Index to 1984 NASA Tech Briefs, volume 9, numbers 1-4

Short announcements of new technology derived from the R&D activities of NASA are presented. These briefs emphasize information considered likely to be transferrable across industrial, regional, or disciplinary lines and are issued to encourage commercial application. This index for 1984 Tech B Briefs contains abstracts and four indexes: subject, personal author, originating center, and Tech Brief Number. The following areas are covered: electronic components and circuits, electronic systems, physical sciences, materials, life sciences, mechanics, machinery, fabrication technology, and mathematics and information sciences

The role of aggregates in the thermal stability of Mg-PSZ refractories for vacuum induction melting

Mg-PSZ refractories used as vacuum induction melting crucibles are particle-reinforced composites with aggregate and matrix phases comprising fused zirconia. Three commercial varieties were cycled eight times to service temperatures and their microstructural and thermomechanical evolution investigated, with focus placed on the aggregate populations. Two refractories, with large aggregates of similar size, were found to retain stiffness after cycling but in the refractory containing aggregates with high stabiliser levels, reaction between the stabiliser and Al and Si impurities produced secondary phases. Volume changes accompanying formation of these phases, and subsequent thermal expansion mismatches, led to aggregate break-up with consequent reductions in refractory toughness and strength. Secondary phases developed only rarely in the aggregates (with lower levels of stabiliser) of the second refractory. These aggregates remained intact and the refractory retained its toughness and strength. A third refractory contained small, unstabilised aggregates in a stabilised matrix and the strain mismatches that ensued during polymorphic transformation damaged microstructural interfaces. Refractory stiffness halved within eight cycles and toughness and strength were lost. All three refractories displayed R-curve behaviour and quasi-stable fracture curves were observed during bend tests. The study shows that when using fused zirconia aggregates to design refractories, engineers need to i) limit stabiliser concentrations - a difference of just ±1 wt% Mg (in the presence of impurity elements) may determine whether secondary phase formation occurs and ii) eliminate alumina and silica impurities when possible through substitution of zircon sand with baddeleyite as the source for fused zirconia.Open Acces

Index to NASA Tech Briefs, 1975

This index contains abstracts and four indexes--subject, personal author, originating Center, and Tech Brief number--for 1975 Tech Briefs

The materials processing research base of the Materials Processing Center

The goals and activities of the center are discussed. The center activities encompass all engineering materials including metals, ceramics, polymers, electronic materials, composites, superconductors, and thin films. Processes include crystallization, solidification, nucleation, and polymer synthesis

Effect of the solid precursors on the formation of nanosized TiBx powders in RF thermal plasma

Continuous synthesis of TiBx (x≈0.5-2) nanoparticles from various low cost solid precursors such as titanium and titanium dioxide admixed with boron and/or carbon in radiofrequency thermal plasma was studied. Feasibility of TiB2 formation was predicted by thermodynamic equilibrium calculations in the 500 - 7500 K temperature range. In all the investigated system high temperature reactions yielded nanometer-sized TiBx powders with a mean size varying between 13 and 83 nm. Among the synthesized products in addition to TiBx, oxidized precursor residues were also found in smaller quantities. Although addition of carbon to the precursors could not completely prevent surface oxidation of boride particles, it contributed to the reduction of the mean particle size of the formed TiB2

Nonterrestrial utilization of materials: Automated space manufacturing facility

Four areas related to the nonterrestrial use of materials are included: (1) material resources needed for feedstock in an orbital manufacturing facility, (2) required initial components of a nonterrestrial manufacturing facility, (3) growth and productive capability of such a facility, and (4) automation and robotics requirements of the facility