Enhanced snr-based admission control algorithm for vehicular ad-hoc network

Vehicular Ad-hoc Network (VANET) becomes a fundamental subcategory of mobile ad-hoc networks that provides vehicles to communicate with each other and with roadside infrastructure smartly. Data traffic in VANET can be categorized into safety and non-safety, where safety is a very critical point and non-safety is related to entertainment. Various VANET performance challenges are considered in terms of Quality of Service (QoS) which cause performance degradation as performance anomaly where high rates of vehicles wait for the low rates of vehicle transmitting time and starvation problem where some vehicles cannot transfer their data. Three main achievements have been accomplished. Starting with the impact of the increasing vehicle speed on performance anomaly problem consequences has been investigated. Followed by high-speed effects on data delivery is illustrated and how 802.11p has outperformed 802.11 in terms of data delivery is also demonstrated. Lastly, starvation problem is investigated where results showed increased data loss when vehicle nodes unable to deliver data correctly. Finally, a QoS-aware Signal to Noise Ratio (SNR) admission control mechanism (QASAC) is proposed to handle the performance anomaly problem while maintaining the QoS levels for high and low traffics. This can result in wasting throughput and cause data loss. The investigation results show that 802.11p has enhanced the number of dropped packets up to 70%. Also, the 802.11p end to end delay has decreased up to 12% less than the results of the 802.11 MAC protocol. The packet delivery ratio has been enhanced by up to 41% by 802.11p. The starvation problem investigation phase shows that 802.11p perform better than 802.11 which mainly affected by the increased speed of the vehicle. QASAC assigned different SNR values to different vehicles group based on the sending SNR values and in each group. Unlike recently proposed admission control in VANET networks, the proposed architecture differentiate between both high priority and low priority traffic QASAC has been compared against the latest SNR based admission control mechanism. QASAC has enhanced the performance of data delivery up to 23% in terms of data dropping rates for high priority traffic

Control-theoretic approaches for efficient transmission on IEEE 802.11e wireless networks

With the increasing use of multimedia applications on the wireless network, the functionalities of the IEEE 802.11 WLAN was extended to allow traffic differentiation so that priority traffic gets quicker service time depending on their Quality of Service (QoS) requirements. The extended functionalities contained in the IEEE Medium Access Control (MAC) and Physical Layer (PHY) Specifications, i.e. the IEEE 802.11e specifications, are recommended values for channel access parameters along traffic lines and the channel access parameters are: the Minimum Contention Window CWmin, Maximum Contention Window CWmax, Arbitration inter-frame space number, (AIFSN) and the Transmission Opportunity (TXOP). These default Enhanced Distributed Channel Access (EDCA) contention values used by each traffic type in accessing the wireless medium are only recommended values which could be adjusted or changed based on the condition of number of associated nodes on the network. In particular, we focus on the Contention Window (CW) parameter and it has been shown that when the number of nodes on the network is small, a smaller value of CWmin should be used for channel access in order to avoid underutilization of channel time and when the number of associated nodes is large, a larger value of CWmin should be used in order to avoid large collisions and retransmissions on the network. Fortunately, allowance was made for these default values to be adjusted or changed but the challenge has been in designing an algorithm that constantly and automatically tunes the CWmin value so that the Access Point (AP) gives out the right CWmin value to be used on the WLAN and this value should be derived based on the level of activity experienced on the network or predefined QoS constraints while considering the dynamic nature of the WLAN. In this thesis, we propose the use of feedback based control and we design a controller for wireless medium access. The controller will give an output which will be the EDCA CWmin value to be used by contending stations/nodes in accessing the medium and this value will be based on current WLAN conditions. We propose the use of feedback control due to its established mathematical concepts particularly for single-input-single-output systems and multi-variable systems which are scenarios that apply to the WLAN