8,633 research outputs found
Nonlinearity and Noise Effects in Multi-level Signal Millimeter-Wave over Fiber Transmission using Single- and Dual-Wavelength Modulation
We transmit multilevel quadrature amplitude modulation (QAM) data-IEEE 802.16 schemes-at 20 MSps and an orthogonal frequency-division multiplexing (OFDM) 802.11 g signal (54 Mbps) with a 25 GHz millimeter-wave over fiber system, which employs a dual wavelength source, over 20 km of single mode fiber. Downlink data transmission is successfully demonstrated over both optical and wireless (up to 12 m) paths with good error vector magnitude. An analysis of two different schemes, in which data is applied to one (single) and both (dual) of the wavelengths of a dual wavelength source, is carried out. The system performance is analyzed through simulation and a good match with experimental results is obtained. The analysis investigates the impact of Mach-Zehnder modulator (MZM) and RF amplifier nonlinearity and various noise sources, such as laser relative intensity noise, amplified spontaneous emission, thermal, and shot noise. A comparison of single carrier QAM IEEE 802.16 and OFDM in terms of their sensitivity to the distortions from MZM and RF amplifier nonlinearity is also presented
Performance Comparison of Dual Connectivity and Hard Handover for LTE-5G Tight Integration in mmWave Cellular Networks
MmWave communications are expected to play a major role in the Fifth
generation of mobile networks. They offer a potential multi-gigabit throughput
and an ultra-low radio latency, but at the same time suffer from high isotropic
pathloss, and a coverage area much smaller than the one of LTE macrocells. In
order to address these issues, highly directional beamforming and a very
high-density deployment of mmWave base stations were proposed. This Thesis aims
to improve the reliability and performance of the 5G network by studying its
tight and seamless integration with the current LTE cellular network. In
particular, the LTE base stations can provide a coverage layer for 5G mobile
terminals, because they operate on microWave frequencies, which are less
sensitive to blockage and have a lower pathloss. This document is a copy of the
Master's Thesis carried out by Mr. Michele Polese under the supervision of Dr.
Marco Mezzavilla and Prof. Michele Zorzi. It will propose an LTE-5G tight
integration architecture, based on mobile terminals' dual connectivity to LTE
and 5G radio access networks, and will evaluate which are the new network
procedures that will be needed to support it. Moreover, this new architecture
will be implemented in the ns-3 simulator, and a thorough simulation campaign
will be conducted in order to evaluate its performance, with respect to the
baseline of handover between LTE and 5G.Comment: Master's Thesis carried out by Mr. Michele Polese under the
supervision of Dr. Marco Mezzavilla and Prof. Michele Zorz
Massive MIMO is a Reality -- What is Next? Five Promising Research Directions for Antenna Arrays
Massive MIMO (multiple-input multiple-output) is no longer a "wild" or
"promising" concept for future cellular networks - in 2018 it became a reality.
Base stations (BSs) with 64 fully digital transceiver chains were commercially
deployed in several countries, the key ingredients of Massive MIMO have made it
into the 5G standard, the signal processing methods required to achieve
unprecedented spectral efficiency have been developed, and the limitation due
to pilot contamination has been resolved. Even the development of fully digital
Massive MIMO arrays for mmWave frequencies - once viewed prohibitively
complicated and costly - is well underway. In a few years, Massive MIMO with
fully digital transceivers will be a mainstream feature at both sub-6 GHz and
mmWave frequencies. In this paper, we explain how the first chapter of the
Massive MIMO research saga has come to an end, while the story has just begun.
The coming wide-scale deployment of BSs with massive antenna arrays opens the
door to a brand new world where spatial processing capabilities are
omnipresent. In addition to mobile broadband services, the antennas can be used
for other communication applications, such as low-power machine-type or
ultra-reliable communications, as well as non-communication applications such
as radar, sensing and positioning. We outline five new Massive MIMO related
research directions: Extremely large aperture arrays, Holographic Massive MIMO,
Six-dimensional positioning, Large-scale MIMO radar, and Intelligent Massive
MIMO.Comment: 20 pages, 9 figures, submitted to Digital Signal Processin
Development of Wireless Techniques in Data and Power Transmission - Application for Particle Physics Detectors
Wireless techniques have developed extremely fast over the last decade and
using them for data and power transmission in particle physics detectors is not
science- fiction any more. During the last years several research groups have
independently thought of making it a reality. Wireless techniques became a
mature field for research and new developments might have impact on future
particle physics experiments. The Instrumentation Frontier was set up as a part
of the SnowMass 2013 Community Summer Study [1] to examine the instrumentation
R&D for the particle physics research over the coming decades: {\guillemotleft}
To succeed we need to make technical and scientific innovation a priority in
the field {\guillemotright}. Wireless data transmission was identified as one
of the innovations that could revolutionize the transmission of data out of the
detector. Power delivery was another challenge mentioned in the same report. We
propose a collaboration to identify the specific needs of different projects
that might benefit from wireless techniques. The objective is to provide a
common platform for research and development in order to optimize effectiveness
and cost, with the aim of designing and testing wireless demonstrators for
large instrumentation systems
Enabling rural broadband via TV "white space"
The use of multiple frequency bands within a wireless network allows the advantages of each band to be exploited. In this paper we discuss how HopScotch, a rural wireless broadband access test bed running in the Scottish Highlands and Islands, uses both 5 GHz and ultra high frequency "white space" bands to offer large data rates and expansive coverage whilst reducing the number of base stations or required transmission power. This reduction in energy consumption allows HopScotch to provide a low-cost and green solution for rural broadband delivery
- âŠ