Design of an MgB₂race track coil for a wind generator pole demonstration

An MgB2 race track coil intended for demonstrating a down scaled pole of a 10 MW direct drive wind turbine generator has been designed. The coil consists of 10 double pancake coils stacked into a race track coil with a cross section of 84 mm x 80 mm. The length of the straight section is 0.5 m and the diameter of the end sections is 0.3 m. Expanded to a straight section of 3.1 m it will produce about 1.5 T magnetic flux density in the air gap of the 10 MW 32 pole generator and about 3.0 T at the edge of the superconducting coil with an operation current density of the coil of 70 A/mm2.Electrical Sustainable EnergyElectrical Engineering, Mathematics and Computer Scienc

Fabrication of a scaled MgB2 racetrack demonstrator pole for a 10 MW direct drive wind turbine generator

Field windings made of MgB2 wires or tapes are considered for their potential to reduce volume, weight and cost of large offshore wind turbine generators. To gain experience of how to use this relatively new material in full-scale generators, tests of different winding methodologies and techniques are needed. In this paper, we describe in detail the steps used to wind a racetrack coil with a length of 1 m and a width of 0.5 m out of 4.5 km of MgB2 superconducting tape. The width corresponds to a full-scale pole of a 10 MW generator, whereas the length of the straight section is shorter than the corresponding full-scale pole. The coil was built up of 10 double pancake coils. Each double pancake coil was wet-wound using a semi-automatic winding process, where Stycast 2850 was applied directly to the MgB2 tape without any other dedicated electrical insulation. The strengths and weaknesses of the winding process are discussed and compared to the dry-winding method.acceptedVersio

Fabrication of a scaled MgB2 racetrack demonstrator pole for a 10 MW direct drive wind turbine generator

Field windings made of MgB2 wires or tapes are considered for their potential to reduce volume, weight and cost of large offshore wind turbine generators. To gain experience of how to use this relatively new material in full-scale generators, tests of different winding methodologies and techniques are needed. In this paper, we describe in detail the steps used to wind a racetrack coil with a length of 1 m and a width of 0.5 m out of 4.5 km of MgB2 superconducting tape. The width corresponds to a full-scale pole of a 10 MW generator, whereas the length of the straight section is shorter than the corresponding full-scale pole. The coil was built up of 10 double pancake coils. Each double pancake coil was wet-wound using a semi-automatic winding process, where Stycast 2850 was applied directly to the MgB2 tape without any other dedicated electrical insulation. The strengths and weaknesses of the winding process are discussed and compared to the dry-winding method.acceptedVersio

Design Study of Coated Conductor Direct Drive Wind Turbine Generator for Small Scale Demonstration

AbstractWe have investigated the properties of a superconducting direct drive generator suitable for demonstration in a small scale 11kW wind turbine. The engineering current density of the superconducting field windings is based on properties of coated conductors wound into coils holding of the order 68 meters of tape. The active mass of the generators has been investigated as function of the number of poles and a 4 pole generator is suggested as a feasible starting point of an in-field demonstration of the system reliability. An active mass of m = 421kg and a usage of 3.45km of tape will be needed to realize such a generator with a peak flux density in the airgap of B0 = 1.5 T