An automatic tool flow for the combined implementation of multi-mode circuits

A multi-mode circuit implements the functionality of a limited number of circuits, called modes, of which at any given time only one needs to be realised. Using run-time reconfiguration of an FPGA, all the modes can be implemented on the same reconfigurable region, requiring only an area that can contain the biggest mode. Typically, conventional run-time reconfiguration techniques generate a configuration for every mode separately. To switch between modes the complete reconfigurable region is rewritten, which often leads to very long reconfiguration times. In this paper we present a novel, fully automated tool flow that exploits similarities between the modes and uses Dynamic Circuit Specialization to drastically reduce reconfiguration time. Experimental results show that the number of bits that is rewritten in the configuration memory reduces with a factor from 4.6X to 5.1X without significant performance penalties

Design and implementation of the Quarc network on-chip

Networks-on-Chip (NoC) have emerged as alternative to buses to provide a packet-switched communication medium for modular development of large Systems-on-Chip. However, to successfully replace its predecessor, the NoC has to be able to efficiently exchange all types of traffic including collective communications. The latter is especially important for e.g. cache updates in multicore systems. The Quarc NoC architecture has been introduced as a Networks-on-Chip which is highly efficient in exchanging all types of traffic including broadcast and multicast. In this paper we present the hardware implementation of the switch architecture and the network adapter (transceiver) of the Quarc NoC. Moreover, the paper presents an analysis and comparison of the cost and performance between the Quarc and the Spidergon NoCs implemented in Verilog targeting the Xilinx Virtex FPGA family. We demonstrate a dramatic improvement in performance over the Spidergon especially for broadcast traffic, at no additional hardware cost

FPSA: A Full System Stack Solution for Reconfigurable ReRAM-based NN Accelerator Architecture

Neural Network (NN) accelerators with emerging ReRAM (resistive random access memory) technologies have been investigated as one of the promising solutions to address the \textit{memory wall} challenge, due to the unique capability of \textit{processing-in-memory} within ReRAM-crossbar-based processing elements (PEs). However, the high efficiency and high density advantages of ReRAM have not been fully utilized due to the huge communication demands among PEs and the overhead of peripheral circuits. In this paper, we propose a full system stack solution, composed of a reconfigurable architecture design, Field Programmable Synapse Array (FPSA) and its software system including neural synthesizer, temporal-to-spatial mapper, and placement & routing. We highly leverage the software system to make the hardware design compact and efficient. To satisfy the high-performance communication demand, we optimize it with a reconfigurable routing architecture and the placement & routing tool. To improve the computational density, we greatly simplify the PE circuit with the spiking schema and then adopt neural synthesizer to enable the high density computation-resources to support different kinds of NN operations. In addition, we provide spiking memory blocks (SMBs) and configurable logic blocks (CLBs) in hardware and leverage the temporal-to-spatial mapper to utilize them to balance the storage and computation requirements of NN. Owing to the end-to-end software system, we can efficiently deploy existing deep neural networks to FPSA. Evaluations show that, compared to one of state-of-the-art ReRAM-based NN accelerators, PRIME, the computational density of FPSA improves by 31x; for representative NNs, its inference performance can achieve up to 1000x speedup.Comment: Accepted by ASPLOS 201