Thermal Perturbations beneath the Incipient Okavango Rift Zone, Northwest Botswana

We used aeromagnetic and gravity data to investigate the thermal structure beneath the incipient Okavango Rift Zone (ORZ) in northwestern Botswana in order to understand its role in strain localization during rift initiation. We used three-dimensional (3-D) inversion of aeromagnetic data to estimate the Curie Point Depth (CPD) and heat flow under the rift and surrounding basement. We also used two-dimensional (2-D) power-density spectrum analysis of gravity data to estimate the Moho depth. Our results reveal shallow CPD values (8-15 km) and high heat flow (60-90 mW m-2) beneath a ∼60 km wide NE-trending zone coincident with major rift-related border faults and the boundary between Proterozoic orogenic belts. This is accompanied by thin crust ( \u3c 30 km) in the northeastern and southwestern parts of the ORZ. Within the Precambrian basement areas, the CPD values are deeper (16-30 km) and the heat flow estimates are lower (30-50 mW m-2), corresponding to thicker crust (∼40-50 km). We interpret the thermal structure under the ORZ as due to upward migration of hot mantle fluids through the lithospheric column that utilized the presence of Precambrian lithospheric shear zones as conduits. These fluids weaken the crust, enhancing rift nucleation. Our interpretation is supported by 2-D forward modeling of gravity data suggesting the presence of a wedge of altered lithospheric mantle centered beneath the ORZ. If our interpretation is correct, it may result in a potential paradigm shift in which strain localization at continental rift initiation could be achieved through fluid-assisted lithospheric weakening without asthenospheric involvement

Microbial Growth and Biofilm Formation in Geologic Media Is Detected with Complex Conductivity Measurements

Complex conductivity measurements (0.1-1000 Hz) were obtained from biostimulated sand-packed columns to investigate the effect of microbial growth and biofilm formation on the electrical properties of porous media. Microbial growth was verified by direct microbial counts, pH measurements, and environmental scanning electron microscope imaging. Peaks in imaginary (interfacial) conductivity in the biostimulated columns were coincident with peaks in the microbial cell concentrations extracted from sands. However, the real conductivity component showed no discernible relationship to microbial cell concentration. We suggest that the observed dynamic changes in the imaginary conductivity (σ″) arise from the growth and attachment of microbial cells and biofilms to sand surfaces. We conclude that complex conductivity techniques, specifically imaginary conductivity measurements are a proxy indicator for microbial growth and biofilm formation in porous media. Our results have implications for microbial enhanced oil recovery, CO2 sequestration, bioremediation, and astrobiology studies

Thermal Perturbations beneath the Incipient Okavango Rift Zone, Northwest Botswana

We used aeromagnetic and gravity data to investigate the thermal structure beneath the incipient Okavango Rift Zone (ORZ) in northwestern Botswana in order to understand its role in strain localization during rift initiation. We used three-dimensional (3-D) inversion of aeromagnetic data to estimate the Curie Point Depth (CPD) and heat flow under the rift and surrounding basement. We also used two-dimensional (2-D) power-density spectrum analysis of gravity data to estimate the Moho depth. Our results reveal shallow CPD values (8-15 km) and high heat flow (60-90 mW m-2) beneath a ∼60 km wide NE-trending zone coincident with major rift-related border faults and the boundary between Proterozoic orogenic belts. This is accompanied by thin crust ( \u3c 30 km) in the northeastern and southwestern parts of the ORZ. Within the Precambrian basement areas, the CPD values are deeper (16-30 km) and the heat flow estimates are lower (30-50 mW m-2), corresponding to thicker crust (∼40-50 km). We interpret the thermal structure under the ORZ as due to upward migration of hot mantle fluids through the lithospheric column that utilized the presence of Precambrian lithospheric shear zones as conduits. These fluids weaken the crust, enhancing rift nucleation. Our interpretation is supported by 2-D forward modeling of gravity data suggesting the presence of a wedge of altered lithospheric mantle centered beneath the ORZ. If our interpretation is correct, it may result in a potential paradigm shift in which strain localization at continental rift initiation could be achieved through fluid-assisted lithospheric weakening without asthenospheric involvement

Hydrological Monitoring with Hybrid Sensor Networks

Existing hydrological monitoring systems suffer from short- comings in accuracy, resolution, and scalability. Their fragility, high power consumption, and lack of autonomy necessitate frequent site visits. Cabling requirements and large size limit their scalability and make them prohibitively expensive. The research described in this paper proposes to alleviate these problems by pairing high-resolution in situ measure- ment with remote data collection and software maintenance. A hybrid sensor network composed of wired and wireless connections autonomously measures various attributes of the soil, including moisture, temperature, and resistivity. The mea- surements are communicated to a processing server over the existing GSM cellular infrastructure. This system enables the collection of data at a scale and resolution that is orders of magnitude greater than any existing method, while dramatically reducing the cost of monitoring. The quality and sheer volume of data collected as a result will enable previously infeasible research in hydrology

In-situ Apparent Conductivity Measurements and Microbial Population Distribution at a Hydrocarbon-Contaminated Site

We investigated the bulk electrical conductivity and microbial population distribution in sediments at a site contaminated with light nonaqueous-phase liquid (LNAPL). The bulk conductivity was measured using in-situ vertical resistivity probes; the most probable number method was used to characterize the spatial distribution of aerobic heterotrophic and oil-degrading microbial populations. The purpose of this study was to assess if high conductivity observed at aged LNAPL-impacted sites may be related to microbial degradation of LNAPL. The results show higher bulk conductivity coincident with LNAPL-impacted zones, in contrast to geoelectrical models that predict lower conductivity in such zones. The highest bulk conductivity was observed to be associated with zones impacted by residual and free LNAPL. Data from bacteria enumeration from sediments close to the resistivity probes show that oil-degrading microbes make up a larger percentage (5-55%) of the heterotrophic microbial community at depths coincident with the higher conductivity compared to ∼5% at the uncontaminated location. The coincidence of a higher percentage of oil-degrading microbial populations in zones of higher bulk conductivity suggests that the higher conductivity in these zones may result from increased fluid conductivity related to microbial degradation of LNAPL, consistent with geochemical studies that suggest that intrinsic biodegradation is occurring at the site. The findings from this study point to the fact that biogeochemical processes accompanying biodegradation of contaminants can potentially alter geoelectrical properties of the subsurface impacted media

Electrical Resistivity Imaging for Long-Term Autonomous Monitoring of Hydrocarbon Degradation: Lessons from the Deepwater Horizon Oil Spill

Conceptual models for the geophysical responses associated with hydrocarbon degradation suggest that the long-term evolution of an oil plume will result in a more conductive anomaly than the initial contamination. In response to the Deepwater Horizon (DH) oil spill into the Gulf of Mexico in 2010, an autonomous resistivity monitoring system was deployed on Grand Terre, Louisiana, in an attempt to monitor natural degradation processes in hydrocarbon-impacted beach sediments of this island. A 48-electrode surface array with a 0.5-m spacing was installed to obtain twice-daily images of the resistivity structure of the shallow subsurface impacted by oil. Over the course of approximately 18 months, we observed a progressive decrease in the resistivity of the DH spill-impacted region. Detailed analysis of pixel/point resistivity variation within the imaged area showed that long-term decreases in resistivity were largely associated with the DH-impacted sediments. A microbial diversity survey revealed the presence of hydrocarbon-degrading organisms throughout the test site. However, hydrocarbon degradation activity was much higher in the DH-impacted locations compared to nonimpacted locations, suggesting the presence of active hydrocarbon degraders, supporting biodegradation processes. The results of this long-term monitoring experiment suggested that resistivity might be used to noninvasively monitor the long-term degradation of crude oil spills

Evidence for Microbial Enhanced Electrical Conductivity in Hydrocarbon-Contaminated Sediments

Bulk electrical conductivity of sediments during microbial mineralization of diesel was investigated in a mesoscale laboratory experiment consisting of biotic contaminated and uncontaminated columns. Population numbers of oil degrading microorganisms increased with a clear pattern of depth zonation within the contaminated column not observed in the uncontaminated column. Microbial community structure determined from ribosomal DNA intergenic spacer analysis showed a highly specialized microbial community in the contaminated column. The contaminated column showed temporal increases in bulk conductivity, dissolved inorganic carbon, and calcium, suggesting that the high bulk conductivity is due to enhanced mineral weathering from microbial activity. The greatest change in bulk conductivity occurred in sediments above the water table saturated with diesel. Variations in electrical conductivity magnitude and microbial populations and their depth distribution in the contaminated column are similar to field observations. The results of this study suggest that geophysical methodologies may potentially be used to investigate microbial activity