Standard arc welders provide high amperage direct current source

Standard arc welders or power supplies are hooked up in parallel or series connections to obtain an adequate supply of current or voltage for various purposes. This method provides maximum flexibility in a wide range of voltages and currents

Flexible ring slosh damping baffle Patent

Flexible ring slosh damping baffle for spacecraft fuel tan

Continuously operating induction plasma accelerator Patent

Continuous operation, single phased, induction plasma accelerator producing supersonic speed

Results of LFC experiment on slotted swept supercritical airfoil in Langley's 8-foot transonic pressure tunnel

A large chord swept supercritical laminar-flow control (LFC) airfoil was designed, constructed, and tested in the Langley 8-foot Transonic Pressure Tunnel (TPT). The LFC airfoil experiment was established to provide basic information concerning the design and compatibility of high performance supercritical airfoils with suction boundary-layer control achieved through fine slots or porous surface concepts. Shockless pressure distribution was achieved. Full chord laminar flow was achieved on upper and lower surfaces. Full chord laminar flow was maintained at subcritical speeds and over large supercritical zones. Feasibility of combined suction laminarization and supercritical airfoil technology was demonstrated

Laboratory investigation of diffraction and reflection of sonic booms by buildings

Laboratory investigation of diffraction and reflection of sonic booms by building

Advances in Moire interferometry for thermal response of composites

An experimental technique for the precise measurement of the thermal response of both sides of a laminated composite coupon specimen uses Moire interferometry with fringe multiplication which yields a sensitivity of 833 nm (32.8 micro in.) per fringe. The reference gratings used are virtual gratings and are formed by partially mirrorized glass prisms in close proximity to the specimen. Results are compared with both results obtained from tests which used Moire interferometry on one side of composite laminates, and with those predicted by classical lamination theory. The technique is shown to be capable of producing the sensitivity and accuracy necessary to measure a wide range of thermal responses and to detect small side to side variations in the measured response. Tests were conducted on four laminate configurations of T300/5208 graphite epoxy over a temperature range of 297 K (75 F) to 422 K (300 F). The technique presented allows for the generation of reference gratings for temperature regimes well outside that used in these tests

The NASA Langley laminar-flow-control experiment on a swept, supercritical airfoil: Suction coefficient analysis

A swept supercritical wing incorporating laminar flow control at transonic flow conditions was designed and tested. The definition of an experimental suction coefficient and a derivation of the compressible and incompressible formulas for the computation of the coefficient from measurable quantities is presented. The suction flow coefficient in the highest velocity nozzles is shown to be overpredicted by as much as 12 percent through the use of an incompressible formula. However, the overprediction on the computed value of suction drag when some of the suction nozzles were operating in the compressible flow regime is evaluated and found to be at most 6 percent at design conditions

Design and experimental evaluation of a swept supercritical Laminar Flow Control (LFC) airfoil

A large chord swept supercritical laminar flow control (LFC) airfoil was designed, constructed, and tested in the NASA Langley 8-ft Transonic Pressure Tunnel (TPT). The LFC airfoil experiment was established to provide basic information concerning the design and compatibility of high-performance supercritical airfoils with suction boundary layer control achieved through discrete fine slots or porous surface concepts. It was aimed at validating prediction techniques and establishing a technology base for future transport designs and drag reduction. Good agreement was obtained between measured and theoretically designed shockless pressure distributions. Suction laminarization was maintained over an extensive supercritical zone up to high Reynolds numbers before transition gradually moved forward. Full-chord laminar flow was maintained on the upper and lower surfaces at M sub infinity = 0.82 up to R sub c is less than or equal to 12 x 10 to the 6th power. When accounting for both the suction and wake drag, the total drag could be reducted by at least one-half of that for an equivalent turbulent airfoil. Specific objectives for the LFC experiment are given

The NASA Langley laminar-flow-control experiment on a swept, supercritical airfoil - Drag equations

The Langley Research Center has designed a swept, supercritical airfoil incorporating Laminar Flow Control for testing at transonic speeds. Analytical expressions have been developed and an evaluation made of the experimental section drag, composed of suction drag and wake drag, using theoretical design information and experimental data. The analysis shows that, although the sweep-induced boundary-layer crossflow influence on the wake drag is too large to be ignored and there is not a practical method for evaluating these crossflow effects on the experimental wake data, the conventional unswept 2-D wake-drag computation used in the reduction of the experimental data is at worst 10 percent too high