258 research outputs found
Adaptive beamforming for large arrays in satellite communications systems with dispersed coverage
Conventional multibeam satellite communications systems ensure coverage of wide areas through multiple fixed beams where all users inside a beam share the same bandwidth. We consider a new and more flexible system where each user is assigned his own beam, and the users can be very geographically dispersed. This is achieved through the use of a large direct radiating array (DRA) coupled with adaptive beamforming so as to reject interferences and to provide a maximal gain to the user of interest. New fast-converging adaptive beamforming algorithms are presented, which allow to obtain good signal to interference and noise ratio (SINR) with a number of snapshots much lower than the number of antennas in the array. These beamformers are evaluated on reference scenarios
Adaptive multibeam antennas for spacelab. Phase A: Feasibility study
The feasibility was studied of using adaptive multibeam multi-frequency antennas on the spacelab, and to define the experiment configuration and program plan needed for a demonstration to prove the concept. Three applications missions were selected, and requirements were defined for an L band communications experiment, an L band radiometer experiment, and a Ku band communications experiment. Reflector, passive lens, and phased array antenna systems were considered, and the Adaptive Multibeam Phased Array (AMPA) was chosen. Array configuration and beamforming network tradeoffs resulted in a single 3m x 3m L band array with 576 elements for high radiometer beam efficiency. Separate 0.4m x 0.4 m arrays are used to transmit and receive at Ku band with either 576 elements or thinned apertures. Each array has two independently steerable 5 deg beams, which are adaptively controlled
Space-Air-Ground Integrated 6G Wireless Communication Networks: A Review of Antenna Technologies and Application Scenarios
A review of technological solutions and advances in the framework of a Vertical Heterogeneous Network (VHetNet) integrating satellite, airborne and terrestrial networks is presented. The disruptive features and challenges offered by a fruitful cooperation among these segments within a ubiquitous and seamless wireless connectivity are described. The available technologies and the key research directions for achieving global wireless coverage by considering all these layers are thoroughly discussed. Emphasis is placed on the available antenna systems in satellite, airborne and ground layers by highlighting strengths and weakness and by providing some interesting trends in research. A summary of the most suitable applicative scenarios for future 6G wireless communications are finally illustrated
Adaptive multibeam phased array design for a Spacelab experiment
The parametric tradeoff analyses and design for an Adaptive Multibeam Phased Array (AMPA) for a Spacelab experiment are described. This AMPA Experiment System was designed with particular emphasis to maximize channel capacity and minimize implementation and cost impacts for future austere maritime and aeronautical users, operating with a low gain hemispherical coverage antenna element, low effective radiated power, and low antenna gain-to-system noise temperature ratio
SpaceRIS: LEO Satellite Coverage Maximization in 6G Sub-THz Networks by MAPPO DRL and Whale Optimization
Satellite systems face a significant challenge in effectively utilizing
limited communication resources to meet the demands of ground network traffic,
characterized by asymmetrical spatial distribution and time-varying
characteristics. Moreover, the coverage range and signal transmission distance
of low Earth orbit (LEO) satellites are restricted by notable propagation
attenuation, molecular absorption, and space losses in sub-terahertz (THz)
frequencies. This paper introduces a novel approach to maximize LEO satellite
coverage by leveraging reconfigurable intelligent surfaces (RISs) within 6G
sub-THz networks. The optimization objectives encompass enhancing the
end-to-end data rate, optimizing satellite-remote user equipment (RUE)
associations, data packet routing within satellite constellations, RIS phase
shift, and ground base station (GBS) transmit power (i.e., active beamforming).
The formulated joint optimization problem poses significant challenges owing to
its time-varying environment, non-convex characteristics, and NP-hard
complexity. To address these challenges, we propose a block coordinate descent
(BCD) algorithm that integrates balanced K-means clustering, multi-agent
proximal policy optimization (MAPPO) deep reinforcement learning (DRL), and
whale optimization (WOA) techniques. The performance of the proposed approach
is demonstrated through comprehensive simulation results, exhibiting its
superiority over existing baseline methods in the literature
Beamforming for OFDM based hybrid terrestrial satellite mobile system
EThOS - Electronic Theses Online ServiceGBUnited Kingdo
1-D broadside-radiating leaky-wave antenna based on a numerically synthesized impedance surface
A newly-developed deterministic numerical technique for the automated design of metasurface antennas is applied here for the first time to the design of a 1-D printed Leaky-Wave Antenna (LWA) for broadside radiation. The surface impedance synthesis process does not require any a priori knowledge on the impedance pattern, and starts from a mask constraint on the desired far-field and practical bounds on the unit cell impedance values. The designed reactance surface for broadside radiation exhibits a non conventional patterning; this highlights the merit of using an automated design process for a design well known to be challenging for analytical methods. The antenna is physically implemented with an array of metal strips with varying gap widths and simulation results show very good agreement with the predicted performance
Beam scanning by liquid-crystal biasing in a modified SIW structure
A fixed-frequency beam-scanning 1D antenna based on Liquid Crystals (LCs) is designed for application in 2D scanning with lateral alignment. The 2D array environment imposes full decoupling of adjacent 1D antennas, which often conflicts with the LC requirement of DC biasing: the proposed design accommodates both. The LC medium is placed inside a Substrate Integrated Waveguide (SIW) modified to work as a Groove Gap Waveguide, with radiating slots etched on the upper broad wall, that radiates as a Leaky-Wave Antenna (LWA). This allows effective application of the DC bias voltage needed for tuning the LCs. At the same time, the RF field remains laterally confined, enabling the possibility to lay several antennas in parallel and achieve 2D beam scanning. The design is validated by simulation employing the actual properties of a commercial LC medium
Physical Layer Security for Visible Light Communication Systems:A Survey
Due to the dramatic increase in high data rate services and in order to meet
the demands of the fifth-generation (5G) networks, researchers from both
academia and industry are exploring advanced transmission techniques, new
network architectures and new frequency spectrum such as the visible light
spectra. Visible light communication (VLC) particularly is an emerging
technology that has been introduced as a promising solution for 5G and beyond.
Although VLC systems are more immune against interference and less susceptible
to security vulnerabilities since light does not penetrate through walls,
security issues arise naturally in VLC channels due to their open and
broadcasting nature, compared to fiber-optic systems. In addition, since VLC is
considered to be an enabling technology for 5G, and security is one of the 5G
fundamental requirements, security issues should be carefully addressed and
resolved in the VLC context. On the other hand, due to the success of physical
layer security (PLS) in improving the security of radio-frequency (RF) wireless
networks, extending such PLS techniques to VLC systems has been of great
interest. Only two survey papers on security in VLC have been published in the
literature. However, a comparative and unified survey on PLS for VLC from
information theoretic and signal processing point of views is still missing.
This paper covers almost all aspects of PLS for VLC, including different
channel models, input distributions, network configurations,
precoding/signaling strategies, and secrecy capacity and information rates.
Furthermore, we propose a number of timely and open research directions for
PLS-VLC systems, including the application of measurement-based indoor and
outdoor channel models, incorporating user mobility and device orientation into
the channel model, and combining VLC and RF systems to realize the potential of
such technologies
- âŠ