Channel estimation for MIMO-OFDM systems based on data nulling superimposed pilots

This paper proposes a new channel estimation algorithm based on data nulling superimposed pilots for the spatial multiplexing multiple-input-multiple-output (MIMO) orthogonal frequency division multiplexing (OFDM) systems. In the proposed method each OFDM data symbol of each transmit antenna is spread over all subcarriers by using a spreading matrix then nulls are introduced at certain subcarriers to cancel the mutual interference between data symbols and superimposed pilots. At receiver accurate channel estimation can be easily acquired based on the superimposed pilots. Then the superimposed pilots are removed from the received signal and simple iterative data detection scheme is used to compensate the distortion which occurred in the data symbols. The simulation results of the proposed algorithm show improvement in the estimation accuracy, bit error rate (BER) and computational complexity compared to that of the conventional superimposed pilot technique. The simulation results also show that the performance of the proposed technique approaches that of the frequency division multiplexed pilots technique while having higher data rate and some excess in the receiver complexity

Iterative channel estimation techniques for multiple input multiple output orthogonal frequency division multiplexing systems

Thesis (Master)--Izmir Institute of Technology, Electronics and Communication Engineering, Izmir, 2007Includes bibliographical references (leaves: 77-78)Text in English; Abstract: Turkish and Englishxii, 78 leavesOrthogonal frequency division multiplexing (OFDM) is well-known for its efficient high speed transmission and robustness to frequency-selective fading channels. On the other hand, multiple-input multiple-output (MIMO) antenna systems have the ability to increase capacity and reliability of a wireless communication system compared to single-input single-output (SISO) systems. Hence, the integration of the two technologies has the potential to meet the ever growing demands of future communication systems. In these systems, channel estimation is very crucial to demodulate the data coherently. For a good channel estimation, spectral efficiency and lower computational complexity are two important points to be considered. In this thesis, we explore different channel estimation techniques in order to improve estimation performance by increasing the bandwidth efficiency and reducing the computational complexity for both SISO-OFDM and MIMO-OFDM systems. We first investigate pilot and Expectation-Maximization (EM)-based channel estimation techniques and compare their performances. Next, we explore different pilot arrangements by reducing the number of pilot symbols in one OFDM frame to improve bandwidth efficiency. We obtain the bit error rate and the channel estimation performance for these pilot arrangements. Then, in order to decrase the computational complexity, we propose an iterative channel estimation technique, which establishes a link between the decision block and channel estimation block using virtual subcarriers. We compare this proposed technique with EM-based channel estimation in terms of performance and complexity. These channel estimation techniques are also applied to STBC-OFDM and V-BLAST structured MIMO-OFDM systems. Finally, we investigate a joint EM-based channel estimation and signal detection technique for V-BLAST OFDM system

Partial-Data Superimposed Training with Data Precoding for OFDM Systems

Superimposed training (ST) is a recently addressed technique used for channel estimation where known training sequences are arithmetically added to data symbols, avoiding the use of dedicated pilot subcarriers, and thus, increasing the available bandwidth compared with traditional pilot symbol assisted modulation schemes. However, the system handles data interference over channel estimation as a result of the ST process; also, data detection is degraded by pilot interference. Recent ST methods have analyzed the data interference and presented schemes that deal with it. We propose a novel superimposed model over a precoded data scheme, named partial-data superimposed training (PDST), where an interference control factor assigns the adequate information level to be added to the training sequence in orthogonal frequency division multiplexing systems. Also, a data detection method is introduced to improve the symbol error rate performance. Moreover, a capacity analysis of the system has been derived. Finally, simulation results confirm that performance of PDST is superior to previous proposals

Channel estimation, data detection and carrier frequency offset estimation in OFDM systems

Orthogonal Frequency Division Multiplexing (OFDM) plays an important role in the implementation of high data rate communication. In this thesis, the problems of data detection and channel and carrier frequency offset estimation in OFDM systems are studied. Multi-symbol non-coherent data detection is studied which performs data detection by processing multiple symbols without the knowledge of the channel impulse response (CIR). For coherent data detection, the CIR needs to be estimated. Our objective in this thesis is to work on blind channel estimators which can extract the CIR using just one block of received OFDM data. A blind channel estimator for (Single Input Multi Output) SIMO OFDM systems is derived. The conditions under which the estimator is identifiable is studied and solutions to resolve the phase ambiguity of the proposed estimator are given.A channel estimator for superimposed OFDM systems is proposed and its CRB is derived. The idea of simultaneous transmission of pilot and data symbols on each subcarrier, the so called superimposed technique, introduces the efficient use of bandwidth in OFDM context. Pilot symbols can be added to data symbols to enable CIR estimation without sacrificing the data rate. Despite the many advantages of OFDM, it suffers from sensitivity to carrier frequency offset (CFO). CFO destroys the orthogonality between the subcarriers. Thus, it is necessary for the receiver to estimate and compensate for the frequency offset. Several high accuracy estimators are derived. These include CFO estimators, as well as a joint iterative channel/CFO estimator/data detector for superimposed OFDM. The objective is to achieve CFO estimation with using just one OFDM block of received data and without the knowledge of CIR

Performance of STBC Based MIMO-OFDM Using Pilot-aided Channel Estimation

Many studies have been published to address the growing issues in wireless communication systems. Space-Time Block Coding (STBC) is an effective and practical MIMO-OFDM application that can address such issues. It is a powerful tool for increasing wireless performance by coding data symbols and transmitting diversity using several antennas. The most significant challenge is to recover the transmitted signal through a time-varying multipath fading channel and obtain a precise channel estimation to recover the transmitted information symbols. This work considers different pilot patterns for channel estimation and equalization in MIMO-OFDM systems. The pilot patterns fall under two general types: comb and block types, with a proper arrangement suitable to the multiple transmit antennas. The two main channel estimation methods, LS and MMSE, are compared by evaluating performance in terms of Bit Error Rate (BER) to analyze the performance of pilot-aided channel estimation for 2x2 and 4x4 MIMO arrangements utilizing LTE parameters and the effects of modifying different numbers of OFDM subcarriers under different channel models It has been discussed, a 4x4 system performs better than a 2x2 system in terms of BER with an acceptable amount of additional complexity

Adaptive averaging channel estimation for DVB-T2 systems

This thesis was submitted for the award of Doctor of Philosophy and was awarded by Brunel University LondonIn modern communication systems, the rate of transmitted data is growing rapidly. This leads to the need for more sophisticated methods and techniques of implementation in every block of the transmitter-receiver chain. The weakest link in radio communications is the transmission channel. The signal, which is passed through it, suffers from many degrading factors like noise, attenuation, diffraction, scattering etc. In the receiver side, the modulated signal has to be restored to its initial state in order to extract the useful information. Assuming that the channel acts like a filter with finite impulse, one has to know its coefficients in order to apply the inverse function, which will restore the signal back to its initial state. The techniques which deal with this problem are called channel estimation. Noise is one of the causes that degrade the quality of the received signal. If it could be discarded, then the process of channel estimation would be easier. Transmitting special symbols, called pilots with known amplitude, phase and position to the receiver and assuming that the noise has zero mean, an averaging process could reduce the noise impact to the pilot amplitudes and thus simplify the channel estimation process. In this thesis, a novel channel estimation method based on noise rejection is introduced. The estimator takes into account the time variations of the channel and adapts its buffer size in order to achieve the best performance. Many configurations of the estimator were tested and at the beginning of the research fixed size estimators were tested. The fixed estimator has a very good performance for channels which could be considered as stationary in the time domain, like Additive White Gaussian Noise (AWGN) channels or slowly time-varying channels. AWGN channel is a channel model where the only distorting factor is the noise, where noise is every unwanted signal interfering with the useful signal. The properties of the noise are that it is additive, which means that the noise is superimposed on the transmitted signal, it is white so the power density is constant for all frequencies, and it has a Gaussian distribution in the time domain with zero mean and variance σ2=N. A slowly time varying channel refers to channel with coherence time larger than the transmitted symbol duration. The performance of a fixed size averaging estimator in case of fast time-varying channels is subject to the buffering time. When the buffering time is smaller or equal to a portion of the coherence time the averaging process offers better performance than the conventional estimation, but when the buffering time exceeds this portion of the coherence time the performance of the averaging process degrades fast. So, an extension has been made to the averaging estimator that estimates the Doppler shift and thus the coherence time, where the channel could be assumed as stationary. The improved estimator called Adaptive Averaging Channel Estimator (AACE) is capable to adjust its buffer size and thus to average only successive Orthogonal Frequency Division Multiplexing (OFDM) symbols that have the same channel distortions. The OFDM is a transmission method where instead of transmitting the data stream using only on carrier, the stream is divided into parallel sub-streams where the subcarriers conveying the sub-streams are orthogonal to each other. The use of the OFDM increases the symbol duration making it more robust against Inter-Symbol Interference (ISI), which the interference among successive transmitted symbols, and also divides the channel bandwidth into small sub-bandwidths preventing frequency selectivity because of the multipath nature of the radio channel. Simulations using the Rayleigh channel model were performed and the results clearly demonstrate the benefits of the AACE in the channel estimation process. The performance of the combination of AACE with Least Square estimation (AACE-LS) is superior to the conventional Least Square estimation especially for low Doppler shifts and it is close to the Linear Minimum Mean Square Error (LMMSE) estimation performance. Consequently, if the receiver has low computational resources and/or the channel statistics are unknown, then the AACE-LS estimator is a valid choice for modern radio receivers. Moreover, the proposed adaptive averaging process could be used in any OFDM system based on pilot aided channel estimation. In order to verify the superiority of the AACE algorithm, quantitative results are provided in terms of BER vs SNR. It is demonstrated that AACE-LS is 7dB more sensitive than the LS estimator

Superimposed training for single carrier transmission in future mobile communications

The amount of wireless devices and wireless traffic has been increasing exponentially for the last ten years. It is forecasted that the exponential growth will continue without saturation till 2020 and probably further. So far, network vendors and operators have tackled the problem by introducing new evolutions of cellular macro networks, where each evolution has increased the physical layer spectral efficiency. Unfortunately, the spectral efficiency of the physical layer is achieving the Shannon-Hartley limit and does not provide much room for improvement anymore. However, considering the overhead due to synchronization and channel estimation reference symbols in the context of physical layer spectral efficiency, we believe that there is room for improvement. In this thesis, we will study the potentiality of superimposed training methods, especially data-dependent superimposed training, to boost the spectral efficiency of wideband single carrier communications even further. The main idea is that with superimposed training we can transmit more data symbols in the same time duration as compared to traditional time domain multiplexed training. In theory, more data symbols means more data bits which indicates higher throughput for the end user. In practice, nothing is free. With superimposed training we encounter self-interference between the training signal and the data signal. Therefore, we have to look for iterative receiver structures to separate these two or to estimate both, the desired data signal and the interfering component. In this thesis, we initiate the studies to find out if we truly can improve the existing systems by introducing the superimposed training scheme. We show that in certain scenarios we can achieve higher spectral efficiency, which maps directly to higher user throughput, but with the cost of higher signal processing burden in the receiver. In addition, we provide analytical tools for estimating the symbol or bit error ratio in the receiver with a given parametrization. The discussion leads us to the conclusion that there still remains several open topics for further study when looking for new ways of optimizing the overhead of reference symbols in wireless communications. Superimposed training with data-dependent components may prove to provide extra throughput gain. Furthermore, the superimposed component may be used for, e.g., improved synchronization, low bit-rate signaling or continuous tracking of neighbor cells. We believe that the current systems could be improved by using the superimposed training collectively with time domain multiplexed training