A theoretical study of the structural phases of Group 5B - 6B metals and their transport properties

In order to predict the stable and metastable phases of the bcc metals in the block of the Periodic Table defined by groups 5B to 6B and periods 4 to 6, as well as the structure dependence of their transport properties, we have performed full potential computations of the total energies per unit cell as a function of the c/a ratio at constant experimental volume. In all cases, a metastable body centered tetragonal (bct) phase was predicted from the calculations. The total energy differences between the calculated stable and metastable phases ranged from 0.09 eV/cell (vanadium) to 0.39 eV/cell (tungsten). The trends in resistivity as a function of structure and atomic number are discussed in terms of a model of electron transport in metals. Theoretical calculations of the electrical resistivity and other transport properties show that bct phases derived from group 5B elements are more conductive than the corresponding bcc phases, while bct phases formed from group 6B elements are less conductive than the corresponding bcc phases. Special attention is paid to the phases of tantalum where we show that the frequently observed beta phase is not a simple tetragonal distortion of bcc tantalum

Strain-induced structural instability in FeRh

We perform density functional calculations to investigate the structure of the inter-metallic alloy FeRh under epitaxial strain. Bulk FeRh exhibits a metamagnetic transition from a low-temperature antiferromagnetic (AFM) phase to a ferromagnetic (FM) phase at 350K, and its strain dependence is of interest for tuning the transition temperature to the room-temperature operating conditions of typical memory devices. We find an unusually strong dependence of the structural energetics on the choice of exchange-correlation functional, with the usual local density approximation (LDA) yielding the wrong ground-state structure, and generalized gradient (GGA) extensions being in better agreement with the bulk experimental structure. Using the GGA we show the existence of a metastable face-centered-cubic (fcc)-like AFM structure that is reached from the ground state body-centered-cubic (bcc) AFM structure by following the epitaxial Bain path. We predict that this metastable fcc-like structure has a significantly higher conductivity than the bcc AFM phase. We show that the behavior is well described using non-linear elasticity theory, which captures the softening and eventual sign change of the orthorhombic shear modulus under compressive strain, consistent with this structural instability. Finally, we predict the existence of an additional unit-cell-doubling lattice instability, which should be observable at low temperature.Comment: 10 pages, 7 figure

Exotic behavior and crystal structures of calcium under pressure

Experimental studies established that calcium undergoes several counterintuitive transitions under pressure: fcc \rightarrow bcc \rightarrow simple cubic \rightarrow Ca-IV \rightarrow Ca-V, and becomes a good superconductor in the simple cubic and higher-pressure phases. Here, using ab initio evolutionary simulations, we explore the behavior of Ca under pressure and find a number of new phases. Our structural sequence differs from the traditional picture for Ca, but is similar to that for Sr. The {\beta}-tin (I41/amd) structure, rather than simple cubic, is predicted to be the theoretical ground state at 0 K and 33-71 GPa. This structure can be represented as a large distortion of the simple cubic structure, just as the higher-pressure phases stable between 71 and 134 GPa. The structure of Ca-V, stable above 134 GPa, is a complex host-guest structure. According to our calculations, the predicted phases are superconductors with Tc increasing under pressure and reaching ~20 K at 120 GPa, in good agreement with experiment

Theoretical Studies of Epitaxial Bain Paths of Metals

Epitaxial growth is an important technique for the fabrication of film structures with good crystalline quality, e.g., monoatomic overlayers, multilayers, compound materials, and ordered alloys. Such epitaxially grown films are technologically important materials with, e.g., adjustable electronic, magnetic, and optical properties. In case of coherent or pseudomorphic epitaxy, the overlayer adapts the in-plane lattice parameters of the substrate, i.e., the overlayer is strained to match the lattice parameters parallel to the substrate surface (in-plane directions). Simultaneously, a relaxation of the film dimension perpendicular to the substrate-film interface occurs (out-of-plane direction). Thus, coherent epitaxy provides a method to put phases under strain, and it can stabilise a metastable state of the film material, if the substrate lattice matches this metastable structure. Bulk-like properties in thick overlayers, which adopt the body-centred tetragonal (BCT) crystal structure and which grow coherently on a suitable substrate with quadratic surface symmetry, are modelled by the epitaxial Bain path (EBP) in this thesis. The knowledge of the EBP allows to study properties of the overlayer as function of the substrate lattice parameter. In particular, strain effects on the film material, magnetic order in the overlayer, and the existence of possible metastable states are investigated by means of density functional theory (DFT) in the local spin density approximation (LSDA), and in the singular case of uranium, employing the generalised gradient approximation (GGA). Note that a symmetry property of the BCT structure states, that it is identical to the body-centred cubic (BCC) structure or the face-centred cubic (FCC) structure for definite ratios of the tetragonal lattice parameters. Our definition of the EBP has two, previously not considered consequences for EBPs in general: an EBP can be discontinuous, and the high symmetry cubic structures (FCC and BCC) need not be points on the EBP. Both cases occurred for several elements considered in this thesis. If, however, a cubic structure is a point on the EBP, then a symmetry property guarantees that the total energy along the EBP, E(a), is stationary at this cubic structure. We computed the EBPs of all transition metals (TMs), the post TMs Zn, Cd, and Hg, the alkaline earth metals Ca, Sr, and Ba, the lanthanides La and Lu, and the actinide U (35 elements were treated in total). For each element but Zr, Hg, and U, there are exactly two structures whose energies are minima on the EBP, and which exhibit neither in-plane nor out-of-plane stresses; for Zr, Hg, and U there are three minima each. All other states on the EBP exhibit in-plane stresses because they are a strained form of the stress-free structures. The possibility of metastability of these particular, stress-free structures, i.e., stabilisation of these structures without bonding to the substrate, was investigated by stability conditions based on linear elasticity theory (except for U). We predict that ten FCC structures and three BCT structures not known from the respective phase diagrams may be metastable. We studied the properties of ferromagnetic (FM) states on the EBP for the elements Fe, Co, and Ni, and moreover predict, that Mn, Ru, Os, and U order ferromagnetically for certain states of the EBP. The latter three elements are paramagnetic in their ground states. The onset of ferromagnetism in Os and U is not accompanied by a simultaneously fulfilled Stoner criterion. According to our results, antiferromagnetic order (with moment sequences up-down or up-up-down-down on successive (001) planes) is never more stable than FM order on any EBP for any element investigated. On the basis of our comprehensive results for all TMs, we analysed trends across each of the three TM series and similarities among the three series. We demonstrate, that the type of the EBP (a classification of extrema of E(a) by symmetry into types) follows a characteristic trend across each of the three TM series. We discuss exceptions (Mn, Fe, and Zr) to this trend. Another trend, identical for the three series, is found for the BCT­-FCC structural energy difference as function of the d-band filling (evaluated for BCT structures that define extrema of E(a)), which follows a similar trend as the well studied BCC­-FCC structural energy difference. Clear similarities among the three periods of elements are also reflected in the bulk moduli and in the elastic constants of the cubic or tetragonal structures, that define the global and local minima of E(a). The mentioned similarities suggest, that many properties which are associated with the EBPs of TMs, can be attributed to the occupation of the d-band, which is the most dominant feature of the electronic structure of TMs

Understanding the origins of metastability in thin film growth; tantalum and the early group VB-VIB metals

Tantalum (Ta) is a metal that is highly prized for its applications in a variety of industries, including the microelectronics industry, where it is largely used in thin film modifications in order to achieve various electronic, magnetic and structural capabilities in solid-state devices. Ta frequently forms metastable phases, including the well-known ß-phase, during the preparation of thin Ta films by standard film deposition methods such as sputtering and electro-deposition. In order to gain insight into Ta metastable phase formation, the Bain transformation mechanism is studied for Ta and the neighboring body centered cubic (bcc) transition metals in Groups 5 and 6 of the Periodic Table, resulting in the prediction of hypothetical body centered tetragonal (bct) and face centered cubic (fcc) phases for all the studied metals at c/a ratios greater than 1.6 and equal to /2 respectively. Density Functional Theory (DFT) in the Linearized Augmented Plane Wave (LAPW) formalism and the Lowest Order Variational Approximation (LOVA) for the solution of the Boltzmann transport equation have been used to calculate the temperature dependent resistivity for the studied metals and reveal that substrate-induced film strain is not by itself sufficient to cause the formation of ß-Ta. Fermi surface calculations of the mean electron velocity in the proposed P42/mnm structure of ß-Ta suggest that the high values of resistivity frequently measured for ß-Ta are not an intrinsic property