Resource management in IP-based radio access networks

IP is being considered to be used in the Radio Access Network (RAN) of UMTS. It is of paramount importance to be able to provide good QoS guarantees to real time services in such an IP-based RAN. QoS in IP networks is most efficiently provided with Differentiated services (Diffserv). However, currently Diffserv mainly specifies Per Hop Behaviors (PHB). Proper mechanisms for admission control and resource reservation have not yet been defined. A new resource management concept in the IP-based RAN is needed to offer QoS guarantees to real time services. We investigate the current Diffserv mechanisms and contribute to development of a new resource management protocol. We focus on the load control algorithm [9], which is an attempt to solve the problem of admission control and resource reservation in IP-based networks. In this document we present some load control issues and propose to enhance the load control protocol with the Measurement Based Admission Control (MBAC) concept. With this enhancement the traffic load in the IP-based RAN can be estimated, since the ingress router in the network path can be notified by marking packets with the resource state information. With this knowledge, the ingress router can perform admission control to keep the IP-based RAN stable with a high utilization even in overload situations

An Experimental Investigation of Hyperbolic Routing with a Smart Forwarding Plane in NDN

Routing in NDN networks must scale in terms of forwarding table size and routing protocol overhead. Hyperbolic routing (HR) presents a potential solution to address the routing scalability problem, because it does not use traditional forwarding tables or exchange routing updates upon changes in network topologies. Although HR has the drawbacks of producing sub-optimal routes or local minima for some destinations, these issues can be mitigated by NDN's intelligent data forwarding plane. However, HR's viability still depends on both the quality of the routes HR provides and the overhead incurred at the forwarding plane due to HR's sub-optimal behavior. We designed a new forwarding strategy called Adaptive Smoothed RTT-based Forwarding (ASF) to mitigate HR's sub-optimal path selection. This paper describes our experimental investigation into the packet delivery delay and overhead under HR as compared with Named-Data Link State Routing (NLSR), which calculates shortest paths. We run emulation experiments using various topologies with different failure scenarios, probing intervals, and maximum number of next hops for a name prefix. Our results show that HR's delay stretch has a median close to 1 and a 95th-percentile around or below 2, which does not grow with the network size. HR's message overhead in dynamic topologies is nearly independent of the network size, while NLSR's overhead grows polynomially at least. These results suggest that HR offers a more scalable routing solution with little impact on the optimality of routing paths

SSthreshless Start: A Sender-Side TCP Intelligence for Long Fat Network

Measurement shows that 85% of TCP flows in the internet are short-lived flows that stay most of their operation in the TCP startup phase. However, many previous studies indicate that the traditional TCP Slow Start algorithm does not perform well, especially in long fat networks. Two obvious problems are known to impact the Slow Start performance, which are the blind initial setting of the Slow Start threshold and the aggressive increase of the probing rate during the startup phase regardless of the buffer sizes along the path. Current efforts focusing on tuning the Slow Start threshold and/or probing rate during the startup phase have not been considered very effective, which has prompted an investigation with a different approach. In this paper, we present a novel TCP startup method, called threshold-less slow start or SSthreshless Start, which does not need the Slow Start threshold to operate. Instead, SSthreshless Start uses the backlog status at bottleneck buffer to adaptively adjust probing rate which allows better seizing of the available bandwidth. Comparing to the traditional and other major modified startup methods, our simulation results show that SSthreshless Start achieves significant performance improvement during the startup phase. Moreover, SSthreshless Start scales well with a wide range of buffer size, propagation delay and network bandwidth. Besides, it shows excellent friendliness when operating simultaneously with the currently popular TCP NewReno connections.Comment: 25 pages, 10 figures, 7 table

Per-hop Internet Measurement Protocols

Accurately measuring per-hop packet dynamics on an Internet path is difficult. Currently available techniques have many well-known limitations that can make it difficult to accurately measure per-hop packet dynamics. Much of the difficulty of per-hop measurement is due to the lack of protocol support available to measure an Internet path on a per-hop basis. This thesis classifies common weaknesses and describes a protocol for per-hop measurement of Internet packet dynamics, known as the IP Measurement Protocol, or IPMP. With IPMP, a specially formed probe packet collects information from intermediate routers on the packet's dynamics as the packet is forwarded. This information includes an IP address from the interface that received the packet, a timestamp that records when the packet was received, and a counter that records the arrival order of echo packets belonging to the same flow. Probing a path with IPMP allows the topology of the path to be directly determined, and for direct measurement of per-hop behaviours such as queueing delay, jitter, reordering, and loss. This is useful in many operational situations, as well as for researchers in characterising Internet behaviour. IPMP's design goals of being tightly constrained and easy to implement are tested by building implementations in hardware and software. Implementations of IPMP presented in this thesis show that an IPMP measurement probe can be processed in hardware without delaying the packet, and processed in software with little overhead. This thesis presents IPMP-based measurement techniques for measuring per-hop packet delay, jitter, loss, reordering, and capacity that are more robust, require less probes to be sent, and are potentially more accurate and convenient than corresponding measurement techniques that do not use IPMP