Modulation parameter estimation of LFM interference for direct sequence spread spectrum communication system in alpha-stable noise

The linear frequency modulation (LFM) interference is one of the typical broadband interferences in direct sequence spread spectrum (DSSS) communication system. In this article, a novel modulation parameter estimation method of LFM interference is proposed for the DSSS communication system in alpha-stable noise. To accurately estimate the modulation parameters, the alpha-stable noise should be eliminated first. Thus, we formulate a new generalized extended linear chirplet transform to suppress the alpha-stable noise, for a robust time-frequency, transformation of LFM interference is realized. Then, using the Radon transform, the maximum value after transformation and the chirp rate according to the angle related to the maximum value are estimated. In addition, a generalized Fourier transform is introduced to estimate the initial frequency of the LFM interference. For the performance analysis, the Cramér-Rao lower bounds of the estimated chirp rate and the initial frequency of the LFM interference in the presence of alpha-stable noise are derived. Moreover, the asymptotic properties of the modulation parameter estimator are analyzed. Simulation results demonstrate that the performance of the proposed parameter estimation method significantly outperforms existing methods, especially in a low SNR regime

Single carrier frequency domain equalization and energy efficiency optimization for MIMO cognitive radio.

This dissertation studies two separate topics in wireless communication systems. One topic focuses on the Single Carrier Frequency Domain Equalization (SC-FDE), which is a promising technique to mitigate the multipath effect in the broadband wireless communication. Another topic targets on the energy efficiency optimization in a multiple input multiple output (MIMO) cognitive radio network. For SC-FDE, the conventional linear receivers suffer from the noise amplification in deep fading channel. To overcome this, a fractional spaced frequency domain (FSFD) receiver based on frequency domain oversampling (FDO) is proposed for SC-FDE to improve the performance of the linear receiver under deep fading channels. By properly designing the guard interval, a larger sized Discrete Fourier Transform (DFT) is equipped to oversample the received signal in frequency domain. Thus, the effect of frequency-selective fading can still be eliminated by a one-tap frequency domain filter. Two types of FSFD receivers are proposed based on the least square (LS) and minimum mean square error (MMSE) criterion. Both the semi-analytical analysis and simulation results are given to evaluate the performance of the proposed receivers. Another challenge in SC-FDE is the in-phase/quadrature phase (IQ) imbalance caused by unideal radio frequency (RF) front-end at the transmitter or the receiver. Most existing works in single carrier transmission employ linear compensation methods, such as LS and MMSE, to combat the interference caused by IQ imbalance. Actually, for single carrier transmissions, it is possible for the receivers to adopt advanced nonlinear compensation methods to improve the system performance under IQ imbalance. For such purpose, an iterative decision feedback receiver is proposed to compensate the IQ imbalance caused by unideal RF front-end in SC-FDE. Numerical results show that the proposed iterative IQ imbalance compensation can significantly improve the performance of SC-FDE system under IQ imbalance compared with the conventional linear method. For the energy efficiency optimization in the MIMO cognitive radio network, multiple secondary users (SUs) coexisting with a primary user (PU) adjust their antenna radiation patterns and power allocations to achieve energy-efficient transmission. The optimization problems are formulated to maximize the energy efficiency of a cognitive radio network in both distributed and centralized point of views. Also, constraints on the transmission power and the interference to PU are introduced to protect the PU’s transmission. In order to solve the non-convex optimization problems, convex relaxations are used to transform them into equivalent problems with better tractability. Then three optimization algorithms are proposed to find the energy-efficient transmission strategies. Simulation results show that the proposed energy-efficiency optimization algorithms outperform the existing algorithms

Wideband data-independent beamforming for subarrays

The desire to operate large antenna arrays for e.g. RADAR applications over a wider frequency range is currently limited by the hardware, which due to weight, cost and size only permits complex multipliers behind each element. In contrast, wideband processing would have to rely on tap delay lines enabling digital filters for every element.As an intermediate step, in this thesis we consider a design where elements are grouped into subarrays, within which elements are still individually controlled by narrowband complex weights, but where each subarray output is given a tap delay line or finite impulse response digital filter for further wideband processing. Firstly, this thesis explores how a tap delay line attached to every subarray can be designed as a delay-and-sum beamformer. This filter is set to realised a fractional delay design based on a windowed sinc function. At the element level, we show that designing a narrowband beam w.r.t. a centre frequency of wideband operation is suboptimal,and suggest an optimisation technique that can yield sufficiently accurate gain over a frequency band of interest for an arbitrary look direction, which however comes at the cost of reduced aperture efficiency, as well as significantly increased sidelobes. We also suggest an adaptive method to enhance the frequency characteristic of a partial wideband array design, by utilising subarrays pointing in different directions in different frequency bands - resolved by means of a filter bank - to adaptively suppress undesired components in the beam patterns of the subarrays. Finally, the thesis proposes a novel array design approach obtained by rotational tiling of subarrays such that the overall array aperture is densely constructed from the same geometric subarray by rotation and translation only. Since the grating lobes of differently oriented subarrays do not necessarily align, an effective grating lobe attenuation w.r.t. the main beam is achieved. Based on a review of findings from geometry,a number of designs are highlight and transformed into numerical examples, and the theoretically expected grating lobe suppression is compared to uniformly spaced arrays.Supported by a number of models and simulations, the thesis thus suggests various numerical and hardware design techniques, mainly the addition of tap-delay-line per subarray and some added processing overhead, that can help to construct a large partial wideband array close in wideband performance to currently existing hardware.The desire to operate large antenna arrays for e.g. RADAR applications over a wider frequency range is currently limited by the hardware, which due to weight, cost and size only permits complex multipliers behind each element. In contrast, wideband processing would have to rely on tap delay lines enabling digital filters for every element.As an intermediate step, in this thesis we consider a design where elements are grouped into subarrays, within which elements are still individually controlled by narrowband complex weights, but where each subarray output is given a tap delay line or finite impulse response digital filter for further wideband processing. Firstly, this thesis explores how a tap delay line attached to every subarray can be designed as a delay-and-sum beamformer. This filter is set to realised a fractional delay design based on a windowed sinc function. At the element level, we show that designing a narrowband beam w.r.t. a centre frequency of wideband operation is suboptimal,and suggest an optimisation technique that can yield sufficiently accurate gain over a frequency band of interest for an arbitrary look direction, which however comes at the cost of reduced aperture efficiency, as well as significantly increased sidelobes. We also suggest an adaptive method to enhance the frequency characteristic of a partial wideband array design, by utilising subarrays pointing in different directions in different frequency bands - resolved by means of a filter bank - to adaptively suppress undesired components in the beam patterns of the subarrays. Finally, the thesis proposes a novel array design approach obtained by rotational tiling of subarrays such that the overall array aperture is densely constructed from the same geometric subarray by rotation and translation only. Since the grating lobes of differently oriented subarrays do not necessarily align, an effective grating lobe attenuation w.r.t. the main beam is achieved. Based on a review of findings from geometry,a number of designs are highlight and transformed into numerical examples, and the theoretically expected grating lobe suppression is compared to uniformly spaced arrays.Supported by a number of models and simulations, the thesis thus suggests various numerical and hardware design techniques, mainly the addition of tap-delay-line per subarray and some added processing overhead, that can help to construct a large partial wideband array close in wideband performance to currently existing hardware

Interference Suppression for Spread Spectrum Signals Using Adaptive Beamforming and Adaptive Temporal Filter

Interference and jamming signals are a serious concern in an operational military communication environment. This thesis examines the utility and performance of combining adaptive temporal filtering with adaptive spatial filtering (i.e. adaptive beamforming) to improve the signal-to-jammer ratio (SJR) in the presence of narrowband and wideband interference. Adaptive temporal filters are used for narrowband interference suppression while adaptive beamforming is used to suppress wideband interference signals. A procedure is presented for the design and implementation of a linear constraints minimum variance generalized sidelobe canceler (LCMV-GSC) beamformer. The adaptive beamformer processes the desired signal with unity gain while simultaneously and adaptively minimizing the output due to any undesired signal. Using the LCMV-GSC beamformer with a least mean squares (LMS) adaptive algorithm, it was shown that the tapped delay line (TDL) adaptive antenna array is more effective for the suppression of wideband jammer suppression than the linear array sensors (LAS) adaptive antenna array. Also a new technique for adaptive beamforming is presented which improves wideband interference suppression in a frequency-hopped environment. The output SJR improvement for the new technique compared to the conventional technique is as much as 15dB. Sometimes, multipath signals and jammers generated by a smart enemy are correlated with the desired signal which destroys the traditional beamformer\u27s performance. After performing a spatial smoothing technique, adaptive beamforming can also be effective in suppressing the jamming signals that are highly correlated with the desired signal