The Kozai Mechanism and the Evolution of Binary Supermassive Black Holes

We consider the dynamical evolution of bound, hierarchical triples of supermassive black holes that might be formed in the nuclei of galaxies undergoing sequential mergers. The tidal force of the outer black hole on the inner binary produces eccentricity oscillations through the Kozai mechanism, and this can substantially reduce the gravitational wave merger time of the inner binary. We numerically calculate the merger time for a wide range of initial conditions and black hole mass ratios, including the effects of octupole interactions in the triple as well as general relativistic periastron precession in the inner binary. The semimajor axes and the mutual inclination of the inner and outer binaries are the most important factors affecting the merger time. We find that for a random distribution of inclination angles and approximately equal mass black holes, it is possible to reduce the merger time of a near circular inner binary by more than a factor of ten in over thirty percent of all cases. We estimate that a typical exterior quadrupole moment from surrounding matter in the galaxy may also be sufficient to excite eccentricity oscillations in supermassive black hole binaries, and also accelerate black hole mergers

Method for characterizing the upset response of CMOS circuits using alpha-particle sensitive test circuits

A method for predicting the SEU susceptibility of a standard-cell D-latch using an alpha-particle sensitive SRAM, SPICE critical charge simulation results, and alpha-particle interaction physics. A technique utilizing test structures to quickly and inexpensively characterize the SEU sensitivity of standard cell latches intended for use in a space environment. This bench-level approach utilizes alpha particles to induce upsets in a low LET sensitive 4-k bit test SRAM. This SRAM consists of cells that employ an offset voltage to adjust their upset sensitivity and an enlarged sensitive drain junction to enhance the cell's upset rate

End-of-fabrication CMOS process monitor

A set of test 'modules' for verifying the quality of a complementary metal oxide semiconductor (CMOS) process at the end of the wafer fabrication is documented. By electrical testing of specific structures, over thirty parameters are collected characterizing interconnects, dielectrics, contacts, transistors, and inverters. Each test module contains a specification of its purpose, the layout of the test structure, the test procedures, the data reduction algorithms, and exemplary results obtained from 3-, 2-, or 1.6-micrometer CMOS/bulk processes. The document is intended to establish standard process qualification procedures for Application Specific Integrated Circuits (ASIC's)

Product assurance technology for custom LSI/VLSI electronics

The technology for obtaining custom integrated circuits from CMOS-bulk silicon foundries using a universal set of layout rules is presented. The technical efforts were guided by the requirement to develop a 3 micron CMOS test chip for the Combined Release and Radiation Effects Satellite (CRRES). This chip contains both analog and digital circuits. The development employed all the elements required to obtain custom circuits from silicon foundries, including circuit design, foundry interfacing, circuit test, and circuit qualification

Product assurance technology for procuring reliable, radiation-hard, custom LSI/VLSI electronics

Advanced measurement methods using microelectronic test chips are described. These chips are intended to be used in acquiring the data needed to qualify Application Specific Integrated Circuits (ASIC's) for space use. Efforts were focused on developing the technology for obtaining custom IC's from CMOS/bulk silicon foundries. A series of test chips were developed: a parametric test strip, a fault chip, a set of reliability chips, and the CRRES (Combined Release and Radiation Effects Satellite) chip, a test circuit for monitoring space radiation effects. The technical accomplishments of the effort include: (1) development of a fault chip that contains a set of test structures used to evaluate the density of various process-induced defects; (2) development of new test structures and testing techniques for measuring gate-oxide capacitance, gate-overlap capacitance, and propagation delay; (3) development of a set of reliability chips that are used to evaluate failure mechanisms in CMOS/bulk: interconnect and contact electromigration and time-dependent dielectric breakdown; (4) development of MOSFET parameter extraction procedures for evaluating subthreshold characteristics; (5) evaluation of test chips and test strips on the second CRRES wafer run; (6) two dedicated fabrication runs for the CRRES chip flight parts; and (7) publication of two papers: one on the split-cross bridge resistor and another on asymmetrical SRAM (static random access memory) cells for single-event upset analysis

The UV Continuum of Quasars: Models and SDSS Spectral Slopes

We measure long (2200-4000 ang) and short (1450-2200 ang) wavelength spectral slopes \alpha (F_\nu proportional to \nu^\alpha) for quasar spectra from the Sloan Digital Sky Survey. The long and short wavelength slopes are computed from 3646 and 2706 quasars with redshifts in the z=0.76-1.26 and z=1.67-2.07 ranges, respectively. We calculate mean slopes after binning the data by monochromatic luminosity at 2200 ang and virial mass estimates based on measurements of the MgII line width and 3000 ang continuum luminosity. We find little evidence for mass dependent variations in the mean slopes, but a significant luminosity dependent trend in the near UV spectral slopes is observed with larger (bluer) slopes at higher luminosities. The far UV slopes show no clear variation with luminosity and are generally lower (redder) than the near UV slopes at comparable luminosities, suggesting a slightly concave quasar continuum shape. We compare these results with Monte Carlo distributions of slopes computed from models of thin accretion disks, accounting for uncertainties in the mass estimates. The model slopes produce mass dependent trends which are larger than observed, though this conclusion is sensitive to the assumed uncertainties in the mass estimates. The model slopes are also generally bluer than observed, and we argue that reddening by dust intrinsic to the source or host galaxy may account for much of the discrepancy.Comment: To be published in ApJ, 18 pages, 10 figure

Non-LTE, Relativistic Accretion Disk Fits to 3C~273 and the Origin of the Lyman Limit Spectral Break

We fit general relativistic, geometrically thin accretion disk models with non-LTE atmospheres to near simultaneous multiwavelength data of 3C~273, extending from the optical to the far ultraviolet. Our model fits show no flux discontinuity associated with a hydrogen Lyman edge, but they do exhibit a spectral break which qualitatively resembles that seen in the data. This break arises from relativistic smearing of Lyman emission edges which are produced locally at tens of gravitational radii in the disk. We discuss the possible effects of metal line blanketing on the model spectra, as well as the substantial Comptonization required to explain the observed soft X-ray excess. Our best fit accretion disk model underpredicts the near ultraviolet emission in this source, and also has an optical spectrum which is too red. We discuss some of the remaining physical uncertainties, and suggest in particular that an extension of our models to the slim disk regime and/or including nonzero magnetic torques across the innermost stable circular orbit may help resolve these discrepancies.Comment: Accepted for publication in Ap

Non-LTE Models and Theoretical Spectra of Accretion Disks in Active Galactic Nuclei. III. Integrated Spectra for Hydrogen-Helium Disks

We have constructed a grid of non-LTE disk models for a wide range of black hole mass and mass accretion rate, for several values of viscosity parameter alpha, and for two extreme values of the black hole spin: the maximum-rotation Kerr black hole, and the Schwarzschild (non-rotating) black hole. Our procedure calculates self-consistently the vertical structure of all disk annuli together with the radiation field, without any approximations imposed on the optical thickness of the disk, and without any ad hoc approximations to the behavior of the radiation intensity. The total spectrum of a disk is computed by summing the spectra of the individual annuli, taking into account the general relativistic transfer function. The grid covers nine values of the black hole mass between M = 1/8 and 32 billion solar masses with a two-fold increase of mass for each subsequent value; and eleven values of the mass accretion rate, each a power of 2 times 1 solar mass/year. The highest value of the accretion rate corresponds to 0.3 Eddington. We show the vertical structure of individual annuli within the set of accretion disk models, along with their local emergent flux, and discuss the internal physical self-consistency of the models. We then present the full disk-integrated spectra, and discuss a number of observationally interesting properties of the models, such as optical/ultraviolet colors, the behavior of the hydrogen Lyman limit region, polarization, and number of ionizing photons. Our calculations are far from definitive in terms of the input physics, but generally we find that our models exhibit rather red optical/UV colors. Flux discontinuities in the region of the hydrogen Lyman limit are only present in cool, low luminosity models, while hotter models exhibit blueshifted changes in spectral slope.Comment: 20 pages, 31 figures, ApJ in press, spectral models are available for downloading at http://www.physics.ucsb.edu/~blaes/habk

Stability of general-relativistic accretion disks

Self-gravitating relativistic disks around black holes can form as transient structures in a number of astrophysical scenarios such as binary neutron star and black hole-neutron star coalescences, as well as the core-collapse of massive stars. We explore the stability of such disks against runaway and non-axisymmetric instabilities using three-dimensional hydrodynamics simulations in full general relativity using the THOR code. We model the disk matter using the ideal fluid approximation with a $\Gamma$-law equation of state with $\Gamma=4/3$. We explore three disk models around non-rotating black holes with disk-to-black hole mass ratios of 0.24, 0.17 and 0.11. Due to metric blending in our initial data, all of our initial models contain an initial axisymmetric perturbation which induces radial disk oscillations. Despite these oscillations, our models do not develop the runaway instability during the first several orbital periods. Instead, all of the models develop unstable non-axisymmetric modes on a dynamical timescale. We observe two distinct types of instabilities: the Papaloizou-Pringle and the so-called intermediate type instabilities. The development of the non-axisymmetric mode with azimuthal number m = 1 is accompanied by an outspiraling motion of the black hole, which significantly amplifies the growth rate of the m = 1 mode in some cases. Overall, our simulations show that the properties of the unstable non-axisymmetric modes in our disk models are qualitatively similar to those in Newtonian theory.Comment: 30 pages, 21 figure