21,125 research outputs found

    Salt tectonics glossary

    Get PDF
    The present glossary is intended to be used together with and complementary of the "Short Course on Salt Tectonics" enclosed in the same Sub-Community/Collection

    South Atlantic continental margins of Africa: a comparison of the tectonic vs climate interplay on the evolution of equatorial west Africa and SW Africa margins

    Full text link
    The comparative review of 2 representative segments of Africa continental margin: the equatorial western Africa and the SW Africa margins, helps in analysing the main controlling factors on their development. Early Cretaceous active rifting S of the Walvis Ridge resulted in the formation of the SW Africa volcanic margin. The non-volcanic rifting N of the Walvis ridge, led to the formation of the equatorial western Africa margin, with thick and extensive, synrift basins. Regressive erosion of SW Africa prominent shoulder uplift accounts for high clastic sedimentation rate in Late Cretaceous - Eocene, while dominant carbonate production on equatorial western Africa shelf suggests little erosion of a low hinterland. The early Oligocene climate change had contrasted response in both margins. Emplacement of the Congo deep-sea fan reflects increased erosion in equatorial Africa, under the influence of wet climate, whereas establishment of an arid climate over SW Africa induced a drastic decrease of denudation, and thus reduced sedimentation on the margin. Neogene emplacement of the African superswell beneath S. Africa renewed onshore uplift on both margins, but it accelerated erosion only in the Congo catchment, due to wetter climate. Neogene high sedimentation rate reactivated gravitational tectonics that had remained quiescent since late Cretaceous

    Present-day stress orientations and tectonic provinces of the NW Borneo collisional margin

    Get PDF
    Extent: 15p.Borehole failure observed on image and dipmeter logs from 55 petroleum wells across the NW Borneo collisional margin were used to determine maximum horizontal stress (σH) orientations; combined with seismic and outcrop data, they define seven tectonic provinces. The Baram Delta–Deepwater Fold-Thrust Belt exhibits three tectonic provinces: its inner shelf inverted province (σH is NW-SE, margin-normal), its outer shelf extension province (σH is NE-SW, margin-parallel), and its slope to basin floor compression province (σH is NW-SE, margin-normal). In the inverted province, σH reflects inversion of deltaic normal faults. The σH orientations in the extension and compression provinces reflect deltaic gravitational tectonics. The shale and minibasin provinces have been recognized in offshore Sabah. In the shale province, σH is N010°E, which aligns around the boundary of a massif of mobile shale. Currently, no data are available to determine σH in the minibasin province. In the Balingian province, σH is ESE-WNW, reflecting ESE absolute Sunda plate motions due to the absence of a thick detachment seen elsewhere in NW Borneo. The Central Luconia province demonstrates poorly constrained and variable σH orientations. These seven provinces result from the heterogeneous structural and stratigraphic development of the NW Borneo margin and formed due to complex collisional tectonics and the varied distribution and thicknesses of stratigraphic packages.Rosalind C. King, Mark R. P. Tingay, Richard R. Hillis, Christopher K. Morley, and James Clar

    A study of tectonic activity in the Basin-Range Province and on the San Andreas Fault. No. 1: Kinematics of Basin-Range intraplate extension

    Get PDF
    Strain rates assessed from brittle fracture and total brittle-ductile deformation measured from geodetic data were compared to estimates of paleo-strain from Quaternary geology for the intraplate Great Basin part of the Basin-Range, western United States. These data provide an assessment of the kinematics and mode of lithospheric extension that the western U.S. Cordillera has experienced from the past few million years to the present. Strain and deformation rates were determined by the seismic moment tensor method using historic seismicity and fault plane solutions for sub-regions of homogeneous strain. Contemporary deformation in the Great Basin occurs principally along the active seismic zones. The integrated opening rate across the entire Great Basin is accommodated by E-E extension at 8 to 10 mm/a in the north that diminishes to NW-SE extension of 3.5 mm/a in the south. Zones of maximum lithospheric extension correspond to belts of thin crust, high heat flow, and Quaternary basaltic volcanism, suggesting that these parameters are related through mechanism of extension such as a stress relaxation, allowing bouyant uplift and ascension of magmas

    Dynamic fluvial systems and gravel progradation in the Himalayan foreland

    Get PDF
    Although the large-scale stratigraphy of many terrestrial foreland basins is punctuated by major episodes of gravel progradation, the relationships of such facies to hinterland tectonism and climate change are often unclear. Structural reentrants provide windows into older and more proximal parts of the foreland than are usually exposed, and thus provide key insights to earlier phases of foreland evolution. Our magnetostratigraphic studies show that, although the major lithofacies preserved within the Himachal Pradesh structural reentrant in northwestern India resemble Neogene facies in Pakistan, they have a much greater temporal and spatial variability. From 11.5 to 7 Ma, major facies boundaries in Himachal Pradesh vary by as much as 2–3 m.y. across distances of 20–30 km and are controlled by the interference between a major southeastward-flowing axial river and a major southwestward-flow- ing transverse river. A thick but highly confined middle to late Miocene conglomerate facies includes the oldest extensive Siwalik conglomerates yet dated (10 Ma) and implies the development of significant erosional topography along the Main Boundary thrust prior to 11 Ma. Our studies document extensive syntectonic gravel progradation with conglomerates extending tens of kilometers into the undeformed foreland during a period of increased subsidence rate and within 1–2 m.y. of major thrust initiation. Overall, gravel progradation is modulated by the interplay among subsidence, sediment supply, and the proportion of gravels in rivers entering the foreland

    Mineral exploration potential of ERTS-1 data

    Get PDF
    The author has identified the following significant results. ERTS-1 imagery of an area approximately 15,000 square miles in Arizona was interpreted for regional structure and tectonic units. Eight fault systems were identified by trend, of which two, northeast and northwest, are considered to be related to porphyry copper mineralization. Nine tectonic units can be identified on the imagery as distinct geological identities. The boundaries between these units can be correlated with theoretical shear directions related to the San Andreas stress system. Fourier analysis of the N 50 W fault trend indicates a fundamental spacing between Fourier energy maxima that can be related to distances between copper deposits

    Subparallel thrust and normal faulting in Albania and the roles of gravitational potential energy and rheology contrasts in mountain belts

    Get PDF
    The active tectonics of Albania and surrounding regions, on the eastern margin of the Adriatic Sea, is characterized by subparallel thrust and normal faulting which, we suggest, is likely to be related to gravitational potential energy contrasts between the low-lying Adriatic Sea and the elevated mountainous areas inland. We calculate the magnitude of the force which the mountains and lowlands exert upon each other as a result of this potential energy contrast. It is likely that this force is largely supported by shear stresses on faults, and if so, the average stresses are less than ∼20 MPa. Alternatively, if the mountains are supported by stresses in the ductile part of the lithosphere, the stresses are likely to be ∼80–240 MPa in magnitude. The mountains of Albania are significantly lower than other ranges, such as the Peruvian Andes, which are thought to be extending in response to potential energy differences, and we discuss the relation between Albania and these other, higher, mountain belts from the perspective of differences in lithosphere rheology. We suggest that the lowlands of western Albania and the Adriatic Sea may have been weakened through time as a result of the deposition of large thicknesses of sediment, which lead to heating of the crystalline basement, a reduction in the potential energy contrast that could be supported by the lowlands, and so normal faulting in the mountains of eastern Albania

    Characteristics of direct human impacts on the rivers Karun and Dez in lowland south-west Iran and their interactions with earth surface movements

    Get PDF
    Two of the primary external factors influencing the variability of major river systems, over river reach scales, are human activities and tectonics. Based on the rivers Karun and Dez in south-west Iran, this paper presents an analysis of the geomorphological responses of these major rivers to ancient human modifications and tectonics. Direct human modifications can be distinguished by both modern constructions and ancient remnants of former constructions that can leave a subtle legacy in a suite of river characteristics. For example, the ruins of major dams are characterised by a legacy of channel widening to 100's up to c. 1000 m within upstream zones that can stretch to channel distances of many kilometres upstream of former dam sites, whilst the legacy of major, ancient, anthropogenic river channel straightening can also be distinguished by very low channel sinuosities over long lengths of the river course. Tectonic movements in the region are mainly associated with young and emerging folds with NW–SE and N–S trends and with a long structural lineament oriented E–W. These earth surface movements can be shown to interact with both modern and ancient human impacts over similar timescales, with the types of modification and earth surface motion being distinguishable. This paper examines the geomorphological evidence and outlines the processes involved in the evolution of these interactions through time. The analysis shows how interactions between earth surface movements and major dams are slight, especially after ancient dam collapse. By contrast, interactions between earth surface movements and major anthropogenic river channel straightening are shown to be a key factor in the persistence of long, near-straight river courses. Additionally, it is suggested that artificial river development, with very limited river channel lateral migration, may promote incision across an active fold at unusually long distances from the fold “core” and may promote markedly increased sinuosity across a structural lineament

    Notes on the Afar triple junction

    Get PDF
    Geological anomalies of Afar and bordering plateau
    corecore