Acetylation of Raw Cotton for Oil Spill Cleanup Application: an FTIR and 13-C MAS NMR Spectroscopic Investigation

Fourier transform infrared (FTIR) and 13C MAS NMR spectroscopy have been used to investigate the acetylation of raw cotton samples with acetic anhydride without solvents in the presence of different amounts of 4-dimethylaminopyridine (DMAP) catalyst. This is a continuation of our previous investigation of acetylation of commercial cotton in an effort to develop hydrophobic, biodegradable, cellulosic sorbent materials for cleaning up oil spills. The FTIR data have again provided a clear evidence for successful acetylation. The NMR results further confirm the successful acetylation. The extent of acetylation was quantitatively determined using the weight percent gain (WPG) due to acetylation and by calculating the ratio R between the intensity of the acetyl C=O stretching band at 1740-1745 cm-1 and the intensity of C-O stretching vibration of the cellulose backbone at about 1020-1040 cm-1. The FTIR technique was found to be highly sensitive and reliable for the determination of the extent of acetylation. The level of acetylation of the raw cotton samples was found to be much higher than that of cotton fabrics and the previously studied commercial cotton. The variation of the R and WPG with reaction time, amount of DMAP catalyst and different samples of raw cotton is discusse

Intercalation of Hydrotalcites with Hexacyanoferrate(II) and (III)-a ThermoRaman Spectroscopic Study

Raman spectroscopy using a hot stage indicates that the intercalation of hexacyanoferrate(II) and (III) in the interlayer space of a Mg,Al hydrotalcites leads to layered solids where the intercalated species is both hexacyanoferrate(II) and (III). Raman spectroscopy shows that depending on the oxidation state of the initial hexacyanoferrate partial oxidation and reduction takes place upon intercalation. For the hexacyanoferrate(III) some partial reduction occurs during synthesis. The symmetry of the hexacyanoferrate decreases from Oh existing for the free anions to D3d in the hexacyanoferrate interlayered hydrotalcite complexes. Hot stage Raman spectroscopy reveals the oxidation of the hexacyanoferrate(II) to hexacyanoferrate(III) in the hydrotalcite interlayer with the removal of the cyanide anions above 250 °C. Thermal treatment causes the loss of CN ions through the observation of a band at 2080 cm-1. The hexacyanoferrate (III) interlayered Mg,Al hydrotalcites decomposes above 150 °C

Recent advances in catalytic/biocatalytic conversion of greenhouse methane and carbon dioxide to methanol and other oxygenates

Methane gas has been identified as the most destructive greenhouse gas (Liu et al., 2004). It was reported that the global warming potential of methane per molecule relative to CO2 is approximately 23 on a 100-year timescale or 62 over a 20-year period (IPCC, 2001). Methane has high C-H bond energy of about 439 kJ/mol and other higher alkanes (or saturated hydrocarbons) also have a very strong C-C and C-H bonds, thus making their molecules to have no empty orbitals of low energy or filled orbitals of high energy that could readily participate in chemical reactions as is the case with unsaturated hydrocarbons such as olefins and alkynes (Crabtree, 1994; Labinger & Bercaw, 2002)..

Infrared and 13-C MAS Nuclear Magnetic Resonance Spectroscopic Study of Acetylation of Cotton

The acetylation of commercial cotton samples with acetic anhydride without solvents in the presence of about 5% 4-dimethylaminopyridine (DMAP) catalyst was followed using FTIR and 13C MAS NMR spectroscopy. This preliminary investigation was conducted in an effort to develop hydrophobic, biodegradable, cellulosic materials for subsequent application in oil spill cleanup. The FTIR results provide clear evidence for successful acetylation though the NMR results indicate that the level of acetylation is low. Nevertheless, the overall results indicate that cotton fibres are potential candidates suitable for further development via acetylation into hydrophobic sorbent materials for subsequent oil spill cleanup application. The results also indicate that de-acetylation, the reverse of the equilibrium acetylation reaction, occurred when the acetylation reaction was prolonged beyond 3 hours

The contribution of the Methanol-to-Aromatics Reaction to Benzene methylation over ZSM-5 Catalysts

The methanol to aromatics conversion is shown to contribute significantly to the benzene methylation with methanol at 400 degrees Celsius over acidic ZSM-5 catalysts but such contribution over all catalysts is negligible at 250 degrees Celsius. Benzene-only conversion shows only negligible contribution at both temperatures over the catalysts studied. However, it appears that the methanol-only conversion can be minimised, to enhance the benzene methylation with methanol (and indirectly the oxidative benzene methylation with methane), by using NaZSM-5 with highly reduced Brönsted acidity

A Raman Spectroscopic Study of Thermally Treated Glushinskite - The Natural Magnesium Oxalate Dihydrate

Raman spectroscopy has been used to study the thermal transformations of natural magnesium oxalate dihydrate known in mineralogy as glushinskite. The data obtained by Raman spectroscopy was supplemented with that of infrared emission spectroscopy. The vibrational spectroscopic data was complimented with high resolution thermogravimetric analysis combined with evolved gas mass spectrometry. TG-MS identified three mass loss steps at 146 and 397 °C. In the first mass loss step water is evolved only, in the second step carbon dioxide is evolved. The combination of Raman microscopy and a thermal stage clearly identifies the changes in the molecular structure with thermal treatment. Glushinskite is the di-hydrate phase in the temperature range up to the pre-dehydration temperature of 146 °C. Above 397 °C, magnesium oxide is formed. Infrared emission spectroscopy shows that this mineral decomposes at around 400 °C. Changes in the position and intensity of the CO and CC stretching vibrations in the Raman spectra indicate the temperature range at which these phase changes occur.

Synthesis of Mixed Oxide Catalysts Based Upon the Nickel-Copper Hydrotalcites of the type NixCu6-xCr2(OH)16(CO3).4H2O

High resolution TG coupled to a gas evolution mass spectrometer has been used to study the thermal properties of a chromium based series of Ni/Cu hydrotalcites of formulae NixCu6-xCr2(OH)16(CO3).4H2O where x varied from 6 to 0. The effect of increased Cu composition results in the increase of the endotherms and mass loss steps to higher temperatures. Evolved gas mass spectrometry shows that water is lost in a number of steps and that the interlayer carbonate anion is lost simultaneously with hydroxyl units. Differential scanning calorimetry was used to determine the heat flow steps for the thermal decomposition of the synthetic hydrotalcites. Hydrotalcites in which M2+ consist of Cu, Ni or Co form important precursors for mixed metal-oxide catalysts. The application of these mixed metal oxides is in the wet catalytic oxidation of low concentrations of retractable organics in water. Therefore, the thermal behaviour of synthetic hydrotalcites, NixCu6-xCr2(OH)16CO3.nH2O was studied by thermal analysis techniques in order to determine the correct temperatures for the synthesis of the mixed metal oxides

Spectroscopic and XRD Characterization of Zeolite Catalyst Active for the Oxidative Methylation of Benzene with Methane

The benzene methylation with methane over zeolite catalysts was previously shown in our laboratory to require the presence of oxygen. Thus, a two-step mechanism involving the intermediate formation of methanol by partial oxidation of methane followed by the methylation of benzene with methanol in the second step, was postulated. This paper now reports the results of the characterisation of the zeolite catalysts used for the oxidative benzene methylation reaction in order to provide some information about their composition, structure, properties and their behaviour before and after the reaction. The catalysts were characterised by XRD, ICP-AES, XRF, FTIR and solid state NMR. XRD results indicate that the crystalline structures of all the ZSM-5 and H-beta catalysts remained unchanged after batch reaction of benzene with methane over the catalysts in agreement with the observation that the catalysts recovered from the reactor could be reused without loss of activity. Elemental analyses and FTIR data show that as the level of metal ion exchange increases, the Brönsted acid concentration decreases but this metal ion exchange does not totally remove Brönsted acidity. FTIR results further show that only a small amount of acid sites is actually necessary for a catalyst to be active since used catalysts containing highly reduced Brönsted acidity are found to be reusable without any loss of their activity. 29Si and 27Al MAS NMR together with FTIR spectra also show that all the active zeolites catalysts contain some extra-framework octahedral aluminium in addition to the normal tetrahedral framework aluminium. The presence of this extra-lattice aluminium does not, however, have any adverse effect on the crystallinity of the catalysts both before and after oxidative benzene methylation reaction. There appears also to be no significant dealumination of the zeolite catalysts during reaction since their catalytic performance was retained after use

Using Thermally Activated Hydrotalcite For The Uptake of Phosphate From Aqueous Media

Hydrotalcites of formula Mg6Al2(OH)16(PO4).4H2O formed by intercalation with the phosphate anion as a function of pH show variation in the d-spacing attributed to the size of the hydrated anion in the interlayer. The value changes from 11.91 Å for pH 9.3, to 7.88 Å at pH 12.5. No crystalline hydrotalcites with phosphate in the interlayer were formed at pH 9.3. Thermal decomposition identifies three steps namely dehydration, dehydroxylation and some loss of carbonate during the thermal treatment. The addition of a thermally activated ZnAl-HT to a phosphate solution resulted in the uptake of the phosphate and the reformation of the hydrotalcite. The technology has the potential for water purification through anion removal