Upper Bound on the Capacity of Discrete-Time Wiener Phase Noise Channels

A discrete-time Wiener phase noise channel with an integrate-and-dump multi-sample receiver is studied. An upper bound to the capacity with an average input power constraint is derived, and a high signal-to-noise ratio (SNR) analysis is performed. If the oversampling factor grows as $\text{SNR}^\alpha$ for $0\le \alpha \le 1$, then the capacity pre-log is at most $(1+\alpha)/2$ at high SNR.Comment: 5 pages, 1 figure. To be presented at IEEE Inf. Theory Workshop (ITW) 201

Capacity Outer Bound and Degrees of Freedom of Wiener Phase Noise Channels with Oversampling

The discrete-time Wiener phase noise channel with an integrate-and-dump multi-sample receiver is studied. A novel outer bound on the capacity with an average input power constraint is derived as a function of the oversampling factor. This outer bound yields the degrees of freedom for the scenario in which the oversampling factor grows with the transmit power $P$ as $P^{\alpha}$. The result shows, perhaps surprisingly, that the largest pre-log that can be attained with phase modulation at high signal-to-noise ratio is at most $1/4$.Comment: 5 pages, 1 figure, Submitted to Intern. Workshop Inf. Theory (ITW) 201

On the Capacity of the Wiener Phase-Noise Channel: Bounds and Capacity Achieving Distributions

In this paper, the capacity of the additive white Gaussian noise (AWGN) channel, affected by time-varying Wiener phase noise is investigated. Tight upper and lower bounds on the capacity of this channel are developed. The upper bound is obtained by using the duality approach, and considering a specific distribution over the output of the channel. In order to lower-bound the capacity, first a family of capacity-achieving input distributions is found by solving a functional optimization of the channel mutual information. Then, lower bounds on the capacity are obtained by drawing samples from the proposed distributions through Monte-Carlo simulations. The proposed capacity-achieving input distributions are circularly symmetric, non-Gaussian, and the input amplitudes are correlated over time. The evaluated capacity bounds are tight for a wide range of signal-to-noise-ratio (SNR) values, and thus they can be used to quantify the capacity. Specifically, the bounds follow the well-known AWGN capacity curve at low SNR, while at high SNR, they coincide with the high-SNR capacity result available in the literature for the phase-noise channel.Comment: IEEE Transactions on Communications, 201

Capacity of SIMO and MISO Phase-Noise Channels with Common/Separate Oscillators

In multiple antenna systems, phase noise due to instabilities of the radio-frequency (RF) oscillators, acts differently depending on whether the RF circuitries connected to each antenna are driven by separate (independent) local oscillators (SLO) or by a common local oscillator (CLO). In this paper, we investigate the high-SNR capacity of single-input multiple-output (SIMO) and multiple-output single-input (MISO) phase-noise channels for both the CLO and the SLO configurations. Our results show that the first-order term in the high-SNR capacity expansion is the same for all scenarios (SIMO/MISO and SLO/CLO), and equal to $0.5\ln (\rho)$, where $\rho$ stands for the SNR. On the contrary, the second-order term, which we refer to as phase-noise number, turns out to be scenario-dependent. For the SIMO case, the SLO configuration provides a diversity gain, resulting in a larger phase-noise number than for the CLO configuration. For the case of Wiener phase noise, a diversity gain of at least $0.5 \ln(M)$ can be achieved, where $M$ is the number of receive antennas. For the MISO, the CLO configuration yields a higher phase-noise number than the SLO configuration. This is because with the CLO configuration one can obtain a coherent-combining gain through maximum ratio transmission (a.k.a. conjugate beamforming). This gain is unattainable with the SLO configuration.Comment: IEEE Transactions on Communication

Capacity bounds for MIMO microwave backhaul links affected by phase noise

We present bounds and a closed-form high-SNR expression for the capacity of multiple-antenna systems affected by Wiener phase noise. Our results are developed for the scenario where a single oscillator drives all the radio-frequency circuitries at each transceiver (common oscillator setup), the input signal is subject to a peak-power constraint, and the channel matrix is deterministic. This scenario is relevant for line-of-sight multiple-antenna microwave backhaul links with sufficiently small antenna spacing at the transceivers. For the 2 by 2 multiple-antenna case, for a Wiener phase-noise process with standard deviation equal to 6 degrees, and at the medium/high SNR values at which microwave backhaul links operate, the upper bound reported in the paper exhibits a 3 dB gap from a lower bound obtained using 64-QAM. Furthermore, in this SNR regime the closed-form high-SNR expression is shown to be accurate.Comment: 10 pages, 2 figures, to appear in IEEE Transactions on Communication

Lower Bound on the Capacity of Continuous-Time Wiener Phase Noise Channels

A continuous-time Wiener phase noise channel with an integrate-and-dump multi-sample receiver is studied. A lower bound to the capacity with an average input power constraint is derived, and a high signal-to-noise ratio (SNR) analysis is performed. The capacity pre-log depends on the oversampling factor, and amplitude and phase modulation do not equally contribute to capacity at high SNR.Comment: Extended version of a paper submitted to ISIT 2015. 9 pages and 1 figure. arXiv admin note: text overlap with arXiv:1411.039

Phase Modulation for Discrete-time Wiener Phase Noise Channels with Oversampling at High SNR

A discrete-time Wiener phase noise channel model is introduced in which multiple samples are available at the output for every input symbol. A lower bound on the capacity is developed. At high signal-to-noise ratio (SNR), if the number of samples per symbol grows with the square root of the SNR, the capacity pre-log is at least 3/4. This is strictly greater than the capacity pre-log of the Wiener phase noise channel with only one sample per symbol, which is 1/2. It is shown that amplitude modulation achieves a pre-log of 1/2 while phase modulation achieves a pre-log of at least 1/4.Comment: To appear in ISIT 201

Tight Upper and Lower Bounds to the Information Rate of the Phase Noise Channel

Numerical upper and lower bounds to the information rate transferred through the additive white Gaussian noise channel affected by discrete-time multiplicative autoregressive moving-average (ARMA) phase noise are proposed in the paper. The state space of the ARMA model being multidimensional, the problem cannot be approached by the conventional trellis-based methods that assume a first-order model for phase noise and quantization of the phase space, because the number of state of the trellis would be enormous. The proposed lower and upper bounds are based on particle filtering and Kalman filtering. Simulation results show that the upper and lower bounds are so close to each other that we can claim of having numerically computed the actual information rate of the multiplicative ARMA phase noise channel, at least in the cases studied in the paper. Moreover, the lower bound, which is virtually capacity-achieving, is obtained by demodulation of the incoming signal based on a Kalman filter aided by past data. Thus we can claim of having found the virtually optimal demodulator for the multiplicative phase noise channel, at least for the cases considered in the paper.Comment: 5 pages, 2 figures. Accepted for presentation at ISIT 201