SatCat5: A Low-Power, Mixed-Media Ethernet Network for Smallsats

In any satellite, internal bus and payload systems must exchange a variety of command, control, telemetry, and mission-data. In too many cases, the resulting network is an ad-hoc proliferation of complex, dissimilar protocols with incomplete system-to-system connectivity. While standards like CAN, MIL-STD-1553, and SpaceWire mitigate this problem, none can simultaneously solve the need for high throughput and low power consumption. We present a new solution that uses Ethernet framing and addressing to unify a mixed-media network. Low-speed nodes (0.1-10 Mbps) use simple interfaces such as SPI and UART to communicate with extremely low power and minimal complexity. High-speed nodes use so-called “media-independent” interfaces such as RMII, RGMII, and SGMII to communicate at rates up to 1000 Mbps and enable connection to traditional COTS network equipment. All are interconnected into a single smallsat-area-network using a Layer-2 network switch, with mixed-media support for all these interfaces on a single network. The result is fast, easy, and flexible communication between any two subsystems. SatCat5 is presented as a free and open-source reference implementation of this mixed-media network switch, with power consumption of 0.2-0.7W depending on network activity. Further discussion includes example protocols that can be used on such networks, leveraging IPv4 when suitable but also enabling full-featured communication without the need for a complex protocol stack

Reducing jitter utilising adaptive pre-emphasis FIR filter for high speed serial links

Jitter requirements have become more stringent with higher speed serial communication links. Reducing jitter, with the main focus on reducing data dependant jitter (DDJ), is presented by employing adaptive finite impulse response (FIR) filter pre-emphasis. The adaptive FIR pre-emphasis is implemented in the IBM 7WL 0.18 µm SiGe BiCMOS process. SiGe heterojunction bipolar transistors (HBTs) provide high bandwidth, low noise devices which could reduce the total system jitter. The trade-offs between utilising metal oxide semiconductor (MOS) current mode logic (CML) and SiGe bipolar CML are also discussed in comparison with a very high fT (IBM 8HP process with fT = 200 GHz) process. A reduction in total system jitter can be achieved by keeping the sub-components of the system jitter constant while optimising the DDJ. High speed CML circuits have been employed to allow data rates in excess of 5 Gb/s to be transmitted whilst still maintaining an internal voltage swing of at least 300 mV. This allows the final FIR filter adaptation scheme to minimise the DDJ within 12.5 % of a unit interval, at a data rate of 5 Gb/s implementing 6 FIR pre-emphasis filter taps, for a worst case copper backplane channel (30" FR-4 channel). The implemented integrated circuit (IC) designed as part of the verification process takes up less than 1 mm2 of silicon real estate. In this dissertation, SPICE simulation results are presented, as well as the novel IC implementation of the proposed FIR filter adaptation technique as part of the hypothesis verification procedure. The implemented transmitter and receiver were tested for functionality, and showed the successful functional behaviour of all the implemented CML gates associated with the first filter tap. However, due to the slow charge and discharge rate of the pulse generation circuit in both the transmitter and receiver, only the main operational state of the transmitter could be experimentally validated. As a result of the adaptation scheme implemented, the contribution in this research lies in that a designer utilising such an IC can optimise the DDJ, reducing the total system jitter, and hence increasing the data fidelity with minimal effort.Dissertation (MEng)--University of Pretoria, 2011.Electrical, Electronic and Computer Engineeringunrestricte