubiquitous tectonic fabric in exposed mantle rocks, and (iii) measurements of seismic and electrical anisotropy. During major episodes of continent Rifting parallel to orogenic belts Ocean-opening through rifting and continent break-up is frequently related to the occurrence ofhotspots. There is, howevcr, a discrepancy between hot spots acting as pin point sources of heat and the linear extent of rifts over thou sands ofkilometres. Moreover rifts tend to parallel pre-existing orogenic fab
Evidence for ancient lithospheric deformation in the East European Craton based on mantle seismic anisotropy and crustal magnetics
International audienceWe present new shear-wave splitting measurements performed at 16 stations on the East European Craton, and discuss their implications in terms of upper-mantle anisotropy for this geophysically poorly-known region. Previous investigations of mantle anisotropy in Central Europe have shown fast directions aligning smoothly with the craton's margin and various suggestions have been proposed to explain their origin such as asthenospheric flow or lithospheric frozen-in deformation.;Here, we aim at investigating the continuation of this shear-wave splitting pattern further to the East, into the East European Craton For the craton, the interpretation appears to be less ambiguous than for central Europe since several arguments support lithospheric anisotropy in this region 1) The large-scale coherence within either of the four constituting blocks and the significant variations between the blocks on a small-scale, 2) the weak correlation with absolute plate motion vectors, and 3) the good correlation between anisotropy and crustal features, for which we use magnetic field alignments as a proxy. Rattler good correlation of these magnetic features with seismic fast orientations strongly supports the idea of vertically coherent deformation throughout upper mantle and crust. The observed splitting orientations thus reflect the last tectonic events of each block. frozen-in into the lithosphere for hundreds of millions of year
Upper mantle deformation beneath the North American–Pacific plate boundary in California from SKS splitting
International audienceIn order to constrain the vertical and lateral extent of deformation and the interactions between lithosphere and asthenosphere in a context of a transpressional plate boundary, we performed teleseismic shear wave splitting measurements for 65 permanent and temporary broadband stations in central California. We present evidence for the presence of two anisotropic domains: (1) one with clear E–W trending fast directions and delay times in the range 1.5 to 2.0 s and (2) the other closely associated with the San Andreas Fault system with large azimuthal variations of the splitting parameters that can be modeled by two anisotropic layers. The upper of the two layers provides fast directions close to the strike of the main Californian faults and averaged delay times of 0.7 s; the lower layers show E–W directions and delay times in the range 1.5 to 2.5 s and thus can be compared to what is observed in stations that require a single layer. We propose the E–W trending anisotropic layer to be a 150 to 200 km thick asthenospheric layer explained by the shearing associated with the absolute plate motion of the North American lithosphere. The shallower anisotropic layer ought to be related to the dynamics of the San Andreas Fault system and thus characterized by a vertical foliation with lineation parallel to the strike of the faults localized in the lithosphere. We also propose that the anisotropic layer associated with each fault of the San Andreas Fault system is about 40 km wide at the base of the lithosphere
The Kaapvaal craton seismic anisotropy: Petrophysical analyses of upper mantle kimberlite nodules
International audienceA dense network of seismic stations has been deployed on the Kaapvaal craton (South Africa) to investigate the upper mantle seismic structures. In order to bring independent petrophysical constraints, we analyze a direct sampling of the cratonic upper mantle and determine the seismic properties of 48 mantle nodules brought up to the Earth's surface by kimberlite eruptions. Seismic properties of these nodules are calculated from the olivine and pyroxene crystal preferred orientations and the single crystal elastic constants. Despite variations in the nodules compositions, microstructures and crystallographic preferred orientations, seismic anisotropy is rather homogeneous throughout the craton. Mean S-wave anisotropy is weak (2.64 %), which is compatible with the small measured SKS wave splitting (mean delay time of 0.62 s)
SplitLab: A shear-wave splitting environment in Matlab
International audienceWe present a graphical user interface to facilitate the processing of teleseismic shear-wave splitting observations. In contrast to a fully automated technique, we present a manual, per-event approach that maintains user control during the sequence of processing. The SplitLab environment is intended to undertake the repetitive processing steps while enabling the user to focus on quality control and eventually the interpretation of the results. Pre-processing modules of SplitLab create a database of events and link the corresponding seismogram files. The seismogram viewer tool uses this database to perform the measurement interactively. Post-processing of the combined results of such a project includes a viewer and export option. Our emphasis lies in the application to teleseismic shear-wave splitting analysis, but our code can be extended easily for other purposes. SplitLab can be downloaded at http://www.gm.univ-montp2.fr/splitting/
- …