Vanadium microalloyed steel for thin slab casting and direct rolling

Vanadium microalloyed steels with high yield strength (»600 MPa), good toughness and ductility have been successfully produced in commercial thin slab casting plants employing direct rolling after casting. Because of the high solubility of VN and VC, most of the vanadium is likely to remain in solution during casting, equalisation and rolling. While some vanadium is precipitated in austenite as cuboids and pins the grain boundaries, a major fraction is available for dispersion strengthening of ferrite. Despite a coarse as-cast grain size, significant grain refinement can be achieved by repeated recrystallisation during hot rolling. Consequently, a fine and uniform ferrite grain structure is produced in the final strip. Increasing the V and N levels increases dispersion strengthening which occurs together with a finer ferrite grain size. The addition of titanium to a vanadium containing steel, decreases the yield strength due to the formation of V-Ti(N) particles in austenite during both casting and equalisation These large particles reduced the amount of V and N available for subsequent precipitation of fine (~5nm) V rich dispersion strengthening particles in ferrite

Dispersion strengthening in vanadium microalloyed steels processed by simulated thin slab casting and direct charging: Part I - Processing parameters, mechanical properties and microstructure

A study simulating thin slab continuous casting followed by direct charging into an equalisation furnace has been undertaken based on six low carbon (0.06wt-%) vanadium microalloyed steels. Mechanical and impact test data showed properties were similar or better than those obtained from similar microalloyed conventional thick cast as rolled slabs. The dispersion plus dislocation strengthening was estimated to be in the range 80-250MPa.A detailed TEM/EELS analysis of the dispersion sized sub-15nm particles showed that in all the steels, they were essentially nitrides with little crystalline carbon detected. In the Steels V-Nb, V-Ti and V-Nb-Ti, mixed transition metal nitrides were present. Modelling of equilibrium precipitates in these steels, based on a modified version of ChemSage, predicted that only vanadium rich nitrides would precipitate in austenite but that the C/N ratio would increase through the two phase field and in ferrite. The experimental analytical data clearly points to the thin slab direct charging process, which has substantially higher cooling rates than conventional casting, nucleating non-equilibrium particles in ferrite which are close to stoichiometric nitrides. These did not coarsen during the final stages of processing, but retained their highly stable average size of ~7nm resulting in substantial dispersion strengthening. The results are considered in conjunction with pertinent published literature

Studies on Monitoring and Tracking Genetic Resources: An Executive Summary

The principles underlying fair and equitable sharing of benefits derived from the utilization of genetic resources are set out in Article 15 of the UN Convention on Biological Diversity, which stipulate that access to genetic resources is subject to the prior informed consent of the country where such resources are located and to mutually agreed terms regarding the sharing of benefits that could be derived from such access. One issue of particular concern for provider countries is how to monitor and track genetic resources once they have left the provider country and enter into use in a variety of forms. This report was commissioned to provide a detailed review of advances in DNA sequencing technologies, as those methods apply to identification of genetic resources, and the use of globally unique persistent identifiers for persistently linking to data and other forms of digital documentation that is linked to individual genetic resources. While the report was written for an audience with a mixture of technical, legal, and policy backgrounds it is relevant to the genomics community as it is an example of downstream application of genomics information

Tricritical Behavior of Two-Dimensional Scalar Field Theories

We compute by Monte Carlo numerical simulations the critical exponents of two-dimensional scalar field theories at the $\lambda\phi^6$ tricritical point. The results are in agreement with the Zamolodchikov conjecture based on conformal invariance.Comment: 13 pages, uuencode tar-compressed Postscript file, preprint numbers: IF/UFRJ/25/94, DFTUZ 94.06 and NYU--TH--94/10/0

Instream and riparian implications of weed cutting in a chalk river

Macrophyte growth is extensive in the iconic chalk streams that are concentrated in southern and eastern England. Widespread and frequent weed cutting is undertaken to maintain their key functions (e.g. flood water conveyance and maintenance of viable fisheries). In this study, a multidisciplinary approach was adopted to quantify coincident physico-chemical responses (instream and riparian) that result from weed cutting and to discuss their potential implications. Three weed cuts were monitored at a site on the River Lambourn (The CEH River Lambourn Observatory) and major instream and riparian impacts were observed. Measurements clearly demonstrated how weed cutting enhanced flood flow conveyance, reduced water levels (river and wetland), increased river velocities, and mobilised suspended sediment (with associated chemicals) and reduced the capacity for its retention within the river channel. Potential implications in relation to flood risk, water resources, downstream water quality, instream and riparian ecology, amenity value of the river, and wetland greenhouse gas emissions were considered. Provided the major influence of macrophytes on instream and riparian environments is fully understood then the manipulation of macrophytes represents an effective management tool that demonstrates the great potential of working with nature

Calcium-Mediated Protein Folding and Stabilisation of Salmonella Biofilm-Associated Protein a

Biofilm-associated proteins (BAPs) are important for early biofilm formation (adhesion) by bacteria and are also found in mature biofilms. BapA from Salmonella is a ~386 kDa surface protein, comprised of 27 tandem repeats predicted to be bacterial Ig-like (BIg) domains. Such tandem repeats are conserved for BAPs across different bacterial species, but the function of these domains is not completely understood. In this work, we report the first study of the mechanical stability of the BapA protein. Using magnetic tweezers, we show that the folding of BapA BIg domains requires calcium- binding and the folded domains have differential mechanical stabilities. Importantly, we identify that >100 nM concentration of calcium is needed for folding of the BIg domains, and the stability of the folded BIg domains is regulated by calcium over a wide concentration range from sub-micromolar (?M) to millimolar (mM). Only at mM calcium concentrations, as found in the extracellular environment, do the BIg domains have the saturated mechanical stability. BapA has been suggested to be involved in Salmonella invasion, and it is likely a crucial mechanical component of biofilms. Therefore, our results provide new insights into the potential roles of BapA as a structural maintenance component of Salmonella biofilm and also Salmonella invasion

Large internal waves in Massachusetts Bay transport sediments offshore

This paper is not subject to U.S. copyright. The definitive version was published in Continental Shelf Research 26 (2006): 2029-2049, doi:10.1016/j.csr.2006.07.022.A field experiment was carried out in Massachusetts Bay in August 1998 to assess the role of large-amplitude internal waves (LIWs) in resuspending bottom sediments. The field experiment consisted of a four-element moored array extending from just west of Stellwagen Bank (90-m water depth) across Stellwagen Basin (85- and 50-m water depth) to the coast (24-m water depth). The LIWs were observed in packets of 5–10 waves, had periods of 5–10 min and wavelengths of 200–400 m, and caused downward excursions of the thermocline of as much as 30 m. At the 85-m site, the current measured 1 m above bottom (mab) typically increased from near 0 to 0.2 m/s offshore in a few minutes upon arrival of the LIWs. At the 50-m site, the near-bottom offshore flow measured 6 mab increased from about 0.1 to 0.4–0.6 m/s upon arrival of the LIWs and remained offshore in the bottom layer for 1–2 h. The near-bottom currents associated with the LIWs, in concert with the tidal currents, were directed offshore and sufficient to resuspend the bottom sediments at both the 50- and 85-m sites. When LIWs are present, they may resuspend sediments for as long as 5 hours each tidal cycle as they travel westward across Stellwagen Basin. At 85-m water depth, resuspension associated with LIWs is estimated to occur for about 0.4 days each summer, about the same amount of time as caused by surface waves.MBIWE98 was supported by the USGS and the Office of Naval Research (ONR). The long-term observations at LT-A and LT-B were conducted under a Joint Funding Agreement between the USGS and the Massachusetts Water Resources Authority and an Inter-Service Agreement with the US Coast Guard. A. Scotti received support from the WHOI Postdoctoral Scholar program, the Johnson Foundation, the USGS, and ONR through grant N00014-01-1-0172; R. Beardsley through ONR grants N00014-98-1-0059, N00014-00-1-0210 and the WHOI Smith Chair in Coastal Physical Oceanography; and S. Anderson through ONR grant N000140-97-1-0158