132 research outputs found
A Novel Addressing Scheme for PMIPv6 Based Global IP-WSNs
IP based Wireless Sensor Networks (IP-WSNs) are being used in healthcare, home automation, industrial control and agricultural monitoring. In most of these applications global addressing of individual IP-WSN nodes and layer-three routing for mobility enabled IP-WSN with special attention to reliability, energy efficiency and end to end delay minimization are a few of the major issues to be addressed. Most of the routing protocols in WSN are based on layer-two approaches. For reliability and end to end communication enhancement the necessity of layer-three routing for IP-WSNs is generating significant attention among the research community, but due to the hurdle of maintaining routing state and other communication overhead, it was not possible to introduce a layer-three routing protocol for IP-WSNs. To address this issue we propose in this paper a global addressing scheme and layer-three based hierarchical routing protocol. The proposed addressing and routing approach focuses on all the above mentioned issues. Simulation results show that the proposed addressing and routing approach significantly enhances the reliability, energy efficiency and end to end delay minimization. We also present architecture, message formats and different routing scenarios in this paper
Sensor Proxy Mobile IPv6 (SPMIPv6)—A Novel Scheme for Mobility Supported IP-WSNs
IP based Wireless Sensor Networks (IP-WSNs) are gaining importance for their broad range of applications in health-care, home automation, environmental monitoring, industrial control, vehicle telematics and agricultural monitoring. In all these applications, mobility in the sensor network with special attention to energy efficiency is a major issue to be addressed. Host-based mobility management protocols are not suitable for IP-WSNs because of their energy inefficiency, so network based mobility management protocols can be an alternative for the mobility supported IP-WSNs. In this paper we propose a network based mobility supported IP-WSN protocol called Sensor Proxy Mobile IPv6 (SPMIPv6). We present its architecture, message formats and also evaluate its performance considering signaling cost, mobility cost and energy consumption. Our analysis shows that with respect to the number of IP-WSN nodes, the proposed scheme reduces the signaling cost by 60% and 56%, as well as the mobility cost by 62% and 57%, compared to MIPv6 and PMIPv6, respectively. The simulation results also show that in terms of the number of hops, SPMIPv6 decreases the signaling cost by 56% and 53% as well as mobility cost by 60% and 67% as compared to MIPv6 and PMIPv6 respectively. It also indicates that proposed scheme reduces the level of energy consumption significantly
Recommended from our members
Design of multi-homing architecture for mobile hosts
This thesis was submitted for the degree of Doctor of Philosophy and awarded by Brunel University.This thesis proposes a new multi-homing mobile architecture for future heterogeneous network environment. First, a new multi-homed mobile architecture called Multi Network Switching enabled Mobile IPv6 (MNS-MIP6) is proposed which enables a Mobile Node (MN) having multiple communication paths between itself and its Correspondent Node (CN) to take full advantage of being multi-homed. Multiple communication paths exist because MN, CN, or both are simultaneously attached to multiple access networks. A new sub layer is introduced within IP layer of the host’s protocol stack. A context is established between the MN and the CN. Through this context, additional IP addresses are exchanged between the two. Our MNS-MIP6 architecture allows one communication to smoothly switch from one interface/communication path to another. This switch remains transparent to other layers above IP. Second, to make communication more reliable in multi-homed mobile environments, a new failure detection and recovery mechanism called Mobile Reach ability Protocol (M-REAP) is designed within the proposed MNS-MIP6 architecture. The analysis shows that our new mechanism makes communication more reliable than the existing failure detection and recovery procedures in multi-homed mobile environments. Third, a new network selection mechanism is introduced in the proposed architecture which enables a multi-homed MN to choose the network best suited for particular application traffic. A Policy Engine is defined which takes parameters from iv the available networks, compares them according to application profiles and user preferences, and chooses the best network. The results show that in multi-homed mobile environment, load can be shared among different networks/interfaces through our proposed load sharing mechanism. Fourth, a seamless handover procedure is introduced in the system which enables multi-homed MN to seamlessly roam in a heterogeneous network environment. Layer 2 triggers are defined which assist in handover process. When Signal to Noise Ratio (SNR) on a currently used active interface becomes low, a switch is made to a different active interface. We show through mathematical and simulation analysis that our proposed scheme outperforms the existing popular handover management enhancement scheme in MIPv6 networks namely Fast Handover for MIPv6 (FMIPv6). Finally, a mechanism is introduced to allow legacy hosts to communicate with MNS-MIP6 MNs and gain the benefits of reliability, load sharing and seamless handover. The mechanism involves introducing middle boxes in CN’s network. These boxes are called Proxy-MNS boxes. Context is established between the middle boxes and a multi-homed MN
Using Media Independent Handover to Support PMIPv6 Inter-domain Mobility Based Vehicular Networks
Proxy Mobile IPv6 (PMIPv6) was proposed by the Internet Engineering Task Force (IETF) as a new network-based mobility protocol which does not require the involvement of MN’s in any form of mobility management. MN can handover relatively faster in PMIPv6 than in host-based mobility protocols (e.g. Mobile IPv6 (MIPv6)) because it actively uses link-layer attachment information which reduces the movement detection time, and eliminates duplicate address detection procedures. However, the current PMIPv6 cannot provide continuous mobility support for MN when roaming between different PMIPv6 domains; we introduce a novel inter-domain PMIPv6 scheme to support seamless handover for vehicle in motion to support continuous and seamless connection while roaming in the new PMIPv6 domain. In this paper we analytically evaluate our proposed scheme to support inter-domain mobility for vehicle roaming between two PMIPv6 domains by using Media Independent Handover (MIH) and Fully Qualified Domain Name (FQDN) to support the handover in addition to a continuous connection
A Seamless Vertical Handoff Protocol for Enhancing the Performance of Data Services in Integrated UMTS/WLAN Network
The Next Generation Wireless Network (NGWN) is speculated to be a unified network composed of several existing wireless access networks such as Wireless Local Area Network (WLAN), Global System for Mobile (GSM), Universal Mobile Telecommunications System (UMTS), Worldwide Interoperability for Microwave Access (WiMAX), and satellite network etc
Peer-to-peer real time mobility using SIP and mobile IPv6
Master'sMASTER OF ENGINEERIN
Location Management in IP-based Future LEO Satellite Networks: A Review
Future integrated terrestrial, aerial, and space networks will involve
thousands of Low Earth Orbit (LEO) satellites forming a network of
mega-constellations, which will play a significant role in providing
communication and Internet services everywhere, at any time, and for
everything. Due to its very large scale and highly dynamic nature, future LEO
satellite networks (SatNets) management is a very complicated and crucial
process, especially the mobility management aspect and its two components
location management and handover management. In this article, we present a
comprehensive and critical review of the state-of-the-art research in LEO
SatNets location management. First, we give an overview of the Internet
Engineering Task Force (IETF) mobility management standards (e.g., Mobile IPv6
and Proxy Mobile IPv6) and discuss their location management techniques
limitations in the environment of future LEO SatNets. We highlight future LEO
SatNets mobility characteristics and their challenging features and describe
two unprecedented future location management scenarios. A taxonomy of the
available location management solutions for LEO SatNets is presented, where the
solutions are classified into three approaches. The "Issues to consider"
section draws attention to critical points related to each of the reviewed
approaches that should be considered in future LEO SatNets location management.
To identify the gaps, the current state of LEO SatNets location management is
summarized. Noteworthy future research directions are recommended. This article
is providing a road map for researchers and industry to shape the future of LEO
SatNets location management.Comment: Submitted to the Proceedings of the IEE
- …