Capacity of Coded Index Modulation

We consider the special case of index coding over the Gaussian broadcast channel where each receiver has prior knowledge of a subset of messages at the transmitter and demands all the messages from the source. We propose a concatenated coding scheme for this problem, using an index code for the Gaussian channel as an inner code/modulation to exploit side information at the receivers, and an outer code to attain coding gain against the channel noise. We derive the capacity region of this scheme by viewing the resulting channel as a multiple-access channel with many receivers, and relate it to the 'side information gain' -- which is a measure of the advantage of a code in utilizing receiver side information -- of the inner index code/modulation. We demonstrate the utility of the proposed architecture by simulating the performance of an index code/modulation concatenated with an off-the-shelf convolutional code through bit-interleaved coded-modulation.Comment: To appear in Proc. IEEE Int. Symp. Inf. Theory (ISIT) 2015, Hong Kong, Jun. 2015. 5 pages, 4 figure

Design of Network Coding Schemes and RF Energy Transfer in Wireless Communication Networks

This thesis focuses on the design of network coding schemes and radio frequency (RF) energy transfer in wireless communication networks. During the past few years, network coding has attracted significant attention because of its capability to transmit maximum possible information in a network from multiple sources to multiple destinations via a relay. Normally, the destinations are only able to decode the information with sufficient prior knowledge. To enable the destinations to decode the information in the cases with less/no prior knowledge, a pattern of nested codes with multiple interpretations using binary convolutional codes is constructed in a multi-source multi-destination wireless relay network. Then, I reconstruct nested codes with convolutional codes and lattice codes in multi-way relay channels to improve the spectrum efficiency. Moreover, to reduce the high decoding complexity caused by the adopted convolutional codes, a network coded non-binary low-density generator matrix (LDGM) code structure is proposed for a multi-access relay system. Another focus of this thesis is on the design of RF-enabled wireless energy transfer (WET) schemes. Much attention has been attracted by RF-enabled WET technology because of its capability enabling wireless devices to harvest energy from wireless signals for their intended applications. I first configure a power beacon (PB)-assisted wireless-powered communication network (PB-WPCN), which consists of a set of hybrid access point (AP)-source pairs and a PB. Both cooperative and non-cooperative scenarios are considered, based on whether the PB is cooperative with the APs or not. Besides, I develop a new distributed power control scheme for a power splitting-based interference channel (IFC) with simultaneous wireless information and power transfer (SWIPT), where the considered IFC consists of multiple source-destination pairs

Wireless-powered cooperative communications: protocol design, performance analysis and resource allocation

Radio frequency (RF) energy transfer technique has attracted much attention and has recently been regarded as a key enabling technique for wireless-powered communications. However, the high attenuation of RF energy transfer over distance has greatly limited the performance and applications of WPCNs in practical scenarios. To overcome this essential hurdle, in this thesis we propose to combat the propagation attenuation by incorporating cooperative communication techniques in WPCNs. This opens a new paradigm named wireless-powered cooperative communication and raises many new research opportunities with promising applications. In this thesis, we focus on the novel protocol design, performance analysis and resource allocation of wireless-powered cooperative communication networks (WPCCNs). We first propose a harvest-then-cooperate (HTC) protocol for WPCCNs, where the wireless-powered source and relay(s) harvest energy from the AP in the downlink (DL) and work cooperatively in the uplink (UL) for transmitting source information. The average throughput performance of the HTC protocol with two single relay selection schemes is analyzed. We then design two novel protocols and study the optimal resource allocation for another setup of WPCCNs with a hybrid relay that has a constant power supply. Besides cooperating with the source for UL information transmission, the hybrid relay also transmits RF energy concurrently with the AP during the DL energy transfer phase. Subsequently, we adopt the Stackelberg game to model the strategic interactions in power beacon (PB)-assisted WPCCNs, where PBs are deployed to provide wireless charging services to wireless-powered users via RF energy transfer and are installed by different operators with the AP. Finally, we develop a distributed power splitting framework using non-cooperative game theory for a large-scale WPCCN, where multiple source-destination pairs communicate through their dedicated wireless-powered relays