Evaluation of Beamforming Algorithms for Massive MIMO

Massive MIMO relay system is an expansion of the Multiple-Input-Multiple-Output (MIMO) which enabled multiple users and antennas to communicate with each other for data sharing. A relay system with multiple antenna system has an advantage over simple MIMO system as it interconnects base station and users with each other for sharing of information and both BS and users are independent of many antennas. High data rate applications such as Machine-to-Machine communication and wireless sensor networks are experiencing transmit power loss, channel capacity and mismanagement of data. The demand for the Massive MIMO relay system is opening a door for ultra-high latency wireless network applications in case of saving transmit power and transmission of accurate information over the wireless networks. Due to the loss in transmit power and mismanagement of information over wireless networks, it is difficult to get better performance. Different approaches were made to optimize the overall transmit power of communication systems. One of the approaches was explained in this thesis work. The focus of the thesis is the use of beamforming algorithms named as Maximum Ratio Combining (MRC) and Zero-Forcing (ZF) to maximize the overall capacity of the MIMO system. These algorithms were evaluated on different scenarios to handle the performance and behavior with different network conditions. Various use cases were used for analyzing the beamforming algorithms. The performance of both algorithms was observed by considering the scenarios such as varying the transmit and receive antenna’s size and modulation schemes. Singular Value Decomposition (SVD) Method was used at the main MIMO channel to optimize the channel capacity. SVD divides the MIMO channel into different subchannels and optimizes the channel capacity of individual channels. The summary of results showed that MRC and ZF in the CP-OFDM environment when the number of RX antennas increased then they gave better BER performance as compared to the single antenna system. On the other hand, with higher modulation schemes efficiency was not good but with lower modulation scheme performance was satisfactory

Millimetre wave frequency band as a candidate spectrum for 5G network architecture : a survey

In order to meet the huge growth in global mobile data traffic in 2020 and beyond, the development of the 5th Generation (5G) system is required as the current 4G system is expected to fall short of the provision needed for such growth. 5G is anticipated to use a higher carrier frequency in the millimetre wave (mm-wave) band, within the 20 to 90 GHz, due to the availability of a vast amount of unexploited bandwidth. It is a revolutionary step to use these bands because of their different propagation characteristics, severe atmospheric attenuation, and hardware constraints. In this paper, we carry out a survey of 5G research contributions and proposed design architectures based on mm-wave communications. We present and discuss the use of mm-wave as indoor and outdoor mobile access, as a wireless backhaul solution, and as a key enabler for higher order sectorisation. Wireless standards such as IEE802.11ad, which are operating in mm-wave band have been presented. These standards have been designed for short range, ultra high data throughput systems in the 60 GHz band. Furthermore, this survey provides new insights regarding relevant and open issues in adopting mm-wave for 5G networks. This includes increased handoff rate and interference in Ultra-Dense Network (UDN), waveform consideration with higher spectral efficiency, and supporting spatial multiplexing in mm-wave line of sight. This survey also introduces a distributed base station architecture in mm-wave as an approach to address increased handoff rate in UDN, and to provide an alternative way for network densification in a time and cost effective manner