Optimized Multimode Interference Fiber Based Refractometer in A Reflective Interrogation Scheme

A fiber based refractometer in a reflective interrogation scheme is investigated and optimized. A thin gold film was deposited on the tip of a coreless fiber section, which is spliced with a single mode fiber. The coreless fiber is a multimode waveguide, and the observed effects are due to multimode interference. To investigate and optimize the structure, the multimode part of the sensor is built with 3 different lengths: 58 mm, 29 mm and 17 mm. We use a broadband light source ranging from 1475 nm to 1650 nm and we test the sensors with liquids of varying refractive indices, from 1.333 to 1.438. Our results show that for a fixed wavelength, the sensor sensitivity is independent of the multimode fiber length, but we observed a sensitivity increase of approximately 0.7 nm/RIU for a one-nanometer increase in wavelength

Simultaneous Measurement for Strain and Temperature Using Fiber Bragg Gratings and Multimode Fibers

An all-fiber sensor capable of simultaneous measurement of temperature and strain is newly presented. The sensing head is formed by a fiber Bragg grating combined with a section of multimode fiber that acts as a Mach-Zehnder interferometer for temperature and strain discrimination. The strain and temperature coefficients of multimode fibers vary with the core sizes and materials. This feature can be used to improve the strain and temperature resolution by suitably choosing the multimode fiber. For a 10 pm wavelength resolution, a resolution of 9.21 μ∈ in strain and 0.26°C in temperature can be achieved

Performance of electronic dispersion compensator for 10Gb/s multimode fiber links

In high-speed optical links, electronic compensation circuits can be utilized to greatly improve the data transmission performance limited by fiber dispersion. In this paper, we develop a full link model, including multimode fibers, optical/electronics/optical components, clock-and-data recovery and electronic compensation circuits. The performance of various electronic compensation techniques, such as feed-forward equalizer and decision feedback equalizer for optical multimode fiber is investigated and numerically evaluated. Finally, a comparison of the performance of each compensation techniques and a proposal of optimal equalizer circuit implementation, achieving a 10-Gb/s transmission over 1-km standard multimode fiber are presented

Integrated Transversal Equalizers in High-Speed Fiber-Optic Systems

Intersymbol interference (ISI) caused by intermodal dispersion in multimode fibers is the major limiting factor in the achievable data rate or transmission distance in high-speed multimode fiber-optic links for local area networks applications. Compared with optical-domain and other electrical-domain dispersion compensation methods, equalization with transversal filters based on distributed circuit techniques presents a cost-effective and low-power solution. The design of integrated distributed transversal equalizers is described in detail with focus on delay lines and gain stages. This seven-tap distributed transversal equalizer prototype has been implemented in a commercial 0.18-µm SiGe BiCMOS process for 10-Gb/s multimode fiber-optic links. A seven-tap distributed transversal equalizer reduces the ISI of a 10-Gb/s signal after 800 m of 50-µm multimode fiber from 5 to 1.38 dB, and improves the bit-error rate from about 10^-5 to less than 10^-12

Direct transmission of pictorial information in multimode optical fibers

The problem of coherent image transmission through a single multimode optical fiber is discussed. A scheme is presented for recovering the transmitted image after distortions brought about by the fiber modes dispersion. Realization of this scheme by holographic techniques and with lens systems is proposed, and its limitations pointed out. The application of this scheme in canceling out temporal signal dispersion in a multimode fiber transmission line is also discussed briefly

Nonlinear multimodal interference and saturable absorption using a short graded-index multimode optical fiber

A detailed investigation of the nonlinear multimodal interference in a short graded-index multimode optical fiber is presented. The analysis is performed for a specific device geometry, where the light is coupled in and out of the multimode fiber via single-mode fibers. The same device geometry was recently used to obtain ultra-low-loss coupling between two single-mode optical fibers with very different mode-field diameters. Our results indicate the potential application of this simple geometry for nonlinear devices, such as in nonlinear switching, optical signal processing, or as saturable absorbers in mode-locked fiber lasers. Saturable absorption in this all-fiber configuration is discussed and it is shown that it provides attractive properties that can potentially be used in high pulse energy mode-locked fiber lasers

Orthogonal frequency-division multiplexing in wireless communication systems with multimode fiber feeds

The feasibility of using multimode fiber as an inexpensive cell feed in broad-band indoor picocellular systems is investigated in this paper. The performance of coded orthogonal frequency-division multiplexing (OFDM) for a variety of multimode fiber profiles, including stepped index and -profile graded index fibers, is assessed. In addition to its ability to perform well in a frequency- selective multipath environment, OFDM is shown to offer good protection against the frequency selectivity of a dispersive multimode fiber. Data rates in excess of 100 Mb/s (without equalization) over a multimode fiber channel are possible, whereas they may be limited to some 20–30 Mb/s using conventional ASK modulation