Transcoding of MPEG Bitstreams

This paper discusses the problem of transcoding as it may occur in, for instance, the following situation. Suppose a satellite transmits an MPEG-compressed video signal at say 9 Mbit/s. This signal must be relayed at a cable head end. However, since the cable capacity is only limited, the cable head end will want to relay this incoming signal at a lower bit-rate of, say, 5 Mbit/s. The problem is how to convert a compressed video signal of a given bit-rate into a compressed video signal of a lower bit-rate. The specific transcoding problem discussed in this paper is referred to as bit-rate conversion. Basically, a transcoder used for such a purpose will consist of a cascaded decoder and encoder. It is shown in the paper that the complexity of this combination can be significantly reduced. The paper also investigates the loss of picture quality that may be expected when a transcoder is in the transmission chain. The loss of quality as compared to that resulting in the case of transmission without a transcoder is studied by means of computations using simplified models of the transmission chains and by means of using computer simulations of the complete transmission chain. It will be shown that the presence of two quantizers, i.e. cascaded quantization, in the transmission chain is the main cause of extra losses, and it will be shown that the losses in terms of SNR will be some 0.5 ¿ 1.0 dB greater than in the case of a transmission chain without a transcoder

Overview of MV-HEVC prediction structures for light field video

Light field video is a promising technology for delivering the required six-degrees-of-freedom for natural content in virtual reality. Already existing multi-view coding (MVC) and multi-view plus depth (MVD) formats, such as MV-HEVC and 3D-HEVC, are the most conventional light field video coding solutions since they can compress video sequences captured simultaneously from multiple camera angles. 3D-HEVC treats a single view as a video sequence and the other sub-aperture views as gray-scale disparity (depth) maps. On the other hand, MV-HEVC treats each view as a separate video sequence, which allows the use of motion compensated algorithms similar to HEVC. While MV-HEVC and 3D-HEVC provide similar results, MV-HEVC does not require any disparity maps to be readily available, and it has a more straightforward implementation since it only uses syntax elements rather than additional prediction tools for inter-view prediction. However, there are many degrees of freedom in choosing an appropriate structure and it is currently still unknown which one is optimal for a given set of application requirements. In this work, various prediction structures for MV-HEVC are implemented and tested. The findings reveal the trade-off between compression gains, distortion and random access capabilities in MVHEVC light field video coding. The results give an overview of the most optimal solutions developed in the context of this work, and prediction structure algorithms proposed in state-of-the-art literature. This overview provides a useful benchmark for future development of light field video coding solutions

Distributed video coding for wireless video sensor networks: a review of the state-of-the-art architectures

Distributed video coding (DVC) is a relatively new video coding architecture originated from two fundamental theorems namely, Slepian–Wolf and Wyner–Ziv. Recent research developments have made DVC attractive for applications in the emerging domain of wireless video sensor networks (WVSNs). This paper reviews the state-of-the-art DVC architectures with a focus on understanding their opportunities and gaps in addressing the operational requirements and application needs of WVSNs

Seminario sullo Standard MPEG-4: utilizzo ed aspetti implementativi

Una delle tecnologie chiave che hanno permesso il grande sviluppo della televisione digitale è la compressione video. La tecnologia di codifica video nota come MPEG-2, sviluppata nei primi anni novanta, è diventata lo standard di trasmissione DTV (Digital TV) sia satellitare sia terrestre in quasi tutti i paesi del mondo. Da allora la velocità dei microprocessori e le capacità di memoria dei dispositivi hardware per la codifica e la decodifica sono migliorate significativamente rendendo possibile lo sviluppo e l’implementazione di algoritmi di codifica innovativi in grado di abbattere significativamente i limiti di compressione dello standard MPEG-2. Tali innovazioni, sfociate nel 2003 nello standard MPEG-4 AVC (Advanced Video Coding), non hanno permesso di mantenere la compatibilità all’indietro con l’MPEG-2, e questo ha inizialmente costituito un limite alla loro introduzione nei sistemi di trasmissione DTV. Tuttavia, negli ultimi anni la codifica MPEG-4 AVC si è diffusa rapidamente, è stata adottata dal progetto DVB, recentemente dall’ATSC, ed è lo standard di codifica nell’IPTV. L’obiettivo di questo seminario, che si articola in due giornate, è quello di presentare lo standard di codifica MPEG-4 AVC con particolare attenzione agli aspetti implementativi del livello di codifica video.2008-11-18Sardegna Ricerche, Edificio 2, Località Piscinamanna 09010 Pula (CA) - ItaliaSeminario sullo Standard MPEG-4: utilizzo ed aspetti implementativ

Performance analysis of H.264 encoder for high-definition video transmission over ultra-wideband communication link.

With the technological advancement, entertainment has become revolutionized and the High-definition (HD) video has become a common feature of our modern amusement devices. Moreover, the demand for wireless transmission of HD video is rising increasingly for its ubiquitous nature, easy installation and relocation. The high bandwidth requirement is the main concern for wireless transmission of high quality video streams. Research has been going on by the consumer electronics industry to provide different solutions of this issue, for the last few years. In this research work, HD video transmission feasibility using the Ultra-wideband (UWB) communication channel is analyzed. The UWB channel is selected for its short-range, high-speed data transmission capability at low-cost, and low-power consumption. The maximum transmitting range of this technology is about 10 m at 100 Mbps data rate. Simulation is conducted by controlling key parameters, such as, in-loop deblocking filter, group of pictures, and quantization parameter of an H.264/AVC encoder. Here, standard HD video streams with different motion characteristics are used, and the impact of these parameters change on the reconstructed video quality and the broadcasting data rate are analyzed. Finally, a generalized parameters settings, and a video content dependent settings for an H.264/AVC encoder are proposed for different bandwidth requirements, as well as acceptable video quality. Performance evaluation of these parameters settings is performed, and the results are quite satisfactory as long as the symbol energy to noise power density ratio, Es/No, is above 15. With the proposed parameters settings, maximum 20 Mbps data rate is achieved with 33.5 dB Y-PSNR

A novel method for subjective picture quality assessment and further studies of HDTV formats

This is the author's accepted manuscript. The final published article is available from the link below. Copyright @ IEEE 2008.This paper proposes a novel method for the assessment of picture quality, called triple stimulus continuous evaluation scale (TSCES), to allow the direct comparison of different HDTV formats. The method uses an upper picture quality anchor and a lower picture quality anchor with defined impairments. The HDTV format under test is evaluated in a subjective comparison with the upper and lower anchors. The method utilizes three displays in a particular vertical arrangement. In an initial series of tests with the novel method, the HDTV formats 1080p/50,1080i/25, and 720p/50 were compared at various bit-rates and with seven different content types on three identical 1920 times 1080 pixel displays. It was found that the new method provided stable and consistent results. The method was tested with 1080p/50,1080i/25, and 720p/50 HDTV images that had been coded with H.264/AVC High profile. The result of the assessment was that the progressive HDTV formats found higher appreciation by the assessors than the interlaced HDTV format. A system chain proposal is given for future media production and delivery to take advantage of this outcome. Recommendations for future research conclude the paper

Error resilience and concealment techniques for high-efficiency video coding

This thesis investigates the problem of robust coding and error concealment in High Efficiency Video Coding (HEVC). After a review of the current state of the art, a simulation study about error robustness, revealed that the HEVC has weak protection against network losses with significant impact on video quality degradation. Based on this evidence, the first contribution of this work is a new method to reduce the temporal dependencies between motion vectors, by improving the decoded video quality without compromising the compression efficiency. The second contribution of this thesis is a two-stage approach for reducing the mismatch of temporal predictions in case of video streams received with errors or lost data. At the encoding stage, the reference pictures are dynamically distributed based on a constrained Lagrangian rate-distortion optimization to reduce the number of predictions from a single reference. At the streaming stage, a prioritization algorithm, based on spatial dependencies, selects a reduced set of motion vectors to be transmitted, as side information, to reduce mismatched motion predictions at the decoder. The problem of error concealment-aware video coding is also investigated to enhance the overall error robustness. A new approach based on scalable coding and optimally error concealment selection is proposed, where the optimal error concealment modes are found by simulating transmission losses, followed by a saliency-weighted optimisation. Moreover, recovery residual information is encoded using a rate-controlled enhancement layer. Both are transmitted to the decoder to be used in case of data loss. Finally, an adaptive error resilience scheme is proposed to dynamically predict the video stream that achieves the highest decoded quality for a particular loss case. A neural network selects among the various video streams, encoded with different levels of compression efficiency and error protection, based on information from the video signal, the coded stream and the transmission network. Overall, the new robust video coding methods investigated in this thesis yield consistent quality gains in comparison with other existing methods and also the ones implemented in the HEVC reference software. Furthermore, the trade-off between coding efficiency and error robustness is also better in the proposed methods

Mesh-based video coding for low bit-rate communications

In this paper, a new method for low bit-rate content-adaptive mesh-based video coding is proposed. Intra-frame coding of this method employs feature map extraction for node distribution at specific threshold levels to achieve higher density placement of initial nodes for regions that contain high frequency features and conversely sparse placement of initial nodes for smooth regions. Insignificant nodes are largely removed using a subsequent node elimination scheme. The Hilbert scan is then applied before quantization and entropy coding to reduce amount of transmitted information. For moving images, both node position and color parameters of only a subset of nodes may change from frame to frame. It is sufficient to transmit only these changed parameters. The proposed method is well-suited for video coding at very low bit rates, as processing results demonstrate that it provides good subjective and objective image quality at a lower number of required bits