Oblique response of a split-ring-resonator-based left-handed metamaterial slab

Cataloged from PDF version of article.We experimentally studied the transmission response of a one-dimensional rectangle-prism-shaped metamaterial slab for oblique incidence angles. The electrical size of the split-ring resonators was 1 order of magnitude smaller than the operation wavelength similar to 8.5 cm. We demonstrated that the left-handed transmission peak preserved up to an angle of incidence 45 degrees. The angular measurements were performed with respect to two lateral directions. The confirmed insensitivity of split-ring-resonator-based metamaterials to the angle of incidence makes them a good candidate for superlens applications. (C) 2009 Optical Society of Americ

Electrically small split ring resonator antennas

Cataloged from PDF version of article.We studied electrically small resonant antennas composed of split ring resonators (SRR) and monopoles. The antennas considered have the same ring radius, but slightly different geometry. The resonance frequency depends on the geometry of the SRRs. Two SRR antennas are designed. The first one, which operates at 3.62 GHz, is demonstrated theoretically and experimentally. The size of this antenna is 0.095 lambda(0)x0.100 lambda(0) and is low profile at the other dimension. The gain and directivity of the antenna was 2.38 and 5.46, respectively. The corresponding efficiency was 43.6%. The estimated radiation Q (rad Q=23.03) was much larger than the minimum radiation Q (min Q=1.78). The second one is a rather small SRR antenna in which the capacitance between the rings is increased. The size is reduced to 0.074 lambda(0)x0.079 lambda(0). This structure is called serrated SRR (SSRR). Both antennas have similar far-field patterns but the efficiency of the SSRR antenna is less. (c) 2007 American Institute of Physics

Metamaterial inspired enhanced far-field transmission through a subwavelength nano-hole

In the present study, we first demonstrate the polarization and orientation dependent transmission response of split ring resonators at the infrared and visible band. Then, we numerically demonstrate a configuration for the enhancement of power passing through an electrically small hole. By using deep subwavelength optical split ring resonator antennas and couplers we achieved a 400-fold enhanced transmission from a subwavelength aperture area of the electrical size Λ 2/25. The power was transmitted to the far field with 3.9 dBi directivity at 300 THz. (© 2010 WILEY-VCH Verlag GmbH & Co. KGaA, Weinheim) Transmission through a subwavelength aperture at the optical regime is quite low. The Letter by Alici and Ozbay shows how it can be enhanced and transferred to the far field by using a metamaterial inspired configuration composed of nano-scale split ring resonator antennas and couplers. A 400-fold power enhancement was achieved. © 2010 WILEY-VCH Verlag GmbH & Co. KGaA, Weinheim

Photonic magnetic metamaterial basics

Cataloged from PDF version of article.In the present study, we provide a detailed analysis for the study of photonic metamaterials. We demonstrate the polarization and orientation dependent transmission response of split ring resonators at the infrared and visible band. We provided optical measurements only for one case, in which electric component of the incident field was coupled to planar split ring resonator array. We consecutively studied (i) frequency tuning, (ii) effect of resonator density, (iii) shifting magnetic resonance frequency by changing the resonator shape, and (iv) effect of metal loss and plasma frequency. The study provides an overlook for the candidate applications such as the enhancement of power passing through an electrically small hole, negative index metamaterials and optical metamaterial absorbers. (C) 2010 Elsevier B.V. All rights reserved

Optimization and tunability of deep subwavelength resonators for metamaterial applications: complete enhanced transmission through a subwavelength aperture

Cataloged from PDF version of article.In the present work, we studied particle candidates for metamaterial applications, especially in terms of their electrical size and resonance strength. The analyzed particles can be easily produced via planar fabrication techniques. The electrical size of multi-split ring resonators, spiral resonators, and multi-spiral resonators are reported as a function of the particle side length and substrate permittivity. The study is continued by demonstrating the scalability of the particles to higher frequencies and the proposition of the optimized particle for antenna, absorber, and superlens applications: a multi-spiral resonator with lambda/30 electrical size operating at 0.810 GHz. We explain a method for tuning the resonance frequency of the multi-split structures. Finally, we demonstrate that by inserting deep subwavelength resonators into periodically arranged subwavelength apertures, complete transmission enhancement can be obtained at the magnetic resonance frequency. (C) 2009 Optical Society of Americ

Miniaturized negative permeability materials

Cataloged from PDF version of article.Experimental and numerical studies of mu-negative (MNG) materials such as multisplit ring resonators (MSRRs) and spiral resonators (SRs) are presented. The resonance frequency of the structures is determined by the transmission measurements and minimum electrical size of lambda(0)/17 for the MSRRs and of lambda(0)/82 for the SRs observed. These MNG materials can be easily produced by the well developed printed circuit board and optical lithography techniques. They are promising elements for the development of high resolution metamaterial lenses and electrically small antennas. (c) 2007 American Institute of Physics

Asymmetric Fabry-Perot-type transmission in photonic-crystal gratings with one-sided corrugations at a two-way coupling

Cataloged from PDF version of article.Strongly asymmetric Fabry-Perot-type transmission arising at the two-way coupling has been studied in the case of normal incidence for slabs of two-dimensional photonic crystals (PCs) with one-sided corrugations that are made of linear isotropic materials. Comparing to the scenario of unidirectional transmission known for the structures with broken spatial inversion symmetry that requires zero order being uncoupled, in the studied mechanism zero order is either the sole order or one of the orders that may be coupled to a Floquet-Bloch mode. Contrary to the earlier studies of asymmetric transmission at the coupled zero order, structures with nondeep corrugations are considered, which allow one to combine Fabry-Perot-type total-transmission maxima with diffractions in a desired way. At a proper choice of PC lattice and corrugation parameters, higher orders can dominate in Fabry-Perot-type transmission at the noncorrugated-side illumination and also at the total-transmission maxima, whereas only zero order contributes to the transmission at the corrugated-side illumination. As a result, strong asymmetry can be obtained without uncoupling of zero order but it invokes the unidirectional contribution of higher orders. The presented results show that the entire structure can be approximately decomposed into the two independent, regular and grating (nonregular), parts whose contributions to the transmission are additive. Multiple asymmetric transmission maxima can coexist with a rather high equivalent group index of refraction. Possible applications of the studied transmission mechanism are discussed

Design of Miniaturized Narrowband Absorbers Based on Resonant-Magnetic Inclusions

Cataloged from PDF version of article.In this paper, we present the design of miniaturized narrowband-microwave absorbers based on different kinds of magnetic inclusions. The operation of the proposed components originates from the resonance of a planar array of inclusions excited by an incoming wave with a given polarization. As in common absorber layouts, a 377 Omega resistive sheet is also used to absorb the electromagnetic energy of the impinging field. Since the planar array of magnetic inclusions behaves at its resonance as a perfect magnetic conductor, the resistive sheet is placed in close proximity of the resonating inclusions, without perturbing their resonance condition. In contrast to other typical absorber configurations presented in the literature, the absorber proposed in this paper is not backed by a metallic plate. This feature may be useful for stealth applications, as discussed thoroughly in the paper. The other interesting characteristic of the proposed absorbers is the subwavelength thickness, which has shown to depend only on the geometry of the basic resonant inclusions employed. At first, regular split-ring resonators (SSRs) disposed in an array configuration are considered and some application examples are presented. Absorbers based on SRRs are shown to reach thickness of the order of lambda(0)/20. In order to further squeeze the electrical thickness of the absorbers, multiple SRRs and spiral resonators are also used. The employment of such inclusions leads to the design of extremely thin microwave absorbers, whose thickness may even be close to lambda(0)/100. Finally, some examples of miniaturized absorbers suitable for a practical realization are proposed

Optically thin composite resonant absorber at the near-infrared band: a polarization independent and spectrally broadband configuration

Cataloged from PDF version of article.We designed, fabricated, and experimentally characterized thin absorbers utilizing both electrical and magnetic impedance matching at the near-infrared regime. The absorbers consist of four main layers: a metal back plate, dielectric spacer, and two artificial layers. One of the artificial layers provides electrical resonance and the other one provides magnetic resonance yielding a polarization independent broadband perfect absorption. The structure response remains similar for the wide angle of incidence due to the sub-wavelength unit cell size of the constituting artificial layers. The design is useful for applications such as thermal photovoltaics, sensors, and camouflage. (C)2011 Optical Society of Americ