Subconvexity for modular form L-functions in the t aspect

Modifying a method of Jutila, we prove a t aspect subconvexity estimate for L-functions associated to primitive holomorphic cusp forms of arbitrary level that is of comparable strength to Good's bound for the full modular group, thus resolving a problem that has been open for 35 years. A key innovation in our proof is a general form of Voronoi summation that applies to all fractions, even when the level is not squarefree.Comment: minor revisions; to appear in Adv. Math.; 30 page

Analysis of a Waveguide-Fed Metasurface Antenna

The metasurface concept has emerged as an advantageous reconfigurable antenna architecture for beam forming and wavefront shaping, with applications that include satellite and terrestrial communications, radar, imaging, and wireless power transfer. The metasurface antenna consists of an array of metamaterial elements distributed over an electrically large structure, each subwavelength in dimension and with subwavelength separation between elements. In the antenna configuration we consider here, the metasurface is excited by the fields from an attached waveguide. Each metamaterial element can be modeled as a polarizable dipole that couples the waveguide mode to radiation modes. Distinct from the phased array and electronically scanned antenna (ESA) architectures, a dynamic metasurface antenna does not require active phase shifters and amplifiers, but rather achieves reconfigurability by shifting the resonance frequency of each individual metamaterial element. Here we derive the basic properties of a one-dimensional waveguide-fed metasurface antenna in the approximation that the metamaterial elements do not perturb the waveguide mode and are non-interacting. We derive analytical approximations for the array factors of the 1D antenna, including the effective polarizabilities needed for amplitude-only, phase-only, and binary constraints. Using full-wave numerical simulations, we confirm the analysis, modeling waveguides with slots or complementary metamaterial elements patterned into one of the surfaces.Comment: Original manuscript as submitted to Physical Review Applied (2017). 14 pages, 14 figure

Inelastic collisions of ultra-cold heteronuclear molecules in an optical trap

Ultra-cold RbCs molecules in high-lying vibrational levels of the a$^3\Sigma^+$ ground electronic state are confined in an optical trap. Inelastic collision rates of these molecules with both Rb and Cs atoms are determined for individual vibrational levels, across an order of magnitude of binding energies. A simple model for the collision process is shown to accurately reproduce the observed scattering rates

Using Earth to Search for Long-Range Spin-Velocity Interactions

Precision measurements of the possible coupling of spin to other scalars, vectors and pseudovectors has proven to be a sensitive way to search for new particle physics beyond the standard model. Indeed, in addition to searching for exotic spin-spin interactions, studies have been undertaken to look for couplings of spin to gravity, the relative velocity between particles, and preferred directions. Several laboratory experiments have established upper bounds on the energy associated with various fermion spin-orientations relative to Earth. Here, we combine these results with a model of Earth in order to investigate the possible long-range spin-velocity interactions associated with the exchange of ultralight ($m_{z'}<1$ neV) or massless scalar or vector bosons. We establish stringent bounds on the strength of these couplings between electrons, neutrons, protons and nucleons.Comment: 6 pages, 1 figure, 1 tabl

Evaluation of Pt, Ni, and Ni–Mo electrocatalysts for hydrogen evolution on crystalline Si electrodes

The dark electrocatalytic and light photocathodic hydrogen evolution properties of Ni, Ni–Mo alloys, and Pt on Si electrodes have been measured, to assess the viability of earth-abundant electrocatalysts for integrated, semiconductor coupled fuel formation. In the dark, the activities of these catalysts deposited on degenerately doped p^+-Si electrodes increased in the order Ni < Ni–Mo ≤ Pt. Ni–Mo deposited on degenerately doped Si microwires exhibited activity that was very similar to that of Pt deposited by metal evaporation on planar Si electrodes. Under 100 mW cm^(−2) of Air Mass 1.5 solar simulation, the energy conversion efficiencies of p-type Si/catalyst photoelectrodes ranged from 0.2–1%, and increased in the order Ni ≈ Ni–Mo < Pt, due to somewhat lower photovoltages and photocurrents for p-Si/Ni–Mo relative to p-Si/Ni and p-Si/Pt photoelectrodes. Deposition of the catalysts onto microwire arrays resulted in higher apparent catalytic activities and similar photoelectrode efficiencies than were observed on planar p-Si photocathodes, despite lower light absorption by p-Si in the microwire structures

Spectral Absorption Coefficient of Additive Manufacturing Polymers

As NASA turns to additive manufacturing processes, there is a need to ensure that the parts they produce are reliable. This is especially true when creating parts in space, where resources are limited and failure could result in catastrophe. Active thermography has shown potential as a non-destructive quality assurance technique for additive manufacturing processes. Heat transfer models used in active thermography techniques require accurate material property measurements in order to extract useful information about the system, including defect location. The spectral absorption coefficient, which determines the depth at which radiative power is absorbed into a surface, is a material property necessary for performing active thermography on AM polymers. This paper presents measurements of spectral absorption coefficients of polymers commonly used in additive manufacturing. Spectral absorption coefficients for fully dense PLA, ABS, and Nylon 12 samples are reported. Future work is needed to measure the spectral absorption coefficients of different materials and colored filaments commonly used in additive manufacturing

Faking and the Validity of Personality Tests: An Experimental Investigation Using Modern Forced Choice Measures

Despite the established validity of personality measures for personnel selection, their susceptibility to faking has been a persistent concern. However, the lack of studies that combine generalizability with experimental control makes it difficult to determine the effects of applicant faking. This study addressed this deficit in two ways. First, we compared a subtle incentive to fake with the explicit “fake-good” instructions used in most faking experiments. Second, we compared standard Likert scales to multidimensional forced choice (MFC) scales designed to resist deception, including more and less fakable versions of the same MFC inventory. MFC scales substantially reduced motivated score elevation but also appeared to elicit selective faking on work-relevant dimensions. Despite reducing the effectiveness of impression management attempts, MFC scales did not retain more validity than Likert scales when participants faked. However, results suggested that faking artificially bolstered the criterion-related validity of Likert scales while diminishing their construct validity