Thermomechanical modelling of laser surface glazing for H13 tool steel

A two-dimensional thermomechanical finite element (FE) model of laser surface glazing (LSG) has been developed for H13 tool steel. The direct coupling technique of ANSYS 17.2 (APDL) has been utilised to solve the transient thermomechanical process. A H13 tool steel cylindrical cross-section has been modelled for laser power 200 W and 300 W at constant 0.2 mm beam width and 0.15 ms residence time. The model can predict temperature distribution, stress–strain increments in elastic and plastic region with time and space. The crack formation tendency also can be assumed by analysing the von Mises stress in the heat-concentrated zone. Isotropic and kinematic hardening models have been applied separately to predict the after-yield phenomena. At 200 W laser power, the peak surface temperature achieved is 1520 K which is below the melting point (1727 K) of H13 tool steel. For laser power 300 W, the peak surface temperature is 2523 K. Tensile residual stresses on surface have been found after cooling, which are in agreement with literature. Isotropic model shows higher residual stress that increases with laser power. Conversely, kinematic model gives lower residual stress which decreases with laser power. Therefore, both plasticity models could work in LSG for H13 tool steel

Investigation of recast and crack formation in laser trepanning drilling of CMSX-4 angled holes

This paper presents an experimental investigation on the influences of laser trepanning drilling process parameters on the recast layer thickness and surface crack formation in CMSX-4 nickel-based superalloy angled holes. The effects of peak power, pulse frequency and the trepanning speed as input parameters were investigated in details by varying the laser drilling conditions using Taguchi orthogonal array-based design of experiment approach. Analysis of variance identifies the significant parameters affecting the output responses. It is found that the output responses are affected mainly by the peak power and trepanning speed. The experimental results reveal that the recast layer thickness increases with the increase of peak power and trepanning speed whereas the crack number density decreases with the increase of peak power only. Pulse frequency has no significant effect on both output responses within the range of values investigated. The knowledge gained in this parametric study could be used to improve the metallurgical characteristics of laser-drilled nickel-based acute angled holes