31,397 research outputs found
Waveform Diversity and Range-Coupled Adaptive Radar Signal Processing
Waveform diversity may offer several benefits to radar systems though often at the cost of reduced sensitivity. Multi-dimensional processing schemes are known to offer many degrees of freedom, which can be exploited to suppress the ambiguity inherent to pulse compression, array processing, and Doppler frequency estimation. Spatial waveform diversity can be achieved by transmitting different but correlated waveforms from each element of an antenna array. A simple yet effective scheme is employed to transmit different waveforms in different spatial directions. A new reiterative minimum mean squared error approach entitled Space-Range Adaptive Processing, which adapts simultaneously in range and angle, is derived and shown in simulation to offer enhanced performance when spatial waveform diversity is employed relative to both conventional matched filtering and sequentially adapting in angle and then range. The same mathematical framework is utilized to develop Time-Range Adaptive Processing (TRAP) algorithm which is capable of simultaneously adapting in Doppler frequency and range. TRAP is useful when pulse-to-pulse changing of the center frequency or waveform coding is used to achieve enhanced range resolution or unambiguous ranging, respectively. The inherent computational complexity of the new multi-dimensional algorithms is addressed by segmenting the full-dimension cost functions, yielding a reduced-dimensional variants of each. Finally, a non-adaptive approach based on the multi-dimensional TRAP signal model is utilized to develop an efficient clutter cancellation technique capable of suppressing multiple range intervals of clutter when waveform diversity is applied to pulse-Doppler radar
Multi-Spectrally Constrained Low-PAPR Waveform Optimization for MIMO Radar Space-Time Adaptive Processing
This paper focuses on the joint design of transmit waveforms and receive
filters for airborne multiple-input-multiple-output (MIMO) radar systems in
spectrally crowded environments. The purpose is to maximize the output
signal-to-interference-plus-noise-ratio (SINR) in the presence of
signal-dependent clutter. To improve the practicability of the radar waveforms,
both a multi-spectral constraint and a peak-to-average-power ratio (PAPR)
constraint are imposed. A cyclic method is derived to iteratively optimize the
transmit waveforms and receive filters. In particular, to tackle the
encountered non-convex constrained fractional programming in designing the
waveforms (for fixed filters), we resort to the Dinkelbach's transform,
minorization-maximization (MM), and leverage the alternating direction method
of multipliers (ADMM). We highlight that the proposed algorithm can iterate
from an infeasible initial point and the waveforms at convergence not only
satisfy the stringent constraints, but also attain superior performance
Advanced Synthetic Aperture Radar Based on Digital Beamforming and Waveform Diversity
This paper introduces innovative SAR system
concepts for the acquisition of high resolution radar images with
wide swath coverage from spaceborne platforms. The new concepts
rely on the combination of advanced multi-channel SAR front-end
architectures with novel operational modes. The architectures
differ regarding their implementation complexity and it is shown
that even a low number of channels is already well suited to
significantly improve the imaging performance and to overcome
fundamental limitations inherent to classical SAR systems. The
more advanced concepts employ a multidimensional encoding of
the transmitted waveforms to further improve the performance
and to enable a new class of hybrid SAR imaging modes that are
well suited to satisfy hitherto incompatible user requirements for
frequent monitoring and detailed mapping. Implementation
specific issues will be discussed and examples demonstrate the
potential of the new techniques for different remote sensing
applications
Signal and System Design for Wireless Power Transfer : Prototype, Experiment and Validation
A new line of research on communications and signals design for Wireless
Power Transfer (WPT) has recently emerged in the communication literature.
Promising signal strategies to maximize the power transfer efficiency of WPT
rely on (energy) beamforming, waveform, modulation and transmit diversity, and
a combination thereof. To a great extent, the study of those strategies has so
far been limited to theoretical performance analysis. In this paper, we study
the real over-the-air performance of all the aforementioned signal strategies
for WPT. To that end, we have designed, prototyped and experimented an
innovative radiative WPT architecture based on Software-Defined Radio (SDR)
that can operate in open-loop and closed-loop (with channel acquisition at the
transmitter) modes. The prototype consists of three important blocks, namely
the channel estimator, the signal generator, and the energy harvester. The
experiments have been conducted in a variety of deployments, including
frequency flat and frequency selective channels, under static and mobility
conditions. Experiments highlight that a channeladaptive WPT architecture based
on joint beamforming and waveform design offers significant performance
improvements in harvested DC power over conventional
single-antenna/multiantenna continuous wave systems. The experimental results
fully validate the observations predicted from the theoretical signal designs
and confirm the crucial and beneficial role played by the energy harvester
nonlinearity.Comment: Accepted to IEEE Transactions on Wireless Communication
Advanced Concepts for Ultra-Wide-Swath SAR Imaging
This paper reviews advanced multi-channel SAR system
concepts for the imaging of ultra-wide swaths with high azimuth
resolution. Novel system architectures and operational
modes are introduced and compared to each other with regard
to their performance
Interference-Mitigating Waveform Design for Next-Generation Wireless Systems
A brief historical perspective of the evolution of waveform designs employed in consecutive generations of wireless communications systems is provided, highlighting the range of often conflicting demands on the various waveform characteristics. As the culmination of recent advances in the field the underlying benefits of various Multiple Input Multiple Output (MIMO) schemes are highlighted and exemplified. As an integral part of the appropriate waveform design, cognizance is given to the particular choice of the duplexing scheme used for supporting full-duplex communications and it is demonstrated that Time Division Duplexing (TDD) is substantially outperformed by Frequency Division Duplexing (FDD), unless the TDD scheme is combined with further sophisticated scheduling, MIMOs and/or adaptive modulation/coding. It is also argued that the specific choice of the Direct-Sequence (DS) spreading codes invoked in DS-CDMA predetermines the properties of the system. It is demonstrated that a specifically designed family of spreading codes exhibits a so-called interference-free window (IFW) and hence the resultant system is capable of outperforming its standardised counterpart employing classic Orthogonal Variable Spreading Factor (OVSF) codes under realistic dispersive channel conditions, provided that the interfering multi-user and multipath components arrive within this IFW. This condition may be ensured with the aid of quasisynchronous adaptive timing advance control. However, a limitation of the system is that the number of spreading codes exhibiting a certain IFW is limited, although this problem may be mitigated with the aid of novel code design principles, employing a combination of several spreading sequences in the time-frequency and spatial-domain. The paper is concluded by quantifying the achievable user load of a UTRA-like TDD Code Division Multiple Access (CDMA) system employing Loosely Synchronized (LS) spreading codes exhibiting an IFW in comparison to that of its counterpart using OVSF codes. Both system's performance is enhanced using beamforming MIMOs
A Blind Interference Canceling Technique for Two-Stage Harmonic Rejection in Down-mixers
This paper presents practical experiments on a harmonic rejection down-mixer, which offers up to 75 dB of harmonic rejection, without an RF filter. The down-mixer uses a two-stage approach; the first stage is an analog multi-path/multiphase harmonic rejection mixer followed by a second stage providing additional harmonic rejection based on blind adaptive interference canceling in the discrete-time domain. The aim is to show its functional operation. The canceler cannot cope with DC offsets. The DC offsets are removed by highpass filters. The signal paths used to obtain an estimate of the interference must be designed to provide as much attenuation of the desired signal as possible. Front-end nonlinearities and DC offsets are discussed
- âŠ