Extraction of vocal-tract system characteristics from speechsignals

We propose methods to track natural variations in the characteristics of the vocal-tract system from speech signals. We are especially interested in the cases where these characteristics vary over time, as happens in dynamic sounds such as consonant-vowel transitions. We show that the selection of appropriate analysis segments is crucial in these methods, and we propose a selection based on estimated instants of significant excitation. These instants are obtained by a method based on the average group-delay property of minimum-phase signals. In voiced speech, they correspond to the instants of glottal closure. The vocal-tract system is characterized by its formant parameters, which are extracted from the analysis segments. Because the segments are always at the same relative position in each pitch period, in voiced speech the extracted formants are consistent across successive pitch periods. We demonstrate the results of the analysis for several difficult cases of speech signals

OMP-type Algorithm with Structured Sparsity Patterns for Multipath Radar Signals

A transmitted, unknown radar signal is observed at the receiver through more than one path in additive noise. The aim is to recover the waveform of the intercepted signal and to simultaneously estimate the direction of arrival (DOA). We propose an approach exploiting the parsimonious time-frequency representation of the signal by applying a new OMP-type algorithm for structured sparsity patterns. An important issue is the scalability of the proposed algorithm since high-dimensional models shall be used for radar signals. Monte-Carlo simulations for modulated signals illustrate the good performance of the method even for low signal-to-noise ratios and a gain of 20 dB for the DOA estimation compared to some elementary method

Estimation of glottal closure instants in voiced speech using the DYPSA algorithm

Published versio

Software Defined Radio Implementation of Carrier and Timing Synchronization for Distributed Arrays

The communication range of wireless networks can be greatly improved by using distributed beamforming from a set of independent radio nodes. One of the key challenges in establishing a beamformed communication link from separate radios is achieving carrier frequency and sample timing synchronization. This paper describes an implementation that addresses both carrier frequency and sample timing synchronization simultaneously using RF signaling between designated master and slave nodes. By using a pilot signal transmitted by the master node, each slave estimates and tracks the frequency and timing offset and digitally compensates for them. A real-time implementation of the proposed system was developed in GNU Radio and tested with Ettus USRP N210 software defined radios. The measurements show that the distributed array can reach a residual frequency error of 5 Hz and a residual timing offset of 1/16 the sample duration for 70 percent of the time. This performance enables distributed beamforming for range extension applications.Comment: Submitted to 2019 IEEE Aerospace Conferenc

Development and Demonstration of a TDOA-Based GNSS Interference Signal Localization System

Background theory, a reference design, and demonstration results are given for a Global Navigation Satellite System (GNSS) interference localization system comprising a distributed radio-frequency sensor network that simultaneously locates multiple interference sources by measuring their signals’ time difference of arrival (TDOA) between pairs of nodes in the network. The end-to-end solution offered here draws from previous work in single-emitter group delay estimation, very long baseline interferometry, subspace-based estimation, radar, and passive geolocation. Synchronization and automatic localization of sensor nodes is achieved through a tightly-coupled receiver architecture that enables phase-coherent and synchronous sampling of the interference signals and so-called reference signals which carry timing and positioning information. Signal and crosscorrelation models are developed and implemented in a simulator. Multiple-emitter subspace-based TDOA estimation techniques are developed as well as emitter identification and localization algorithms. Simulator performance is compared to the CramérRao lower bound for single-emitter TDOA precision. Results are given for a test exercise in which the system accurately locates emitters broadcasting in the amateur radio band in Austin, TX.Aerospace Engineering and Engineering Mechanic