Low temperature dielectric relaxation study of aqueous solutions of diethylsulfoxide

In the present work, dielectric spectra of mixtures of diethylsulfoxide (DESO) and water are presented, covering a concentration range of 0.2 - 0.3 molar fraction of DESO. The measurements were performed at frequencies between 1 Hz and 10 MHz and for temperatures between 150 and 300 K. It is shown that DESO/water mixtures have strong glass-forming abilities. The permittivity spectra in these mixtures reveal a single relaxation process. It can be described by the Havriliak-Negami relaxation function and its relaxation times follow the Vogel-Fulcher-Tammann law, thus showing the typical signatures of glassy dynamics. The concentration dependence of the relaxation parameters, like fragility, broadening, and glass temperature, are discussed in detail.Comment: 20 pages, 5 figure

Induced polarization of Lambda(1116) in kaon electroproduction

We have measured. the induced polarization of the Lambda(1116) in the reaction ep - \u3e e\u27 K+ Lambda, detecting the scattered e\u27 and K+ in the final state along with the proton from the decay Lambda - \u3e p pi(-). The present study used the CEBAF Large Acceptance Spectrometer (CLAS), which allowed for a large kinematic acceptance in invariant energy W (1.6 \u3c = W \u3c = 2.7 GeV) and covered the full range of the kaon production angle at an average momentum transfer Q(2) = 1.90 GeV2. In this experiment a 5.50-GeV electron beam was incident upon an unpolarized liquid-hydrogen target. We have mapped out the W and kaon production angle dependencies of the induced polarization and found striking differences from photoproduction data over most of the kinematic range studied. However, we also found that the induced polarization is essentially Q(2) independent in our kinematic domain, suggesting that somewhere below the Q(2) covered here there must be a strong Q(2) dependence. Along with previously published photo-and electroproduction cross sections and polarization observables, these data are needed for the development of models, such as effective field theories, and as input to coupled-channel analyses that can provide evidence of previously unobserved s-channel resonances

Energy Calibration of the JLab Bremsstrahlung Tagging System

In this report, we present the energy calibration of the Hall B bremsstrahlung tagging system at the Thomas Jefferson National Accelerator Facility. The calibration was performed using a magnetic pair spectrometer. The tagged photon energy spectrum was measured in coincidence with $e^+e^-$ pairs as a function of the pair spectrometer magnetic field. Taking advantage of the internal linearity of the pair spectrometer, the energy of the tagging system was calibrated at the level of $\pm 0.1$. The absolute energy scale was determined using the $e^+e^-$ rate measurements close to the end-point of the photon spectrum. The energy variations across the full tagging range were found to be $<3$ MeV.Comment: 15 pages, 12 figure

Hysteresis Effects During the Phase Transition in Solutions of Temperature Sensitive Polymers

It is demonstrated, for the first time,that well-known phase transitions induced by changes in temperature in solutions of polymers containing both hydrophilic and hydrophobic functional groups could be followed by noticeable hysteresis effects. A well-known phase transitions accompanied by a sharp change in fluid properties, in particular its optical density can be induced by many external influences, including temperature changes occurring in the solutions of polymers containing both hydrophilic and hydrophobic functional groups. Since intensification subsequent hydrophobic interactions, leading to loss of solubility of the polymer molecules, resulting, in particular, a significant increase in the turbidity of the medium and are accompanied by a pronounced hysteresis phenomena. Hysteresis phenomena in the processes of molecular-scale play an important theoretical and practical interest in linkage with the development of advanced nano-level technology. In particular, the issue of the development of molecular "trigger" switches, and other analog electronic systems, implemented on submolecular level was actively discussed. In fact, under the same physical conditions of the environment of macromolecules system can be in two different states, which resolves the issue of programming such molecules. State of these polymers depends on their way of formation and thermodynamic variables. Observed effect could be utilized directly for information recording into the structure on the basis of stimulus-sensitive macromolecular chains. In fact, it is a first step towards creating memory of quasi-biological elements

A New Measurement of the π0\pi^0 Radiative Decay Width

High precision measurements of the differential cross sections for $\pi^0$ photoproduction at forward angles for two nuclei, $^{12}$C and $^{208}$Pb, have been performed for incident photon energies of 4.9 - 5.5 GeV to extract the ${\pi^0 \to \gamma\gamma}$ decay width. The experiment was done at Jefferson Lab using the Hall B photon tagger and a high-resolution multichannel calorimeter. The ${\pi^0 \to \gamma\gamma}$ decay width was extracted by fitting the measured cross sections using recently updated theoretical models for the process. The resulting value for the decay width is $\Gamma{(\pi^0 \to \gamma\gamma)} = 7.82 \pm 0.14 ~({\rm stat.}) \pm 0.17 ~({\rm syst.}) ~{\rm eV}$. With the 2.8% total uncertainty, this result is a factor of 2.5 more precise than the current PDG average of this fundamental quantity and it is consistent with current theoretical predictions.Comment: 4 pages, 5 figure

Особенности использования статистического метода стабилизации частоты генераторов в распределенных информационно-измерительных системах

The article deals with the problems of frequency stabilization of generators in distributed information-measuring systems on the basis of the static frequency stabilization method. The examples of similar systems are given. The necessity to ensure high stability of signal frequency generated by subscribers to improve the efficiency of the stated systems is noted. Two main features of applying the static frequency stabilization method are stated. The first one is determined with a delay in signal input into the device for estimating the frequency-time signal parameters in relation to the signal phase measurement interval. The second feature involves the entry delay of the formed control signal of generator frequency correction. It is shown that the mentioned features lead to divergence of the current variation of generator frequency and the value under correction, obtained considering the delay. The description of information signals enabling to specify a mathematical model of the process of assessment forming of the information signal frequency variation, taking into account the mentioned factors, is offered. It is shown that the possibility of using a statistical method to stabilize the frequency of generators in distributed informationmeasuring systems is determined not only with the values of nominal frequencies and relative instabilities of generators included into the information-measuring system, but also by the autocorrelation function of a random process describing the change of information signal frequency. In case of small time delays between the evaluation of information signal frequency and frequency stabilization, the use of the method to be considered allows to reduce the relative instability of information signal frequency. When time delays are greater than the correlation interval, the use of the statistical method does not lead to the change of relative instability of information signal frequency. Within the correlation interval, the use of the statistical method of frequency stabilization can cause depending on the autocorrelation function values both decrease and increase of the relative information signal frequency instability.В статье рассмотрены вопросы стабилизации частоты генераторов в распределенных информационно-измерительных системах на основе использования метода статической стабилизации частоты. Приведены примеры таких систем и отмечена необходимость обеспечения высокой стабильности частоты формируемых абонентами сигналов для повышения эффективности функционирования указанных систем. Отмечены две основные особенности применения метода статистической стабилизации частоты. Первая определяется задержкой поступления сигнала в устройство оценивания частотно-временных параметров сигнала по отношению к интервалу измерения фазы сигнала. Вторая особенность связана с задержкой прихода сформированного управляющего сигнала коррекции частоты генератора. Показано, что отмеченные особенности приводят к несовпадению текущего отклонения частоты генератора и корректируемого значения, полученного с учетом задержки. Предложено описание информационных сигналов, позволяющих уточнить математическую модель процесса формирования оценки отклонения частоты информационного сигнала с учетом указанных факторов. Показано, что возможность использования статистического метода стабилизации частоты генераторов в распределенных информационно-измерительных системах определяется не только значениями номинальных частот и относительных нестабильностей генераторов, входящих в состав информационно-измерительной системы, но и автокорреляционной функцией случайного процесса, описывающего изменение частоты информационного сигнала. При малых временных задержках между оцениванием частоты информационного сигнала и стабилизацией частоты использование рассматриваемого метода позволяет уменьшить относительную нестабильность частоты информационного сигнала. При временных задержках больше интервала корреляции использование статистического метода не приводит к изменению относительной нестабильности частоты информационного сигнала. В пределах интервала корреляции использование статистического метода стабилизации частоты может приводить в зависимости от значений автокорреляционной функции как к уменьшению, так и увеличению относительной нестабильности частоты информационного сигнала