Linear Precoders for Non-Regenerative Asymmetric Two-way Relaying in Cellular Systems

Two-way relaying (TWR) reduces the spectral-efficiency loss caused in conventional half-duplex relaying. TWR is possible when two nodes exchange data simultaneously through a relay. In cellular systems, data exchange between base station (BS) and users is usually not simultaneous e.g., a user (TUE) has uplink data to transmit during multiple access (MAC) phase, but does not have downlink data to receive during broadcast (BC) phase. This non-simultaneous data exchange will reduce TWR to spectrally-inefficient conventional half-duplex relaying. With infrastructure relays, where multiple users communicate through a relay, a new transmission protocol is proposed to recover the spectral loss. The BC phase following the MAC phase of TUE is now used by the relay to transmit downlink data to another user (RUE). RUE will not be able to cancel the back-propagating interference. A structured precoder is designed at the multi-antenna relay to cancel this interference. With multiple-input multiple-output (MIMO) nodes, the proposed precoder also triangulates the compound MAC and BC phase MIMO channels. The channel triangulation reduces the weighted sum-rate optimization to power allocation problem, which is then cast as a geometric program. Simulation results illustrate the effectiveness of the proposed protocol over conventional solutions.Comment: 30 pages, 7 figures, submitted to IEEE Transactions on Wireless Communication

Virtual full-duplex multiple-input multiple-output relaying in the presence of inter-relay interference

Driven by the increasing demand for wireless broadband, low latency and power-efficient networks, multiple-input multiple-output (MIMO) full-duplex relaying (FDR) schemes have gained much attention in recent years. However, the performance of FDR schemes is impaired by sophisticated self-interference suppression techniques. As such, MIMO virtual FDR (VFDR) schemes have been considered as practical alternatives to recover spectral efficiency loss in half-duplex relays (HDR) without the need for sophisticated self-interference suppression algorithms. Successive relaying (SR) scheme is one of the VFDR techniques which uses a pair of HD relays that alternate between reception and retransmission of the source information to the destination. The performance of the SR based VFDR scheme is affected by inter-relay interference (IRI) due to the concurrent transmission of the source and relay nodes. The interference in VFDR schemes is conventionally treated as a degrading factor on the information decoding receivers resulting in the design of several interference avoidance and cancellation techniques. On the contrary, this thesis developed several VFDR schemes which exploit the interference to achieve performance improvement. In this study, interference management techniques, transmit/receive beamforming matrices, power allocation and joint optimisation algorithms were developed. First, a reliable MIMO VFDR scheme in the presence of IRI was designed, where the IRI was exploited for reliability improvements. The results showed significant reliability improvement over the existing schemes. Second, a joint power allocation for MIMO VFDR schemes under network power constraint was developed. The power allocation problem in the presence of IRI was formulated based on primal-dual algorithm. The results showed that the joint optimisation algorithm can efficiently utilise the network power when compared with the conventional approach. Third, simultaneous wireless information and power transfer (SWIPT) in MIMO VFDR system was proposed, where the transmit beamforming matrices which optimise the achievable rate and harvested energy at the relays were jointly designed. The results showed that the interference energy can be harnessed to improve the SWIPT system throughput. Finally, a joint optimisation of the power split and relay position in SWIPT MIMO VFDR network were investigated. Results showed that the joint optimisation of the power split and distance factors can greatly improve the system outage performance. The analytical and numerical results in the research showed that IRI can be exploited to improve the throughput, reliability and energy harvesting of a wireless communication system. The results also showed a minimum achievable rate improvement of 80% over the HDR schemes and a reliability of 100% over the FDR schemes

Non-coherent successive relaying and cooperation: principles, designs, and applications

Cooperative communication is capable of forming a virtual antenna array for each node (user) in a network by allowing the nodes (users) to relay the messages of others to the destination. Such a relay aided network may be viewed as a distributed multiple-input multiple-output (MIMO) system relying on the spatially distributed single antennas of the cooperating mobiles, which avoids the correlation of the antenna elements routinely encountered in conventional MIMO systems and hence attains the maximum achievable diversity gain. Therefore, the family of cooperative communication techniques may be regarded as a potential solution for future wireless networks. However, constrained by the half-duplex transmit/receive mode of most practical transceivers, the cooperative networks may impose a severe 50% throughput loss. As a remedy, successive relaying can be employed, which is capable of mimicking a full-duplex relay and thereby recovering much of the 50% throughput loss. Furthermore, for the sake of bypassing power-hungry and potentially excessive-complexity channel estimation, noncoherent detection techniques may be employed for multiple-antenna aided systems, because estimating all the associated channels may become unrealistic. Explicitly, the mobile-stations acting as relays cannot be realistically expected to estimate the source-to-relay channels. In order to motivate further research on noncoherent successive relaying aided systems, a comprehensive review of its basic concepts, fundamental principles, practical transceiver designs and open challenges is provide

Physical-Layer Security with Full-Duplex Transceivers and Multiuser Receiver at Eve

Full-duplex communication enables simultaneous transmission from both ends of a communication link, thereby promising significant performance gains. Generally, it has been shown that the throughput and delay gains of full-duplex communication are somewhat limited in realistic network settings, leading researchers to study other possible applications that can accord higher gains. The potential of full-duplex communication in improving the physical-layer security of a communication link is investigated in this contribution. We specifically present a thorough analysis of the achievable ergodic secrecy rate and the secrecy degrees of freedom with full-duplex communication in the presence of a half-duplex eavesdropper node, with both single-user decoding and multi-user decoding capabilities. For the latter case, an eavesdropper with successive interference cancellation and joint decoding capabilities is assumed. Irrespective of the eavesdropper capabilities and channel strengths, the ergodic secrecy rate with full-duplex communication is found to grow linearly with the log of the direct channel signal-to-noise-ratio (SNR) as opposed to the flattened out secrecy rate with conventional half-duplex communication. Consequently, the secrecy degrees of freedom with full-duplex is shown to be two as opposed to that of zero in half-duplex mode

A Survey of Physical Layer Security Techniques for 5G Wireless Networks and Challenges Ahead

Physical layer security which safeguards data confidentiality based on the information-theoretic approaches has received significant research interest recently. The key idea behind physical layer security is to utilize the intrinsic randomness of the transmission channel to guarantee the security in physical layer. The evolution towards 5G wireless communications poses new challenges for physical layer security research. This paper provides a latest survey of the physical layer security research on various promising 5G technologies, including physical layer security coding, massive multiple-input multiple-output, millimeter wave communications, heterogeneous networks, non-orthogonal multiple access, full duplex technology, etc. Technical challenges which remain unresolved at the time of writing are summarized and the future trends of physical layer security in 5G and beyond are discussed.Comment: To appear in IEEE Journal on Selected Areas in Communication