OFDM over IEEE 802.11b hardware for telemedical applications

Using a wireless Local Area Network (WLAN) to transmit live high-quality video suitable for a telemedical application presents many challenges, including ensuring sufficient Quality of Service (QoS) for the end-user to be able to make an accurate diagnosis. One of the many problems that exist when developing such a system is the multipath effect caused by the reflections of the transmitted signals on various surfaces including walls, floors, furniture and people. This degrades the signal quality and reduces the amount of available bandwidth and, thus, the quality of the image. Presently, most of Europe is using the IEEE 802.11b hardware for such applications. As an alternative to the existing modulation of 802.11b, Orthogonal Frequency Division Multiplexing (OFDM) is investigated, especially for use inside hospitals. The advantages of using this modulation over IEEE 802.11b hardware for a telemedicine application are examined by means of simulation using three different simulation packages

MedLAN: Compact mobile computing system for wireless information access in emergency hospital wards

This thesis was submitted for the degree of Doctor of Philosophy and awarded by Brunel University.As the need for faster, safer and more efficient healthcare delivery increases, medical consultants seek new ways of implementing a high quality telemedical system, using innovative technology. Until today, teleconsultation (the most common application of Telemedicine) was performed by transferring the patient from the Accidents and Emergency ward, to a specially equipped room, or by moving large and heavy machinery to the place where the patient resided. Both these solutions were unpractical, uneconomical and potentially dangerous. At the same time wireless networks became increasingly useful in point-of-care areas such as hospitals, because of their ease of use, low cost of installation and increased flexibility. This thesis presents an integrated system called MedLAN dedicated for use inside the A&E hospital wards. Its purpose is to wirelessly support high-quality live video, audio, high-resolution still images and networks support from anywhere there is WLAN coverage. It is capable of transmitting all of the above to a consultant residing either inside or outside the hospital, or even to an external place, thorough the use of the Internet. To implement that, it makes use of the existing IEEE 802.11b wireless technology. Initially, this thesis demonstrates that for specific scenarios (such as when using WLANs), DICOM specifications should be adjusted to accommodate for the reduced WLAN bandwidth. Near lossless compression has been used to send still images through the WLANs and the results have been evaluated by a number of consultants to decide whether they retain their diagnostic value. The thesis further suggests improvements on the existing 802.11b protocol. In particular, as the typical hospital environment suffers from heavy RF reflections, it suggests that an alternative method of modulation (OFDM) can be embedded in the 802.11b hardware to reduce the multipath effect, increase the throughput and thus the video quality sent by the MedLAN system. Finally, realising that the trust between a patient and a doctor is fundamental this thesis proposes a series of simple actions aiming at securing the MedLAN system. Additionally, a concrete security system is suggested, that encapsulates the existing WEP security protocol, over IPSec

Modeling of wide-band MIMO radio channels based on NLoS indoor measurements

Link to published version (if available)

High Performance WLAN Using Smart Antenna

The need for higher data rates in WLANs boosts drastically because tremendous consumer interest in emerging multimedia applications, such as HDTV, has been increased. Currently, the IEEE 802.11a/b/g WLANs provide a limited data rate for the current user application requirements. In order to overcome substantial limitations of the existing WLANs, the next generation of WLANs, IEEE 802.11n, is in the course of development and expected to support higher throughput, larger coverage area and better QoS. The high performance IEEE 802.11n WLAN can improve data rate significantly by using smart antenna systems in the physical layer to take advantage of multi-path fading of wireless channels. In this thesis, an analytical model is developed to study the MAC performance and the underlying smart antenna technologies used in multi-path fading channels. Multiple antennas employed in the AP arise two popular approaches to provide a significant performance improvement, diversity and multiplexing. Considering the diversity gain of multiple antennas at the AP in which the AP with multiple antennas serves one user at a time, the capacity and throughput can be obtained. In addition, the AP is possible to serve multiple users in the downlink, by exploiting the multiplexing gain of the wireless channel. We investigate the maximum network throughput when the traffic intensity of the AP approaches to one. Unlike most of previous research which focus on either the physical or the MAC layer performance, our analytical model jointly considers the MAC protocol and the smart antenna technology