5,186 research outputs found
Static pressure correction in high Reynolds number fully developed turbulent pipe flow
Measurements are reported of the error in wall static pressure reading due to the finite size of the pressure tapping. The experiments were performed in incompressible turbulent pipe flow over a wide range of Reynolds numbers, and the results indicate that the correction term (as a fraction of the wall stress) continues to increase as the hole Reynolds number increases, contrary to previous studies. For small holes relative to the pipe diameter the results follow a single curve, but for larger holes the data diverge from this universal behaviour at a point that depends on the ratio of the hole diameter to the pipe diameter
A new friction factor relationship for fully developed pipe flow
The friction factor relationship for high-Reynolds-number fully developed turbulent pipe flow is investigated using two sets of data from the Princeton Superpipe in the range 31×10^3 ≤ ReD ≤ 35×10^6. The constants of Prandtl’s ‘universal’ friction factor relationship are shown to be accurate over only a limited Reynolds-number range and unsuitable for extrapolation to high Reynolds numbers. New constants, based on a logarithmic overlap in the mean velocity, are found to represent the high-Reynolds-number data to within 0.5%, and yield a value for the von Kármán constant that is consistent with the mean velocity profiles themselves. The use of a generalized logarithmic law in the mean velocity is also examined. A general friction factor relationship is proposed that predicts all the data to within 1.4% and agrees with the Blasius relationship for low Reynolds numbers to within 2.0%
Reynolds number dependence of streamwise velocity spectra in turbulent pipe flow
Spectra of the streamwise velocity component in fully developed turbulent pipe flow are presented for Reynolds numbers up to 5.7×10^6. Even at the highest Reynolds number, streamwise velocity spectra exhibit incomplete similarity only: while spectra collapse with both classical inner and outer scaling for limited ranges of wave number, these ranges do not overlap. Thus similarity may not be described as complete, and a region varying with the inverse of the streamwise wave number, k1, is not expected, and any apparent k1-1 range does not attract any special significance and does not involve a universal constant. Reasons for this are suggested
Scaling of the streamwise velocity component in turbulent pipe flow
Statistics of the streamwise velocity component in fully developed pipe flow are examined for Reynolds numbers in the range 5.5 x 10^4 ≤ ReD ≤ 5.7 x 10^6. Probability density functions and their moments (up to sixth order) are presented and their scaling with Reynolds number is assessed. The second moment exhibits two maxima: the one in the viscous sublayer is Reynolds-number dependent while the other, near the lower edge of the log region, follows approximately the peak in Reynolds shear stress. Its locus has an approximate (R^+)^{0.5} dependence. This peak shows no sign of ‘saturation’, increasing indefinitely with Reynolds number. Scalings of the moments with wall friction velocity and are examined and the latter is shown to be a better velocity scale for the outer region, y/R > 0.35, but in two distinct Reynolds-number ranges, one when ReD 7 x 10^4. Probability density functions do not show any universal behaviour, their higher moments showing small variations with distance from the wall outside the viscous sublayer. They are most nearly Gaussian in the overlap region. Their departures from Gaussian are assessed by examining the behaviour of the higher moments as functions of the lower ones. Spectra and the second moment are compared with empirical and theoretical scaling laws and some anomalies are apparent. In particular, even at the highest Reynolds number, the spectrum does not show a self-similar range of wavenumbers in which the spectral density is proportional to the inverse streamwise wavenumber. Thus such a range does not attract any special significance and does not involve a universal constant
Seizoensarbeid nodig voor groei biologische landbouw
In de nota 'Een biologische markt te winnen' heeft de Minister van LNV laten weten dat het Nederland zou sieren wanneer de biologische sector in 2010 10% van het agrarisch areaal omvat
Further observations on the mean velocity distribution in fully developed pipe flow
The measurements by Zagarola & Smits (1998) of mean velocity profiles in fully developed turbulent pipe flow are repeated using a smaller Pitot probe to reduce the uncertainties due to velocity gradient corrections. A new static pressure correction (McKeon & Smits 2002) is used in analysing all data and leads to significant differences from the Zagarola & Smits conclusions. The results confirm the presence of a power-law region near the wall and, for Reynolds numbers greater than 230×10^3 (R+ >5×10^3), a logarithmic region further out, but the limits of these regions and some of the constants differ from those reported by Zagarola & Smits. In particular, the log law is found for 600<y+ <0.12R+ (instead of 600<y+ <0.07R+), and the von Kármán constant κ, the additive constant B for the log law using inner flow scaling, and the additive constant B∗ for the log law using outer scaling are found to be 0.421 ± 0.002, 5.60 ± 0.08 and 1.20 ± 0.10, respectively, with 95% confidence level (compared with 0.436±0.002, 6.15±0.08, and 1.51±0.03 found by Zagarola & Smits). The data also confirm that the pipe flow data for ReD ≤ 13.6×10^6 (as a minimum) are not affected by surface roughness
A robust method for determining instants of major excitations in voiced speech
We propose a method for determining the instants of significant excitation in speech signals using the negative derivative of the unwrapped phase (group delay) function of the short time Fourier transform. Here significant excitation refers primarily to the instants of glottal closure in voiced speech. The method computes the average slope of the unwrapped phase spectrum as a function of time. The instants where the phase slope function makes a positive zero-crossing correspond to the major excitations in the signal. For an analysis window size in the range of one to two pitch periods, these instants coincide with the instants of glottal closure in each pitch period. The method is robust, as it depends only on the average phase slope value, and further, it depends only on the positive zero-crossing instants of the average phase slope functio
Some preliminary results of experiments with in-vitro culture of dipterocarps.
A study was made of the influence of light, temp., growth regulators, and sugar and macrosalt concn. on the growth and morphogenesis of leaf and axis explants of young Shorea curtisii, S. obtusa and Dipterocarpus grandiflorus. Terminal and axillary buds grew best on half strength Murashige and Skoog medium. Leaf explants formed more callus on full strength medium, when containing part of the midrib and when taken from the lower half of the leaf. More than 95% of D. grandiflorus explants were infected by a fungus apparently present in the parent plant. (Abstract retrieved from CAB Abstracts by CABI’s permission
The response of hot wires in high Reynolds-number turbulent pipe flow
Issues concerning the accuracy of hot-wire measurements in turbulent pipe flow are addressed for pipe Reynolds numbers up to 6 × 106 and hot-wire Reynolds numbers up to Rew ap 250. These include the optimization of spatial and temporal resolution and the associated feature of signal-to-noise ratio. Very high wire Reynolds numbers enable the use of wires with reduced length-to-diameter ratios compared to those typical of atmospheric conditions owing to increased wire Nusselt numbers. Simulation of the steady-state heat balance for the wire and the unetched portion of wire are used to assess static end-conduction effects: they are used to calculate wire Biot numbers, \sqrt{c_0}l , and fractional end-conduction losses, σ, which confirm the 'conduction-only' theory described by Corrsin. They show that, at Rew ap 250, the wire length-to-diameter ratio can be reduced to about 50, while keeping \sqrt{c_0}l\gt3 and σ < 7% in common with accepted limits at Rew ap 3. It is shown that these limits depend additionally on the choice of wire material and the length of unetched wire. The dynamic effects of end-cooling are also assessed using the conduction-only theory
- …